Miele 1119 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Technical Information


Date: June 7, 2004

To: Technical Service

Subject: Washer/Dryer Stand W1113, 1119, 1203, 1213, 1215
T1302, 1303, 1322C, 1323C, 1329C, 1403, 1405

ملخص المحتوى في الصفحة رقم 2

Washer Stand Washer Stand Note: The washer/dryer stand is designed for use with washers and dryers only. Use for any other purpose may result in damage to the machine or personal injury. DO NOT USE OR PLACE A STACKED WASHER AND DRYER ON THIS STAND! Carry out the following steps prior to installing the stands. Drawer Removal Pull the drawer out all the way. Lift upward to release and remove see Fig. 2

ملخص المحتوى في الصفحة رقم 3

Washer Stand Installation • Drain the unit, before laying it on its side. • Remove the shipping struts • Lay the washer on its right side. Be sure to lay the unit on a flat, soft underlay (i.e. carpet) • Remove the washers feet • Using the threaded studs and nuts provided (M10), screw 2 nuts midway onto each threaded stud. • Screw the threaded studs (M 10) into the washer and tighten them see Fig. 5. • Install a washer (10.2 x 32 x 2) on each threaded stud. • Fit the stand on