Manitowoc Ice SD1472C دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

KFC and Taco Bell Logo Application Instructions

Manitowoc Models S600C, S1470C

These instructions will help the location manager or machine installer to correctly center the urethane logo on the front panel of the
Manitowoc ice machine.

Tools Needed:
Philips head screw driver

Contents of Kit:
Small packet containing alcohol prep pad

Urethane logo
L-shaped static cling template


MODELS - SY1474C or SD1472C
MODEL - SY0674C or SD0672C
Follow these instructions to

ملخص المحتوى في الصفحة رقم 2

MODEL - SY0684C or SD0672C MODELS - SY1474C or SD1472C 1. Place the panel on a flat, horizontal surface with the stainless steel side (exterior) facing up. 6. Examine the urethane logo. Notice that it is covered on one Note: The screw hole on the face of the panel should be in the side by white backing paper and on the other by a thinner semi- lower right-hand corner when you are facing the panel, as transparent masking film. Peel back the solid, white backing pictured below: paper slo

ملخص المحتوى في الصفحة رقم 3

8. When the semi-transparent masking and logo are in place, apply pressure against the top of the masking, working out any visible air bubbles. Remove the semi-transparent logo masking very slowly, allowing only the urethane logo to remain in the space within the template frame. As the semi-transparent masking is pulled back, make sure no stray pieces of urethane logo remain attached to the semi-transparent masking. If this occurs, slowly lower the masking and press firmly against