Casio DQR-100 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

WAVE
WAVE
UP(+)
UP(+)
MA0308-EA
Operation Guide DQR-100
Main unit
Sub-unit
1
AB C
°C/ °F RESET
SNZ
ON
OFF
SNZ
5 ALM ON
OFF
ALM
TEMP.
CLEAR
MAX/MIN
°C/ °F RESET
RESET
SET
TEMP.
CLEAR
9
MAX/MIN
7 8
4 0
RESET
6
3
SET
2
• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the
clock.
• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.
2
Alarm Off Alarm On
Current time
(Ho

ملخص المحتوى في الصفحة رقم 2

Operation Guide DQR-100 GENERAL GUIDE Main unit 1SNOOZE/LIGHT button • Press this button to illuminate the display for about four seconds. • Pressing this button while the alarm is sounding stops the alarm. 2Alarm Time Set buttons Use these buttons to change the alarm time or current time setting. 3SET button Inside, among Inside a vehicle Near refrigerators Near a Near high-tension Among or behind Use this button when setting the current time. buildings, or near or other household construction

ملخص المحتوى في الصفحة رقم 3

WAVE WAVE UP(+) UP(+) Operation Guide DQR-100 Setting the Time and Date Manually USING THE ALARM • When using the clock in an area that is outside of the range of the transmitter in Mainflingen or in an area where The alarm sounds and the light turns on when the alarm time you set is reached. You can also use the Alarm signal reception is impossible for some reason, you need to manually adjust the time as required. Mode selector (5) to select the snooze alarm feature. 1. Press the SET button (3)

ملخص المحتوى في الصفحة رقم 4

Operation Guide DQR-100 BATTERY REPLACEMENT High Temperature and Low Temperature Memory Low Battery Warning • The following data is stored in memory automatically. A indicator appears on the display to let you know when battery power is low. Replace the batteries as soon Main unit high temperature and low temperature as possible. Sub-unit high temperature and low temperature Note that the indicator appears on both the main unit and sub-unit when sub-unit battery power goes low. To replace main

ملخص المحتوى في الصفحة رقم 5

Operation Guide DQR-100 USING THE SUB-UNIT Data Transfer from the Sub-unit • Data is transferred from the sub-unit to the main unit every three minutes. • The sub-unit is able to send data to the main unit up to an unobstructed distance of about 30 meters. • The data receive status is indicated on the display of the main unit by the icons shown below. Receive successful Receive unsuccessful • If a receive operation is not successful for some reason, the display of the main unit shows dashes (–)