Best IN-LINE ILB9 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

MODELS ILB9 ILB11
!!!
!!
Page 1
IN-LINE BLOWERS
READ AND SAVE THESE INSTRUCTIONS
! !
FOR DOMESTIC COOKING ONLY
WARNING WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO 4. Use an extinguisher ONLY if:
PERSONS, OBSERVE THE FOLLOWING:
A. You know you have a Class ABC extinguisher and you already
know how to operate it.
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
B. The fire is small and conta

ملخص المحتوى في الصفحة رقم 2

MODELS ILB9 ILB11 !!! !! Page 2 TYPICAL INSTALLATION TYPICAL INSTALLATION MOUNTING USING HANGER KIT (included) MOUNTING (New Frame Construction) 10” ROUND DUCT 8” X 12” TO (OUTLET) 10” ROUND HANGER KIT BOLT TRANSITIONS & WASHER EXTENSION SPRING 10” ROUND DUCT HANGER 10” ROUND (INTAKE) KIT CHAIN DUCT (INTAKE) HANGER KIT EYE-BOLT GRILLE NUT (Install into square 8” X 12” TO holes in housing) 10” ROUND HANGER MOUNTING TRANSITIONS Ventilator KIT NUT & BRACKETS factory-shipped WASHER in straight-thr

ملخص المحتوى في الصفحة رقم 3

MODELS ILB9 ILB11 !!! !! Page 3 WIRING WIRING PLATE POSITION BLACK TO BLACK EDGE OF HOUSING GROUND TO VERTICAL WIRING PLATE POWER CABLE CONNECTION WIRING PLATE HORIZONTAL POWER CABLE CONNECTION WHITE TO Wiring plate mounts to side or top of housing. WHITE 120 VAC LINE IN (from range hood) DUCTING OPTIONS Ventilator can be wired from outside of housing. BLOWER DISCHARGE POSITIONS Use UL approved connectors to wire per local codes. DUCT Housing DUCT MOVABLE CONNECTOR CONNECTOR rotated & PANEL (o

ملخص المحتوى في الصفحة رقم 4

MODELS ILB9 ILB11 !!! !! Page 4 USE AND CARE To clean blower assembly: Remove access panel, unplug blower from housing, remove blower mounting nuts, and carefully remove blower from housing. Use appropriate vacuum attachment or a Follow wiring instructions packed with range hood, and adhere to soft cloth and mild soap or detergent to clean blower discharge all local and state codes, and the National Electrical Code. area and wheel. DO NOT ALLOW WATER TO ENTER MOTOR. Make sure blower assembly i