ملخص المحتوى في الصفحة رقم 1
Operating Instructions
PMR3000 1 watt UHF CB Radio
Read this manual carefully before use.
ملخص المحتوى في الصفحة رقم 2
TM
ملخص المحتوى في الصفحة رقم 3
Table of contents Safety Information and Warnings ................................... 4 Information on Safe Operation ....................................... 6 Your Oricom PMR3000 radio controls ............................. 9 Your Oricom PMR3000 radio display ............................ 10 Getting Started ............................................................ 11 Operation ..................................................................... 13 UHF channels and frequencies ...............
ملخص المحتوى في الصفحة رقم 4
Safety Information and Warnings Safety Information and Warnings Damaged Antenna CAUTION Do not use any radio that has a damaged antenna. If a damaged antenna comes in contact with the skin, a minor burn may result. Batteries All batteries can cause property damage and/ or bodily injury such as burns if conductive material such as jewellery keys, or beaded chains touches exposed terminals. The material may complete an electrical circuit (short circuit) and become quite hot. Exercise care i
ملخص المحتوى في الصفحة رقم 5
Safety Information and Warnings Batteries WARNING Do not replace or charge batteries in a potentially explosive atmosphere. Contact sparking may occur while installing or removing batteries and cause an explosion. Blasting Caps and Areas To avoid possible interference with blasting operations, turn your radio OFF near electrical blasting caps or in a “blasting area” or in areas posted: “Turn off the two way radio.” Obey all signs and instructions. NOTE: Areas with potentially explosive at
ملخص المحتوى في الصفحة رقم 6
Information on Safe Operation Read This Information Before Using Your Oricom Radio. Transmit and Receive Procedure Your two-way radio contains a transmitter and a receiver. To control your exposure and ensure compliance with the general population/ uncontrolled environment exposure limits, always adhere to the following procedure: • Transmit no more than 50% of the time. • To receive calls, release the PTT button. • To transmit (talk), press the Push to Talk (PTT) button. Transmitting 50% of t
ملخص المحتوى في الصفحة رقم 7
Information on Safe Operation Radiocommunications (Citizen Band Radio Stations) Class Licence 2002 No licence is required to own or operate this radio in Australia and New Zealand. The Radiocommunications (Citizen Band Radio Stations) Class Licence 2002 contains the technical parameters, operating requirements, conditions of licence and relevant standards for Citizen Band (CB) radios. CB radios must comply with the class licence for their use to be authorised under the class licence. Elect
ملخص المحتوى في الصفحة رقم 8
Information on Safe Operation • Use the ear opposite the pacemaker to minimize the potential for interference. • Turn the radio OFF immediately if there is any reason to suspect that interference is taking place. Medical Devices - Hearing Aids Some digital wireless radios may interfere with some hearing aids. In the event of such interference, you may want to consult your hearing aid manufacturer to discuss alternatives. Other Medical Devices If you use any other personal medical device, con
ملخص المحتوى في الصفحة رقم 9
Your Oricom PMR3000 radio controls Indicator light On/off button Menu button Push to talk (PTT) button Volume up and menu settings Key lock Call tone Volume down button and menu settings Scan and monitor Headset socket Charging contacts Battery compartment clip 9
ملخص المحتوى في الصفحة رقم 10
Your Oricom PMR3000 radio display RX icon TX icon Baby monitor VOX Battery level Key tone Scan/dual scan CTCSS code Channel Stopwatch Call tone Squelech Volume Automatic power save mode Keypad lock Roger Beep 10
ملخص المحتوى في الصفحة رقم 11
Getting Started This pack contains • 2 UHF radios • 2 belt clips • 2 PTT headsets • 2 Ni-Mh rechargeable battery packs • 1 twin desk top charger • 1 AC adaptor Installing the batteries Each radio uses a Ni-Mh rechargeable battery pack (supplied). Or for added convenience you can choose to use 3 AAA alkaline batteries in each radio (not supplied). Warnings • Do not mix old and new batteries. • Do not charge alkaline or non rechargeable batteries as they could explode and cause injury. • If you
ملخص المحتوى في الصفحة رقم 12
Getting Started 4. Plug one end of the AC power adaptor into the charging pod and then the AC adaptor into the power socket. 5. Slide the radios into the charging pod ensuring the charging contacts line up. The red lights on the charge pod glow when radios are properly inserted. 6. The batteries will be fully charged within 14 hours. IMPORTANT NOTE 1. When moving between hot/cold environments do not charge the battery until the battery temperature acclimates (usually about 20 minutes). 2.
