American Standard Cadet Whirlpool /Bathing Pool 2774.XXXW دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

CADET™ 6' x 42"
2774.XXXW SERIES
HIGH GLOSS ACRYLIC
SHOWN LESS ALL FITTINGS
WHIRLPOOL/BATHING POOL
INSTALLATION INSTRUCTIONS
PROVIDE ACCESS TO PUMP FOR
SERVICING ON ALL INSTALLATIONS
1829 mm
(72)
305 mm THANK YOU...
RECOMMENDED FITTING LOCATION
(12)
229mm
64 X 330mm (2-1/2 x 13")
(9)
FOR PIER OR ISLAND for selecting an American Standard bath. Your new
19 mm
INSTALLATIONS ONLY
(3/4)
bath is shipped to you after careful inspection. The
FINISHED
WALL
SEE FITTING whirlpool version is completely a

ملخص المحتوى في الصفحة رقم 2

INSTALLATION AND FRAMING INSTRUCTIONS The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for access to the drain components. NOTE: The apron should not be used as the primary

ملخص المحتوى في الصفحة رقم 3

ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: 1. DANGER: RISK OF ELECTRIC SHOCK Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a licensed electrician and grounded. 3. Install

ملخص المحتوى في الصفحة رقم 4

WIRE SELECTION GUIDE Maximum distance from The sizes shown on this fusebox to motor chart are recommendations 50' 100' 150' 200' Motor for copper conductors Hi Performance only. Always follow Rating 115V Power Line local and national electrical codes 2.1 12 10 8 8 DRAIN CONNECTION AND SYSTEM TEST Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fill w