Cornelius Remcor 70217 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

IMI CORNELIUS INC g One Cornelius Place g Anoka, MN 55303-6234
Telephone (800) 238-3600 Facsimile (612) 422-3246
FOR
ED150-8V “K” STYLE LID KITS,
P/N 630200153 AND 630000191
THESE “K” STYLE KITS APPLY TO THE FOLLOWING ICE
MAKERS:
Ice Maker Width
Cornelius 322/522 22I
Crystal Tips 200/300/400 22”
Ice-O-Matic 22”
Manitowoc 320/420 22”
Scotsman SLC 300/400 22”
Servend S2/4 22”
Table 1. Loose-Shipped Parts
Item
No. Part No. Name Qty.
1 1
52994 Cover, Gray (630000191) 1
52934 Cover, Black (630200153)

ملخص المحتوى في الصفحة رقم 2

3. Place (2) sealing washers (item 9) over studs and (2) flat washers (item11), then fasten in place with (2) plastic acorn nuts (item 8). 4. Set ice maker lid on the top of the dispenser. 5. Using the slotted holes in the lid as a template, drill four (4) .140Idiameter (9/64I) holes at the bottom of the slots (see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8 sheet metal screws, two on each side. 6. Seal the ice maker to the top of th

ملخص المحتوى في الصفحة رقم 3

8 11 9 12 10 SECTION Y -- Y 8 2 PLCS. 11 2 PLCS. 9 2 PLCS. 12 10 FIGURE 1. ED150--8V KIT 620912201 3

ملخص المحتوى في الصفحة رقم 4

ICEMAKER VIEW ”A” ENLARGED 4 (8) PLCS. DRILL 9/64 (.140) DIA. HOLES USING BOTTOM OF SLOTTED HOLES AS A TEMPLATE. 3 (4) PLCS. 4 6 (2) PLCS. 2 VIEW ”A” 1 FIGURE 2. DISPENSER ASSEMBLY 620912201 4