Invacare Articulating/Elevating Legrest دليل المستخدم

ملخص المحتوى في الصفحة رقم 1


 
   
 
  
REMOVING EXISTING RATCHET
SAVE THESE INSTRUCTIONS
ASSEMBLY (FIGURE 1)
NOTE: Check ALL parts for shipping damage. In case of
NOTE: Note location and orientation of ratchet assembly
shipping damage, DO NOT use. Contact Carrier/Dealer
BEFORE removing for installation of NEW ratchet kit.
for further instruction.
1. Determine how the ratchet handle is secured to the
SAFETY SUMMARY
legrest.
The f

ملخص المحتوى في الصفحة رقم 2

RATCHET KIT WITH ROLL PIN: RATCHET KIT WITH SNAP RING: ELEVATING LEGREST ELEVATING LEGREST Domed Upper Push Cap Support Tube Ratchet Upper Ratchet Bar Support Legrest Handle Tube Support Tube Ratchet Elevating Snap Handle Support Tube Ring ARTICULATING LEGREST ARTICULATING LEGREST Upper Drive Link Ratchet Support Tube Handle Ratchet Drive Link Handle Upper Support Tube Legrest Support Tube Ratchet Bar Snap Link Bar Elevating Link Bar Ring Support Tube NOTE: Domed push cap not used on articulatin

ملخص المحتوى في الصفحة رقم 3

INSTALLING NEW RATCHET KIT Legrest Support Domed Tube Elevating Legrests (Figure 2) Push Ratchet 1. Install ratchet handle through support tube. Cap Body 2. Install nylon washer onto end of ratchet handle. Ratchet Ratchet Bar 3. Install spring into ratchet body. Snap the spring clips Handle into the spring clip mounting holes of the ratchet body. Acorn 4. Insert the cam into the ratchet body against the spring Nut Nylon ensuring that the teeth on the cam are facing up as Washer shown in DETAIL

ملخص المحتوى في الصفحة رقم 4

17. Close legrest as far as possible. Articulating Legrests (Figure 3) 18. Reinstall upper legrest support to lower legrest sup- 1. Install ratchet handle from outside of legrest through port ensuring that the gears mesh. upper legrest support tube. 19. Reinstall screw and locknut to secure legrest sup- 2. Install nylon washer onto end of ratchet handle. port. Securely tighten. 3. Install spring into ratchet body. Snap the spring clips into the spring clip mounting holes of the ratchet body OUTS

ملخص المحتوى في الصفحة رقم 5

CORRECT ASSEMBLED POSITION FOR COMPLETE TRAVEL OF ARTICULATING LEGREST (FIGURE 4) 1. The ADULT, after it is mounted to the chair frame, will be at about a 30° angle. 2. The HEMI, after it is mounted to the chair frame, will be at about a 45° angle. NOTE: Check legrest for full travel and locking capability before use. ADULT ARTICULATING HEMI ARTICULATING One (1) Two (2) Spacers Spacers APPROX. 30° APPROX. 45° FIGURE 4 - ASSEMBLY OF THE ARTICULATING LEGREST 5

ملخص المحتوى في الصفحة رقم 6

NOTES 6

ملخص المحتوى في الصفحة رقم 7

NOTES 7

ملخص المحتوى في الصفحة رقم 8




          
              !  "#$ %&   '   (()*+,-, ./ )0  1 ,   '   2+)))+* +2+22)2 3  4  )+- 5 4  -(,2 /   6-7 8