Bretford A2642NS دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

A2642NS CA2642NS
A2642DNS CA2642DNS
ADJUSTABLE CART WITH OR WITHOUT CABINET
SINGLE OR DOUBLE PULL OUT SHELVES
Assembly Instructions
Parts List
Qty Part # Description
1 022-2813 Top Section for Single Shelf Models
022-3087 Top Section for Double Shelf Models
1 022-1099 Bottom Section for Open Shelf Models
022-1252 Bottom Section for Cabinet Models
1 010-5773 Notebook Pull Out Shelf (2 for Double Shelf Models)
1 030-1468 Left Outer Slide (2 for Double Shelf Models)
1 030-1470 Right Outer Sl

ملخص المحتوى في الصفحة رقم 2

STEP 1 STEP 2 Turn bottom section over and push each caster into each Lay both top and bottom sections on their sides. Slide of the corner sockets. If casters do not insert easily a the top section over the bottom section as shown. rubber mallet may be used to tap the casters in place. MAKE SURE CASTERS ARE SECURELY IN PLACE. STEP 3 Attach legs together using screws (AA) and nuts (BB) as shown. NOTE: Carts have height adjustments at 4” increments. The single shelf models range from 26

ملخص المحتوى في الصفحة رقم 3

This tab determines where the shelf will slide out from. Each cart bracket has additional cutouts to allow the shelf to pull out from either side of the cart. STEP 4 Install the outer slide onto the cart bracket by sliding TAB 1 into CUTOUT A and TAB 2 into CUTOUT B. NOTE: Some bend in the bracket is ok as the slides and shelf will take care of that once they are installed. IMPORTANT NOTE: Double shelf “DNS” models should have pull out shelves installed to pull out opposite from one

ملخص المحتوى في الصفحة رقم 4

STEP 5 Install each inner slide into the outer slides. NOTE: Push inner slide in all the way until it snaps in. STEP 6 Extend the slides to the positioning shown. 4

ملخص المحتوى في الصفحة رقم 5

CUTOUT 2 TAB 1 TAB 2 CUTOUT 1 STEP 7 Install the pull out shelf by sliding CUTOUT 1 into TAB 1 and CUTOUT 2 into TAB 2. Part # 031-7755 Rev. 01.20.11 CZ 5