Attwood 5080 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION, DECK MOUNT
®
All-Round Lights
1. To access mounting holes, gently twist lens helmet counterclockwise
to remove.
3
2. Place light in position as shown in Figure 1.
Important: Before drilling, be sure that light will shine within 5° of
12-Volt
horizontal when boat is floating.
3. Mark and drill 3/4" (19mm) diameter hole. (Figure 3)
Navigation Lights
4. Thread wire leads and base stem into hole. Mark location of screw
holes. Proceed to Step 5 below.
All-Round Li

ملخص المحتوى في الصفحة رقم 2

INSTALLATION, RAISED BASE MOUNT FINAL WIRING All-Round Lights CAUTION: 1. Place light in position as shown in Figure 1. Power source must be positive 12V DC only. All positive (+12V DC) wires must be fused to protect the circuit. Attwood Pulsar Navigation Important: Before drilling, be sure that light will shine within 5° of Lights require a 1-amp fuse. Failure to make proper connections and horizontal when boat is floating. fusing will void product warranty. 2. Mark and drill 3/8" (10mm) di