Agio International Multi-Purpose Work Bench 92558 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

MULTI-PURPOSE WORK BENCH ASSEMBLY INSTRUCTIONS
#92558
DESCRIPTION ORDER PART #QTY DESCRIPTION ORDER PART #QTY DESCRIPTION ORDER PART #QTY
LARGE WHEEL
2
N WB0002
A M10 X 55MM BOLT 3 DRAIN PLUG 1
AA WB0015
WHEEL COVER 4
O WB0003
B M6 X 50MM BOLT 6 DOWEL RODS 3
BB WB0016
REAR FAUCET
AXLE SLEEVE WB0004 3
M6 X 16MM BOLT 16 1
C P WB0017
CC
PANEL
FOLDING
RIGHT SUPPORT 1
M6 NUT 12 Q WB0005 1
D WB0018
DD
COUNTER
FRAME
LEFT SUPPORT AXLE FOR
6MM WASHER 6 WB0006 1
R
E WB0019 1
EE
FOLDING COUNTER
FRAME
CUSH

ملخص المحتوى في الصفحة رقم 2

STEP 4 FRAME ASSEMBLY Figure 3 Connect right side support frame (Q) and left side support frame (R) using the rear support bar (V). Be sure that the hole in the center of the rear support bar is facing up. Add a 10mm washer (F) to a M10 x 55 mm bolt (A) and insert through the left side frame support(r) into the fixed nuts in the rear support bar (V) as shown in figure 3. Repeat for opposite side. (Q). Attach front support bar to middle support frame as shown in figure 3 using a M6 x 16m

ملخص المحتوى في الصفحة رقم 3

STEP 6 SINK ASSEMBLY (continued) Position the sink top assembly (Z) over the left side, right side and middle support frames, making sure the holes for the bolts are properly aligned. Once in proper position, use M6 x 16mm bolts (C) Figure 6 to attach sink top/basin assembly to the left support frame. Insert bolts through holes in sink top into the fixed nuts in the left side support frame. Repeat procedure for right side support frame. Insert M6 x 50mm bolts (B) through the holes in t

ملخص المحتوى في الصفحة رقم 4

STEP 8 FINAL TOUCHES Drawer assembly. Tilt the front end of drawer up and slide into Figure 8 track. Make sure track and drawer runners are properly aligned. Slide the two bottom trays (GG) into frame as shown in figure 8. At this time, make sure all nuts and bolts are tightened completely using wrench and hex key wrench. Do not over tighten. Add 12mm PVC cover (K) to each end of wheel axle and 10mm PVC cover (J) to each end of the folding shelf axle as shown in figure 8. LIMITED