Invacare Comfort-Mate Extra / Comfort-Mate Extra Base دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

 
  
 
   


   
 
ATTACHING/REMOVING CUSHION
SAVE THESE INSTRUCTIONS
TO/FROM SEATING SURFACE
NOTE: Check all parts for shipping damage. In case of
damage, DO NOT use. Contact Carrier/Invacare for fur- (FIGURE 1)
ther instruction.
The cushion attaches to the wheelchair seating surface
SAFETY SUMMARY
using hook and loop fastening strips. The bottom of the
The following recommendations are made for the safe cushion cover

ملخص المحتوى في الصفحة رقم 2

Seat Front of Seat Zipper Faces Back of Chair Front of Loop Portion of Mounting Fastening Strip Cushion Hook (Attached To Lines Locations Seat) up with the Front Double Sided Edge of Hook Portion of Seating Fastening Strip Surface Rear of Seat Seating Surface FIGURE 1- ATTACHING/ REMOVING SEAT TO/FROM SEATING SURFACE ATTACHING/ADJUSTING THE CUSHION/BASE MOUNTING HOOKS TO BASE (FIGURE 2) NOTE: Refer to FIGURE 2 in this instruction sheet for mounting hook locations. 1. For minimal width adjustment

ملخص المحتوى في الصفحة رقم 3

INNER COVER STEPS 1 THROUGH 3 Quick Release Hand clean the water repellant inner cover using a soft Release Rail Clamp cloth, warm water and a mild soap solution. Rinse off Tab Thumb-like and hang dry. Feature OUTER COVER CAUTION Mounting MACHINE WASH seat cover in cold water on Lock Screw gentle cycle using a mild detergent. DO NOT Washer use fabric softeners or bleach. DO NOT machine dry. Air dry ONLY. DO NOT dry in sun. Otherwise Mounting damage to the cover will result. Hook Internal Threade

ملخص المحتوى في الصفحة رقم 4

LIMITED WARRANTY PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLI- CABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975. This warranty is extended only to the original purchaser/user of our products. This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state. Invacare warrants the Comfort-Mate Extra / Comfort-Mate Extra Base to be free from defects in materials and workmanship for a period of two (2) years