Harbor Freight Tools 52848 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

AIR ANGLE DIE GRINDER
FRONT EXHAUST
Operating and Maintenance Instructions
Distributed exclusively by
®
Harbor Freight Tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright © 2001 by Harbor Freight Tools . All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced in any shape or form without the express written con-
sent of Harbor Freight Tools.
For technical questions please call 1-800-444-33

ملخص المحتوى في الصفحة رقم 2

SPECIFICATIONS ITEM DESCRIPTION 90 PSI Max. Air Pressure 20,000 RPM Air Speed 1/4” NPT Fitting Size 1/4” 1/8” Collet Sizes 11 mm Collet Wrench (Qty: 1) Accessories 17 mm Collet Wrench (Qty: 1) SAVE THIS MANUAL You will need this manual for the safety warnings and precautions, operating and maintenance procedures, parts lists and diagrams. Keep your invoice with this manual. Write the invoice

ملخص المحتوى في الصفحة رقم 3

8. STAY ALERT. Watch what you are doing at all times. Use common sense. Do not use the Air Angle Die Grinder when you are tired or distracted from the job at hand. 9. CHECK FOR DAMAGED PARTS. Before using the Air Angle Die Grinder, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of the Air Angle Die Grinder. Replace or repair damaged or worn parts immediately. 10. REPLACEMENT PAR

ملخص المحتوى في الصفحة رقم 4

FIGURE A UNPACKING When unpacking, check to make sure all parts shown on the Parts List and Assembly Diagram are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. OPERATING INSTRUCTIONS ALL PARTS BELOW REFER TO THE PARTS LISTED AND SHOWN IN THIS MANUAL. To Connect The Air Angle Die Grinder To An Air Hose: 1. The Air Angle Die Grinder requires the attachment of a 1/4” NPT Quick Connector (avail

ملخص المحتوى في الصفحة رقم 5

2. To change Collets (part #32) you will need to use the two accessory Collet Wrenches. 3. With one Wrench hold the Work Spindle (part #30) in place. Use the other Wrench to turn the Collet Jacket (part #33) counterclockwise. 4. Remove the Collet Jacket (part #33) and insert the appropriate size Collet (part #32) into the Work Spindle (part #30). 5. With one Wrench, hold the Work Spindle (part #30) in place. Use the other Wrench to turn the Collet Jacket (part #33) clockwise to tighten and loc

ملخص المحتوى في الصفحة رقم 6

PARTS LIST / ASSEMBLY DIAGRAM NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. REV 07k SKU 52848 PAGE 6