ملخص المحتوى في الصفحة رقم 1
Transformer
Control Panel
230 VAC
Spa
BLK
Light
J20
J1
J21
WHT JP1
K1
8 7
6 5
Temperature Sensor
4 3
J12 2 1
BRN
K2
Hi-limit/Freeze Sensor
O J2
3
J14
Ozonator BRN
Flow Switch
K3
J3
Circ.
Pump J16
J4
Logic Jumper Settings
K4
All Export 50 Hz Models:
J11
BLU
JP1 1-2 ON = 20A Logic*
JP1 1-2 OFF = 30A Logic
F1
BLU *Factory Jumper Setting
J15
K5 K7 K8
Temp. Jumper Settings (All Models):
BLU
JP1 7-8 ON = Celsius Temp Display
J5
J13
JP1 7-8 OFF = Fahrenheit Temp Display
BRN
Heater IN Heater OUT
J17
ملخص المحتوى في الصفحة رقم 2
Attention New Spa Owner! Congratulations on the purchase of your new Jacuzzi® spa! The following is a list of automated functions performed by your spa. These functions are listed below in an attempt to suppress any operational concerns you may have during the first 24-hours of ownership! Also listed below are important maintenance recommen- dations you should observe on a regular basis to protect your new investment. Automated Operations Approximately two minutes after power is applied to
ملخص المحتوى في الصفحة رقم 3
Table of Contents 1.0 Important Spa Owner Information ..............................................1 2.0 FCC Notice ....................................................................................1 3.0 Important Safety Instructions .....................................................2 4.0 Choosing A Location ...................................................................7 4.1 Outdoor Location ...........................................................................7 4.2 Indoor L
ملخص المحتوى في الصفحة رقم 4
13.0 Water Quality Maintenance .......................................................27 13.1 pH Control ....................................................................................27 13.2 Sanitizing ......................................................................................28 13.3 Optional CD Ozone Water Maintenance System ........................28 14.0 Error Conditions/Error Messages ............................................28 14.1 Panel Displays SN1 .....
ملخص المحتوى في الصفحة رقم 5
1.0 Important Spa Owner Information ® Your Jacuzzi 200 series spa is constructed to the highest standards and is capable of providing many years of trouble-free use. However, because heat retentive materials are utilized to insulate the spa for effi- cient operation, an uncovered spa surface directly exposed to sunlight and high temperatures for an extended period is subject to permanent damage. Damage caused by exposing the spa to this abuse is not covered by warranty. We recommend that yo
ملخص المحتوى في الصفحة رقم 6
3.0 IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY When installing and using this electrical equipment, basic safety precau- tions should always be followed, including: . WARNINg: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. 2. WARNINg: A grounding wire connector is provided on this unit to 2 connect a minimum No. 8 AWG (8.4mm ) solid copper conduc- tor between this unit and any metal equipm
ملخص المحتوى في الصفحة رقم 7
8. WARNINg: To Reduce the Risk of Injury: 9. The water in the spa should never exceed 04°F (40°C). Water temperatures between 00°F (38°C) and 04°F (40°C) are consid - ered safe for a healthy adult. Lower water temperatures are recom- mended for young children and when spa use may exceed 0 min - utes. 0. Since excessive water temperatures have a high potential for caus- ing fetal damage during the early months of pregnancy, pregnant or possibly pregnant women should limit spa water tempera
ملخص المحتوى في الصفحة رقم 8
IMPORTANT CSA SAFETY INSTRUCTIONS (CANADA ONLY) When using this electrical equipment, basic safety precautions should always be followed, including the following: . READ AND FoLLoW ALL INSTRUCTIoNS. 2. A green colored terminal or a terminal marked G, Gr, Ground, Grounding or the symbol* is located inside the supply terminal box or compartment. To reduce the risk of electric shock, this terminal must be connected to the grounding means provided in the electric supply service panel with a
ملخص المحتوى في الصفحة رقم 9
WARNINg: Water temperature in excess of 40°C (04°F) may be injuri - ous to your health. WARNINg: Before entering the spa, measure the water temperature with an accurate thermometer. WARNINg: Do not use a spa immediately following strenuous exercise. WARNINg: Prolonged immersion in a spa may be injurious to your health. WARNINg: Do not permit electric appliances (such as lights, telephone, radio, television, etc.) within 5 feet (.5m) of this spa unless such appli - ances are built-in by the
ملخص المحتوى في الصفحة رقم 10
A warning sign is provided in your warranty packet. Please install it at a location near your spa, where it is visible to the user of the spa. For additional or replacement signs please contact your local Jacuzzi spas dealer and reference item num- ber #6530-082. CAUTIONS . Persons suffering from heart disease, diabetes, high or low blood pressure, and any condition requiring medical treatment, pregnant women, the elderly, or infants should consult with a physician before using a spa. 2.
ملخص المحتوى في الصفحة رقم 11
4.0 Choosing A Location IMPORTANT: Because of the combined weight of the spa, water and users, it is extremely important that the base upon which the spa rests be smooth, flat, level and capable of uniformly supporting this weight, without shifting or settling, for the entire time the spa is in place. If the spa is placed on a surface which does not meet these requirements, damage to the skirt and/or the spa shell may result. Damage caused by improper support is not covered under warranty.
