ملخص المحتوى في الصفحة رقم 1
Owner’s Manual
5.0 Horsepower
2400 PSI
2.2 GPM
PRESSURE WASHER
Model No.
919.672180
Safety Guidelines
Assembly
Operation
Maintenance
Storage
Troubleshooting
Repair Parts
CAUTION: Read the Safety Guidelines
and All Instructions Carefully Before
Operating.
Sold by Sears Canada, Inc. Toronto, Ont. M5B 2B8
D30339 Rev. 1 9/10/04
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 SPECIFICATION CHART . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 SAFETY GUIDELINES- DEFINITIONS . . . . . . . . . . . . . . . . . . . . . . . . . . .3 IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . .3-7 BOX CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 ASSEMBLY . .
ملخص المحتوى في الصفحة رقم 3
SPECIFICATION CHART Model No. 919.672180 Pressure Washer Pressure 2400 PSI Flow Rate 2.2 GPM Cleaning Units (PSI x GPM) 5280 Engine RPM 3600 Rated Horsepower 5.0 Spark Plug Gap .030” (0.76mm) Gasoline Capacity 1 quart (0.95 liters) Oil 20 oz. ( 0.6 liters) capacity SAE 30 weight SAFETY GUIDELINES - DEFINITIONS This manual contains information that is important for you to know and understand. This information relates to protecting YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recogni
ملخص المحتوى في الصفحة رقم 4
IMPORTANT SAFETY INSTRUCTIONS Read Operators Manual. Do not operate equipment until you have read operators Manual for Safety, Assembly, Operation, and Maintenance Instructions. READ AND SAVE THESE INSTRUCTIONS HAZARD RISK OF EXPLOSION OR FIRE WHAT CAN HAPPEN HOW TO PREVENT IT Spilled gasoline and it’s vapors can be- Shut off engine and allow it to cool before come ignited from cigarette sparks, adding fuel to the tank. electrical arcing, exhaust gases, and hot Use care in filling tank to
ملخص المحتوى في الصفحة رقم 5
HAZARD RISK OF INJURY OR PROPERTY DAMAGE WHEN TRANSPORTING OR STORING WHAT CAN HAPPEN HOW TO PREVENT IT Fuel or oil can leak or spill and could If pressure washer is equipped with a fuel result in fire or breathing hazard, serious shut-off valve, turn the valve to the off injury or death can result. Fuel or oil position before transporting to avoid fuel leaks will damage carpet, paint or other leaks. If pressure washer is not equipped surfaces in vehicles or trailers. with a fuel shut-off va
ملخص المحتوى في الصفحة رقم 6
HAZARD RISK OF UNSAFE OPERATION WHAT CAN HAPPEN HOW TO PREVENT IT Unsafe operation of your pressure washer Do not use chlorine bleach or any other could lead to serious injury or death to corrosive compound. you or others. Become familiar with the operation and controls of the pressure washer. Keep operating area clear of all persons, pets, and obstacles. Do not operate the product when fatigued or under the influence of alcohol or drugs. Stay alert at all times. Never defeat the saf
ملخص المحتوى في الصفحة رقم 7
HAZARD RISK OF INJURY FROM SPRAY WHAT CAN HAPPEN HOW TO PREVENT IT Always wear ANSI approved Z87 safety High velocity fluid spray can cause glasses.Wear protective clothing to protect objects to break, propelling particles at against accidental spraying. high speed. Never point wand at, or spray people or Light or unsecured objects can become animals. hazardous projectiles. Always secure trigger lock when wand is not in service to prevent accidental operation. Never permanently secur
ملخص المحتوى في الصفحة رقم 8
CARTON CONTENTS Accessories Panel Part No. D25081 English/ French Owners Manual Handle Engine Frame and Part No. D22316 with Wheel Assembly Screws Part No. D22901 Bagged Accessories Panel Knobs Part No. 16471 Saddle Bolts Part No. D23196 Chemical Hose Part No. Engine Oil Allen Wrench Part No. 16797 H140 High Pressure Cleaning Tool Part No. NCT001 Hose Part No. D28094 Bagged Parts Multi-Reg Wand Spray Gun Part No. A06120 Part No. D27858 ASSEMBLY 1. Place handle assembly onto 2. Connect wand
ملخص المحتوى في الصفحة رقم 9
5. To Assemble Accessories Panel Screws a. Remove top screws on handle assembly. b. Loosen bottom screws on handle assembly. Remove Loosen d. Place screws (removed earlier) into the top holes and secure accessories panel assembly to handles. Do not overtighten. c. Place grooves in accessories panel assembly onto screws and slide panel assembly into place. 9- ENG D30339
ملخص المحتوى في الصفحة رقم 10
OPERATION Know Your Pressure Washer READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Chemical Hose Throttle Control High Spray Pressure Gun Hose Hand Choke Oil Grip Control Fill Engine Air Filter Multi-Reg Wand High Pressure Pump PRESSURE WASHER Also, the high and low pressure settings can be controlled by moving High
ملخص المحتوى في الصفحة رقم 11
HOW TO USE PRESSURE WASHER IMPORTANT: Read and understand TERMINOLOGY how to use the pressure washer PSI: Pounds per Square Inch. The before operating. unit of measure for water pressure. TO ADJUST PRESSURE Also used for air pressure, hydraulic pressure, etc. The pressure setting is preset at the factory to achieve optimum pressure GPM: Gallons Per Minute. The unit of and cleaning. If you need to lower the measure for the flow rate of water. pressure, it can be accomplished by CU: Cleaning Unit