ملخص المحتوى في الصفحة رقم 13
Operation Turning your radio on and off Press and hold for three seconds to turn your radio on. The radio chirps and the display will show all feature icons for a brief period. Press and hold button for three seconds to turn off your radio. Adjusting the volume level When turned on, simply press or button to adjust the volume to a comfortable listening level. Selecting the channel 1. Press the button, the currently selected channel number will begin to blink. 2. Press the or button to
ملخص المحتوى في الصفحة رقم 14
Operation Press and hold the button to check for channel activity. If you hear static, the channel is clear for use. Your radio has 40 channels. If you are in a group and you wish to talk to each other, all radios must be set to the same channel and interference eliminator code (CTCSS). If you experience interference and need to change channel, ensure that you change the channel and code of all radios in your group. 1. For maximum clarity, hold radio 5 to 7cm’s from mouth. 2. Press and ho
ملخص المحتوى في الصفحة رقم 15
Operation Channel scan By scanning, you can monitor channels and codes for transmissions and lock in on the one that interests you. More importantly, you can find someone in your group who has accidentally changed channels and is talking during your scan. 1. To start scanning, briefly press and release the button. 2. If you activate scan while the CTCSS code is set to 0, then the radio will check for any activity on each channel, regardless of the CTCSS code in use on that channel. 3. If
ملخص المحتوى في الصفحة رقم 16
Operation To restore the channel to the scan list, turn the radio off and then on. You cannot remove your home channel from the scan list (your home channel is the channel your radio was set to when you activated scan). Keypad lock Press and hold the button for three seconds to lock or unlock the keypad. When the radio is locked, the icon will show in the display. The keypad lock disables the , and buttons. It also disables the scan function, but allows you to use the button to monit
ملخص المحتوى في الصفحة رقم 17
Operation Time-out timer The time-out timer feature helps extend battery life by preventing accidental transmission. The radio will emit a continuous warning tone if the button is pressed for more than 60 continuous seconds and will stop transmitting. The battery level meter The battery level meter located in the display indicates how much battery power you have remaining to protect the rechargeable battery. When the battery meter has one segment left, the radio will chirp after releasing
ملخص المحتوى في الصفحة رقم 18
Operation To set dual channel and code 1. Press until display. 2. Pressing the or button will increase or decrease the dual channel. 3. Press again and then press or button to increase or decrease the dual code number. 4. Press to exit the menu and save the dual channel and code combination. When the Dual Channel Monitor function is activated, the PMR will switch sequentially between the standby channel + CTCSS and the Dual Channel + CTCSS. When there is activity on the Dual Channel
ملخص المحتوى في الصفحة رقم 19
Operation Hands-free use (IVOX) This feature allows you to transmit “hands-free” by talking into the radio microphone without using the headset. How to use the IVOX feature 1. Press button until VOX appears. 2. Press or button to “ ” to disable the IVOX or enable IVOX by select level 1, 2 or 3. 3. Press button to confirm your setting. 4. At standby mode, when IVOX function activated, to transmit, speak into the radio microphone. To receive, stop talking. 5. Press will disable IVOX operat
ملخص المحتوى في الصفحة رقم 20
Operation Monitor function This feature allows you to listen for weak signals on the current channel. 1. Pressing and holding allows you to monitor your channel for activity. Note: It is good radio etiquette to monitor the channel for activity before you transmit, to ensure that you do not interrupt other users already on the channel. Baby monitor function One of the units can be set as Baby monitor. The radio will transmit a signal when it is activated by the crying baby or another sound