ملخص المحتوى في الصفحة رقم 12
4.2 Indoor Location For indoor installations, be certain to make provisions for proper ventilation. When the spa is in use, considerable amounts of moisture will escape. This can damage certain surfaces over time. If you have any questions regarding the placement or installation of your spa, consult your authorized Jacuzzi dealer. WARNINg: In addition to maintenance of filters and water chemistry, proper ventilation is recommended to reduce the risk of exposure to viruses and bacteria tha
ملخص المحتوى في الصفحة رقم 13
6.0 Power Requirements ® Jacuzzi spas are designed to provide optimum performance and flex- ibility of use when connected to the maximum electrical service listed in the tables below. If you prefer, your dealer can perform a minor circuit board modification to allow your spa to accept an electrical service other than the factory setting. US/Canada J-210/J-220 1-Pump Convertible Model (60Hz) 120V/15A* 240V/30A* 240V/40A** Voltage: 120 VAC 240 VAC 240 VAC # of Wires: 3 (15A GFCI Cord 4 4 US
ملخص المحتوى في الصفحة رقم 14
Export J-210 / J-220 1-Pump Models (50Hz) 230V/20A* 230V/30A** Voltage: 230 VAC 230 VAC # of Wires: 3 3 Frequency: 50Hz 50Hz Current Draw: 15A 21A Circuit Breaker: 20A 30A * In the 20A configuration, the heater will not operate while the jets pump is running in high speed. This is the factory setting. ** In the 30A configuration, the heater will operate while the jets pump is running in high speed. Export J-230 2-Pump Model (50Hz) 230V/20A* 230V/30A** 230V/40A*** Vol
ملخص المحتوى في الصفحة رقم 15
• Convertible 120/240V Operation: The included 120V GFCI cord must be discarded for 240V operation. This spa must be hard wired. Supplying power to either configuration above which is not in accor- dance with these instructions will void both the independent testing agency listing and the manufacturer’s warranty. 2. dedicated 230-240V Power Models: This spa must be permanently connected (hard-wired) to the power supply. NO Pl Ug- IN CONNECTIONS OR ExTENSION CORdS ARE TO bE USEd IN CONJUNC
ملخص المحتوى في الصفحة رقم 16
Figure-A Equipment Area 7 8 Flow 4 6 3 5 Note: Pump Locations Vary by Model 5 2 2 6. -Speed Pump #2 . Control Box 7. optional CD ozonator (Purchased Separately) 2. Power Supply Inlet(s) 3. 2-Speed Pump # 8. ozone Injector 4. Heater 5. Pump Drain Plug Figure-b - Control box 2 TB . Terminal Block 2. Bonding Lug 3. Grounding Terminal 3 WHT TB Figure-C TB Figure-D WHT WHT WHT RED BLK BLK BLK BLK BLK BLK 2 2 to Circuit RED Board RED 3 3 to Circuit Board GRN GRN Al
ملخص المحتوى في الصفحة رقم 17
WHT TB Figure-C TB Figure-D WHT WHT WHT RED BLK BLK BLK BLK BLK BLK 2 2 to Circuit RED Board RED 3 3 to Circuit Board GRN GRN All US/Canada J-210 / J-220 Convertible All US/Canada J-210 / J-220 Convertible Models: 120 VAC, 3-Wire Connection (60Hz) Models: 120/240 VAC, 4-Wire Connection (60Hz) RED BLUE Figure-E TB Figure-F TB RED RED BLUE BLK BRoWN BLK BLK BRoWN 2 2 to Circuit to Circuit Green Green Board Board TB3 TB3 All Export J-210 / J-220 / J-230 Models: US/Canada J-230 Model
ملخص المحتوى في الصفحة رقم 18
3. Turn On Power Turn on power to spa at the home’s circuit breaker. The heater and filter/circulation pump will automatically activate. If the control panel LCD flashes water temperature and “COL” or “ICE”, refer to page 29 for additional information. 4. Activate Jets Pump 1 Depress the JETS button on the control panel once to activate jets pump #. 5. Add Start-Up Chemicals Add the spa water chemicals as recommended by your authorized Jacuzzi dealer. See section 3.0 “W ater Qual
ملخص المحتوى في الصفحة رقم 19
B • The heater operates until the water reaches the programmed “set temperature”, then turns off. The heater will reactivate after the water cools to approximately 1.5° below the set temperature. 8. Place Cover On Spa • Keeping the insulating cover in place anytime the spa is not in use will reduce the time required for heating, thereby minimizing operat- ing costs. • The time required for initial heat-up will vary depending on the start- ing water temperature. DANGER: Risk of injur
ملخص المحتوى في الصفحة رقم 20
CAUTION: never leave your spa unattended for any reason while the cover is open and accessible to small children and animals! 11. Turn off power to the spa at the circuit breaker, then drain spa as outlined in section 12.2 “Draining And Refilling” (page 25). 12. Fill spa until water covers all jets but does not touch the bottom of the lowest headrest. Do NoT oVERFILL . CAUTION: Never fill with water from a water softener. If your water is extremely “hard”, it is preferable to fill half-wa