ملخص المحتوى في الصفحة رقم 1
ULIN_016357_30092.fm Page 1 Thursday, March 23, 2006 2:58 PM
Use and Care Guide
®
Combo Ice Maker/Refrigerator Model:
CO2175FF
Refrigerator/Freezer Model:
2175RF
CO2175FF 2175RF
ملخص المحتوى في الصفحة رقم 2
1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. U-Line products are making life mor
ملخص المحتوى في الصفحة رقم 3
2 Table of Contents Introduction ...............................................................................................................................2 Warranty Registration .......................................................................................................2 Please Record Your Model Information ...........................................................................2 Table of Contents ...............................................................................
ملخص المحتوى في الصفحة رقم 4
This page intentionally left blank 4 CO2175FF, 2175RF
ملخص المحتوى في الصفحة رقم 5
WARNING 3 Safety Precautions SHOCK HAZARD - Electrical Grounding Required. IMPOR IMPORT TAN ANT T � Never attempt to repair or perform maintenance on the unit until the electricity PLEASE READ all instructions completely before has been disconnected. attempting to install, operate, or service your unit. � Never remove the round grounding prong from • Proper installation procedures must be followed the plug and never use a two-prong grounding if this unit is being initially installed, or is
ملخص المحتوى في الصفحة رقم 6
� Self-closing door hinges engage when the door is open 4 Product Features approximately 8-10 in. (20-25 cm), ensuring a positive door seal and preventing door bounce back. Échelon Model 2175RF Refrigerator/ � Black and white models feature a slightly contoured, across the top, integrated door handle design that Freezer, Model CO2175FF Ice Maker/ permits the door to be easily reversed. The doors come Refrigerator standard with a factory installed flush panel. They can accommodate a 1/4 in
ملخص المحتوى في الصفحة رقم 7
Temperature Control 5 Operation Checking Product Temperature ULIN_0080_A Figure 2 IMPOR IMPORT TAN ANT T Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected. ULIN_0093_A Initial Startup Figure 4 All U-Line units are shipped with controls that are preset. No initial adjustments are required. To check the actual product temperature, in re
ملخص المحتوى في الصفحة رقم 8
Temperature Display Interior Lighting To display the interior temperature: The LIGHT icon (Figure 3, 5) on the control panel is used to control an additional lighting function. The blackout/ 1. Touch and hold the WARMER icon (Figure 5, 2) for Sabbath mode (not Star K certified) will turn the interior approximately five seconds and release when the °F light and display (Figure 3, 3) off. symbol in the display (Figure 5, 3) begins to flash. To access the blackout/Sabbath mode (not Star K 2. T
ملخص المحتوى في الصفحة رقم 9
The ice bucket can be removed for emptying and Ice Maker cleaning. To remove the ice bucket, raise the bin arm and When the ice bucket is full, the ice making mechanism will remove the bucket from the ice compartment. Use the ice shut off. However, the refrigeration system will continue bucket for ice storage only. to cool and maintain the cube supply. Frost-free icemaker units have lower ice production than manual defrost Normal Operating Sounds units. All models incorporate rigid foam in
ملخص المحتوى في الصفحة رقم 10
Food Storage Storage, Vacation, Moving If the unit will not be used for an extended period, or Crisper otherwise stored, follow these steps completely: Your models may have a lower crisper drawer for storage. WARNING Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels. Failure to do so may result in death or electrical shock. 1. Remove all consumable contents from the unit. 2. Disconnect power to the unit. 3. Shut off water supply to the unit at t
ملخص المحتوى في الصفحة رقم 11
Product Disposal 6 Cleaning and Maintenance If the unit is being removed from service for disposal, check and obey all Federal, State and/or Local regulations General Cleaning regarding the disposal and recycling of refrigeration appliances, and follow these steps completely: Exterior Cleaning (As Required) 1. Disconnect power to the unit and unplug the power Black and White Models: cord from its outlet. � Surfaces may be cleaned with a mild detergent and warm water solution. Do not use sol
