Attwood 3130 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

3. Measure and mark location of terminal clearance hole. Be
certain that centerline of hole is aligned with boat centerline.
®
Drill a 1-¹⁄₈" (29mm)-dia. hole. (See Figure 2.)
3
Figure 2
(Applies to Quasar Light, not Snap Base)
Quasar 12-Volt 2-Mile
•• • •
Navigational Light 9/16" 1" 13/16"
(14mm) (25mm) (21mm)
Without Wire Leads: 3100-3104, 3130-3134
•
With 7" Wire Leads: 3120-3124, 3150-3154
Attwood marine hardware, navigational lighting, bilge pumps, and other
•
marine accessories are specif

ملخص المحتوى في الصفحة رقم 2

Figure 3a WIRING INSTRUCTIONS (Optional Mount with Snap Base) The power source must be 12-volt DC ONLY. Use marine grade wire connectors only. Protect all connections with suitable materials. Light Assembly NOTE: Failure to make proper connections and fuse the light properly will void the product warranty. 1. Connect one terminal to the negative ( - ) post of the 12-volt battery. Connect the other terminal to the positive ( + ) lead through a 2-amp fuse and suitable dash-mounted switch. (See Fig