Attwood 3820 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

4. Measure and mark location of wire clearance hole. If installing a
bicolor light, location must be on the boat centerline. If installing
®
a sidelight pair, both must be the same distance from the bow.
3
At the marked location(s), make a mark for a ³⁄₄" hole. This hole is
necessary for wire passage and lamp ventilation (See Figure 2).
3800 Series Stainless
Figure 2
Steel 2-Mile Sidelights
• Cover Screw
Bicolor Combination Bow Light: 3810
Sidelight Pair: 3820
Attwood marine hardware, navigati

ملخص المحتوى في الصفحة رقم 2

1. Connect one lead to the negative (-) post of the 12-volt supply. 6. Place stainless steel cover over lens. Be sure gasket is inside Connect the other lead to a fused and switched positive (+) 12-volt the stainless steel cover at the back. Reinstall screw into cover supply. Sidelights require 1-amp fusing per lamp: a 1-amp fuse (See Figure 5). for the Bicolor Combination light, a 2-amp fuse for the Sidelight Pair. Note that navigation rules require sidelights to be operated Figure 5 separatel