ملخص المحتوى في الصفحة رقم 1
Contents
General information, 1-2-3-4-5
Technical Information, 2-3
For your safety, 4
Introduction, 5
Installation requirements, 6-7
Attention / Grounding instructions, 6
Electrical, location and draining, 7
Installing the washer-dryer, 8-9-10-11
Unpacking the washer-dryer, 8
Removing the transit screws, 8
210oXC
Connecting the water inlets, 9
Connecting the drain hose, 9
Installing the exhaust ducting, 10
Leveling the washer-dryer, 10
Completing the installation, 11
About your appliance, 12-13-
ملخص المحتوى في الصفحة رقم 2
General Information As an Energy Star Partner, This appliance was tested by UL and Splendide Division of Westland conforms with both Canadian and Sales has determined that Energy U.S. UL safety requirements and Star labeled models meet the displays their mark. Energy Star guidelines for energy efficiency. 2 General Information
ملخص المحتوى في الصفحة رقم 3
Technical information Model WD2100XC(P) Splendide 2100XC, Splendide 2100XCP Weight 148 lbs. Width: 23.4” (59.5 cm) Dimensions Height: 33.25”-33.75” (84.5-85.7 cm) Depth: 22” (55.9 cm) Minimum Installation Sides: 0” Front / Back: 1” Clearances Washing: 2 to 15 lbs. (1 to 7 kg) Capacity Drying: 2 to 11 lbs. (1 to 5 kg) Voltage: 120 Volts, 10.5 Amp, 60 Hz Electrical Connection Max. Absorbed Power: 1300 Watts Max. Pressure: .69 MPa (6.9 bar), 100 PSI Water Connection Min. Pressure: 0.05
ملخص المحتوى في الصفحة رقم 4
For Your Safety Save These Instructions Your washer-dryer has been built in compliance with the strictest international safety regulations. However, for your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. Read all instructions before using any appliance. • Do not wash or dry articles that have been previously cleaned in, washed in, or spotted in gasoline, dry c
ملخص المحتوى في الصفحة رقم 5
Congratulations Introduction For your records Congratulations on your purchase of a Write model and serial numbers here. You can find Splendide. Your Spendide washer-dryer takes them on the front of the machine and inside of the the drudgery out of doing laundry - simply toss door opening. dirty laundry in and get clean, dry laundry out! Model: (i.e. WD2100XP) Whether it’s installed in a luxury RV, yacht, or apartment closet, your new Splendide is designed to fit where others won’t and deliver
ملخص المحتوى في الصفحة رقم 6
Installation Requirements GROUNDING INSTRUCTIONS ATTENTION! This appliance must be grounded. In the event of malfunction, or breakdown, For your own protection and to prevent grounding will reduce the risk of electric accidents, injury, and fire, please read the shock by providing a path of least resistance following carefully before installing the for electriccurrent. This appliance is washer-dryer. equipped with acord having an equipment Installation and grounding must be done in gr
ملخص المحتوى في الصفحة رقم 7
If you have... You’ll need... Electrical no access to Hot/Cold Splendide Faucet Adapter Machine Voltage/Amperage - 120V, 60 Hz, water hookups Kit, or equivalent. 1300 W, 10.5 Amp. to install a dryer vent Splendide Vent Kit, or and ducting in your equivalent. Connection - 3-prong plug with 6’ cord is RV or boat provided with the machine. concerns about the Splendide SecureFit bracket appliance shifting in kit, or equivalent. your RV or boat Circuit/Protector - 3-wire single pha
ملخص المحتوى في الصفحة رقم 8
Installing the washer-dryer Unpacking the washer-dryer IMPORTANT: Retain the transit screws, spacers and rubber tubes. These items Carefully remove the packing materials with care should be reinstalled to prevent damage if not to damage the drain hose and power cord or when you transport the machine in the that are shipped installed on the machine. future. Check that the machine is intact. Report any damage immediately. Position the washer-dryer near the desired installation positi
ملخص المحتوى في الصفحة رقم 9
Connecting the drain hose IMPORTANT: Make sure that the drain hose is not kinked and that water flow is It is possible for the water to be discharged into a not restricted. sink, standpipe or drainpipe, but an air break must be available at a minimum 20” height to prevent the method. 2) directly to a “Y” branch tail piece machine from siphoning (Fig. 6). (available at most hardware stores). 3) Through the floor to a separate trap. The trap must be vented to Floor Standpipe Wall Standpipe preven
ملخص المحتوى في الصفحة رقم 10
Installing exhaust ducting WARNING! To reduce the risk of fire, this appliance must be exhausted to the outdoors. IMPORTANT: Rigid or flexible metallic duct required. This appliance should Ducting must be as short and straight as NOT be exhausted possible. into a chimney, wall, ceiling, or any Do not exhaust dryer into a chimney, Fig 8 concealed space of a furnace, cold air duct, attic crawl space, or building. Only rigid another duct used for venting. or flexible metallic ducting should b
ملخص المحتوى في الصفحة رقم 11