ملخص المحتوى في الصفحة رقم 12
Maintenance CAUTION Proper maintenance of your U-Line product will ensure DO NOT use any type of cleaner on the condenser efficiency, top performance and long life. The unit. maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you 4. Clean the condenser coil (Figure 9, 2) using a soft have pets or other special considerations. brush with a “combing” action or vacuum cleaner. Do not touch the condenser coil. Defrosting 5. Position the grille
ملخص المحتوى في الصفحة رقم 13
Ice Cube Thickness Adjustment 4. Install the ice maker assembly cover. Interval - As Required IMPOR IMPORT TAN ANT T On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into Use only genuine U-Line replacement parts. U-Line ice maker parts are not the same as standard FSP the ice maker assembly as follows: Whirlpool parts. Using non U-Line parts can reduce ice rate, cause water to overflow from ice maker mold, damage the unit, and may void th
ملخص المحتوى في الصفحة رقم 14
Door Alignment Check and Adjustment IMPOR IMPORT TAN ANT T When properly aligned: 1 � The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top. � The door gasket will be firmly in contact with the 23 ULIN_0201_A perimeter of the cabinet and not pinched on the hinge side of the door. Figure 17 The following procedure will correct for up to 1/4 in. 3. Turn the door upside down and inspect the hinge plate misalignment: m
ملخص المحتوى في الصفحة رقم 15
Door Reversal 1 ULIN_0002_A Figure 21 2. Remove plastic screw plugs (three each, top and bottom) (Figure 21, 1) from new hinge location. Do not discard. 3. Remove top hinge (three screws) (Figure 20, 2) and reinstall hinge screw pin (Figure 20, 1). ULIN_0015_A Figure 19 Black and white units may be left- or right-hand opening. Stainless steel unit doors cannot be reversed. The doors are easily reversed by moving the hinge hardware to the opposite side. The top hinge hardware will be used o
ملخص المحتوى في الصفحة رقم 16
5. Remove the two door closer inserts (Figure 23, 1) from Door Shelf Removal/Insertion the existing bottom hinge and install as shown on the new bottom hinge (Figure 22, 1). 6. Remove existing bottom hinge (three screws) and 1 remount on opposite side TOP. Remove hinge screw pin. 7. Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side. 2 ULIN_0006_A ULIN_0039_A Figure 24
ملخص المحتوى في الصفحة رقم 17
Glass Shelf Removal/Installation Light Bulb Replacement Remove the shelves as follows: To replace the light bulb in your U-Line unit: 2 1 ULIN_0001_A Figure 27 1. Grasp the edges of the light housing lens (Figure 27, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 27, 2). 2. Pull the edge of the lens down (Figure 27, 1) and swing it out of the light housing. IMPOR IMPORT TAN ANT T ALWAYS use a genuine U-Line replacement bulb (P/N 31317) in the light housing. Use o
ملخص المحتوى في الصفحة رقم 18
7 Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the TROUBLESHOOTING GUIDE in this guide will assist you in quickly identifying common problems, and provide information on possible causes and remedies. Most often, this will resolve the problem without the need to call for service. If Service is Required
ملخص المحتوى في الصفحة رقم 19
Troubleshooting Guide DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY Unit does not operate and No electrical supply Plug unit in or check circuit breaker. electronic display is blank. No interior light Loose or burned out bulb Tighten or replace bulb (See MAINTENANCE; LIGHT BULB REPLACEMENT). Electronic display is bla
ملخص المحتوى في الصفحة رقم 20
PROBLEM POSSIBLE CAUSE REMEDY ICE MAKER EQUIPPED MODELS ONLY Water is leaking out the back of the Water supply connection leaking Tighten fitting as required. unit. Ice cubes sticking together Infrequent use of cubes Break apart cubes. No ice Bin arm locked in upright position Lower bin arm. No water to unit Turn on water or contact plumber. Not enough ice Ice cube size too large Set cube size smaller (See MAINTENANCE; ICE MAKER; ICE CUBE THICKNESS ADJUSTMENT). Dirty condenser coils Clean conde