ملخص المحتوى في الصفحة رقم 12
2. Place other end of chemical hose The nozzle at the end of the multi- with filter on it into container adjustable spray wand can be rotated holding chemical/cleaning solution. to change the high pressure spray NOTE: The chemical/water ratio is pattern from a narrow jet to a 40º fan 7:1, for every 7 gallons of water shape, as shown. Markings have pumped 1 gallon of been placed on the nozzle to help chemical/cleaning solution will be you select the spray pattern. used. 3. Set multi-adjustable no
ملخص المحتوى في الصفحة رقم 13
2. Remove filler cap/dipstick and BEFORE STARTING add engine oil (supplied) to Read and understand all Important engine. Safety Instructions in the front of NOTE: There will be a slight amount this manual and the following of oil in the engine from factory Cautions and Warnings before testing. starting the pressure washer. 3. Oil level should be at the FULL line on dipstick. Always check oil level before each start-up. Never fill fuel tank completely. Fill tank to 1/2" below bottom Filler
ملخص المحتوى في الصفحة رقم 14
7. If you are applying a chemical or 10. Pull starter grip slowly until you cleaning solution, See How To feel resistance, then pull briskly. Apply Chemicals and Cleaning Return starter grip gently. Pull Solvents in Operation section of rope with a rapid full arm stroke. this manual. Let rope rewind slowly. Repeat if necessary. 8. Turn water source on. If the engine does NOTE: Make sure water supply is not start after two turned on. pulls, pull the trigger to relieve the 9. Move the choke contr
ملخص المحتوى في الصفحة رقم 15
CUSTOMER RESPONSIBILITIES TABLE Every 25 Every 50 Every 100 Before hours or hours or hours or each use MAINTENANCE TASK yearly yearly yearly ENGINE X check oil level change oil X* check air cleaner X** clean/replace spark plug X X clean debris X clean air cooling system clean combustion chamber X * Change oil after first 5 to 8 hours of use, then every 50 hours or every season. Change oil every 25 hours when operating the engine under heavy load or in high temperatures. ** Clean more often unde
ملخص المحتوى في الصفحة رقم 16
To Change Oil Air Cleaner Drain the engine oil when the engine To Remove is warm. Warm oil drains quickly and 1. Loosen screw and tilt cover completely. down. 2. Remove air cleaner. 1. Before tipping engine or equipment to drain oil, drain fuel 3. Reinstall clean (or new) air from tank by running engine until cleaner assembly inside cover. fuel tank is empty. Lip of pre-cleaner must be at bottom of cartridge pleats. 2. Disconnect spark plug wire and keep it away from spark plug. 4. Insert cover’
ملخص المحتوى في الصفحة رقم 17
Cleaning Debris NOZZLE CLEANING Engine parts should be kept clean to If the nozzle becomes clogged with reduce the risk of overheating and foreign materials, such as dirt, ignition of accumulated debris. excessive pressure may develop. If the nozzle becomes partially clogged NOTE: Do not use water to clean or restricted, the pump pressure will engine parts. Water could pulsate. Clean the nozzle contaminate fuel system. Use a brush immediately using the nozzle kit or dry cloth. supplied and th
ملخص المحتوى في الصفحة رقم 18
STORAGE PUMP ENGINE It is recommended that you follow IMPORTANT: It is important to prevent these steps to protect the internal gum deposits from forming in essential seals of the pressure washer when fuel system parts such as the storing the unit for an extended carburetor, fuel filter, hose or tank period and WHEN FREEZING during storage. Also, experience TEMPERATURES ARE EXPECTED. indicates that alcohol-blended fuels (called gasohol or using ethanol or NOTE: If storing the unit for more me
ملخص المحتوى في الصفحة رقم 19
6. Pull engine starter rope slowly 9. Drain all water from high pressure several times until antifreeze or hose, coil it, and store it in cradle windshield washer fluid comes of the pressure washer handle. out of high pressure hose con- 10. Drain all water from spray gun nection of pump. and wand by holding spray gun in 7. Remove short hose from water a vertical position with nozzle end inlet of pump. pointing down and squeezing trigger. Store in gun/hose holder. 8. Install spark plug into
ملخص المحتوى في الصفحة رقم 20
PROBLEM CAUSE CORRECTION No or low 6. Turn off the engine, then 6. Air in hose. pressure the water source. (initial use) Disconnect the water (continued) source from the pump inlet and turn the water source on to remove all air from the hose. When there is a steady stream of water present, turn water source off. Reconnect water source to pump inlet and turn on water source. Squeeze trigger to remove remaining air. 7. Choke lever in the 7. Move choke to the "No "Choke" position. Choke" positio