Completing the installation Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. Check that the shipping brackets have been removed. Check that the water faucets are ON. Check for leaks around faucets and inlet hoses. Plug washer into a grounded 3-prong outlet. Slide the washer-dryer to it’s final location and confirm that it’s level. When installing this appliance in an RV or marine vessel
ملخص المحتوى في الصفحة رقم 12
About your washer-dryer after every wash (except Express Wash) and features an Extra Rinse button that adds yet another rinse to remove even CAUTION more dirt/detergent from fabrics (recommended for those RISK OF ELECTRIC SHOCK with detergent contact allergies). DO NOT OPEN Foam Removal System CAUTION: To reduce the risk of electric shock, Your machine automatically measures the amount of foam DO NOT remove cover (or back). No user in circulation and adds water to the drum to remove excess ser
ملخص المحتوى في الصفحة رقم 13
Description of the control panel OPTION DOOR LOCK Buttons LED ON/OFF START STATUS LED’s CYCLE DRY TIME Selector Selector WASH TEMP Selector ON/OFF (Door Open) Button START (Cancel) Button Turns power to the washer ON or OFF, unlocks the Press once to START the program, or press and hold door during the wash and dry cycles. Also restarts a to CANCEL a program in progress. SILK or WOOL cycle that’s gone into Anticrease/ Soak. OPTION Buttons Use these buttons to modify the wash cycle (see DOOR LO
ملخص المحتوى في الصفحة رقم 14
Description of the Option Buttons You can customize the wash by adding an OPTION or combination of options to your cycle selection. The button corresponding to the OPTION selected will remain LIT. NOTE: If you push an OPTION button and it flashes, that means the OPTION you selected is not available for that cycle. Low Pre Extra Low Heat Wash Rinse Spin EXTRA RINSE - Adds an extra rinse LOW HEAT - Reduces the dryer heat temperature of the selected dry cycle to the wash cycle (Not available in Del
ملخص المحتوى في الصفحة رقم 15
Optional Laundry Aid Type / Amounts All-Natural, HE detergent formulated for your washer-dryer Your Splendide requires smaller amounts of laundry Softens fabrics aids to get fabrics clean. Adding too much naturally detergent won’t necessarily make for a more While not required, Splen- efficient wash, and may in fact cause build up on dide recommends the use of a High Efficiency (HE) your clothes and inside your appliance and even detergent. HE detergents Splendide Premium pollute the env
ملخص المحتوى في الصفحة رقم 16
Washing and drying Cycle Description Chart Cycle Selector Detergent * Degree of Cycle Pre Fabric Options Cycle Cycle Fabric type No. Wash Bleach soil Name Wash Softener Available Length Description Cotton Heavy Duty Cycles Low Heat Exception- Extra Rinse 1 Super •• • 96 min. ally Soiled Low Spin Wash cycle, rinse Heavy cotton cycles, intermediate fabrics: Heavily 2 Heavy •• • • 77 min. and final spin cycles Low Heat Soiled i.e. sheets, socks, Pre Wash 77 min. Soiled 3 Regular •• • • 1,200rpm h
ملخص المحتوى في الصفحة رقم 17
Before starting a cycle Setting a wash-to-dry cycle Always make sure, 1) Select the wash cycle • the drum is loaded correctly (see below) select a washing cycle using the Cycle Selector; • the door is closed select the wash water temperature using the • the ON-OFF button has been pressed and machine WASH TEMP knob; power is ON press available OPTION buttons (optional); • laundry aids have been added to the Dispenser Drawer (see below) 2) Select the dry time select the length of drying
ملخص المحتوى في الصفحة رقم 18
For best results, Combine large and small items in one full DON’T OVERLOAD THE DRUM. Keep up with load. When washing single items such as a sweater, towel or jeans, add 1 or 2 similar laundry by doing smaller loads every day or items to help balance the load. Single, heavy two. items such asabathrobe can be washed DON’T EXCEED RECOMMENDED DETERGENT separately. OR FABRIC SOFTENER AMOUNTS. When going from ‘was-to-dry’ automatically, Do not wash rugs that could come apart Always us
ملخص المحتوى في الصفحة رقم 19
Sample wash-to-dry loads Combo laundry FAQ’s Is using a combination washer-dryer much To get you started, here are a few sample load sizes that different than what I’m use to? can go directly from wash through dry. NOTE: Data Yes, in some ways. You are washing and purely indicative. Actual drying times will vary depend- drying in the same drum and load sizes are ing on type/weight of material. smaller. Wash cycles are similar, but because combination washer-dryers are compact and operate using
ملخص المحتوى في الصفحة رقم 20
Care and maintenance Turning off the water or Checking the water inlet electricity supply hoses Turn off the water supply after every wash. This Check the water inlet hoses at least once a year. will limit the wear of your appliance’s water Clean the filters and the water valves. If you see system and also prevent leaks. Unplug your any cracks, bulges or wear, replace hoses appliance when cleaning it, while on vacation immediately; During the wash cycles, water and during all maintenance operati
