Henny Penny OE/OG 301 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

The controls have four programming levels, a first level mode, a
second level mode, a third level mode, and a special program
mode. In each level, pressing the set switch advances through
the programmable items. Program mode can be entered at
anytime except during an alarm. The left display describes the
item being programmed. The right display shows the item set-
ting and can be changed by pressing the right Up and Down
Switches.
The Low Level Program Mode allows the operator to program

ملخص المحتوى في الصفحة رقم 2

7. Press the set switch and the alarm LED flashes. The left display shows “AL 1”) the right display shows the alarm time and can be adjusted with the right Up and Down Switches. 8. Repeat step 8 for alarms 2,3, and 4. 9. Press and hold the Set Switch to exit program mode, or continue to second level mode. The Second Level Program Mode allows the operator to pro- gram load compensation, load anticipation, proportional control, filter cycle for the selected product, and the idle parameter

ملخص المحتوى في الصفحة رقم 3

8. Also, with the Product LED flashing, pressing the right Up and Down Switches will access the Idle Mode parameters. The idle LED will be flashing, the left display will continue to show “Slct” and the right display shows “Prod.” Pressing the Set Switch allows the operator to program the idle parameters (See Section 4-3). The Idle Mode must be enabled for the operator to access this 4-3. I ING mode. 1. While in the Second Program Mode, and the Product LED is flashing, press the right

ملخص المحتوى في الصفحة رقم 4

el 30113Q21303 3. Press the Set Switch and the left display flashes “Prob” and “Calib.” The right display shows the actual pot temperature, and the right Up and Down Switches are used for calibration. 4. Press the Set Switch and the left display flashes “AL” and “dur.” The right display shows the duration of this alarm at the end of a cook cycle, and can be adjusted with the right Up and Down Switches. 5. Press the Set Switch and the left display flashes “Hold” and “dur.” The left disp