ملخص المحتوى في الصفحة رقم 1
Model / Modelo
Operator’s Manual
020289
Manual del Operario
Questions? Help is just a moment away!
Preguntas? La ayuda es justa un momento lejos!
Call: Pressure Washer Helpline
Llame: Línea Directa del Lavador a Presión
1-800-743-4115 M-F 8-5 CT
web: www.briggsandstratton.com
WARNING ADVERTENCIA
Before using this product, read this manual and follow all Antes de utilizar el producto, lea este manual y siga todas las
Safety Rules and Operating Instructions. Reglas de Seguridad e Instrucciones
ملخص المحتوى في الصفحة رقم 2
Section Safety Rules 1 SAVE THESE INSTRUCTIONS TABLE OF CONTENTS SAFETY RULES Section 1 - Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . 2-5 This is the safety alert symbol. It is used to Section 2 - Features and Controls . . . . . . . . . . . . . . . . . . . 6 alert you to potential personal injury hazards. Section 3 - Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-9 Obey all safety messages that follow this Section 4 - Operation . . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 3
Section 1: Safety Rules WARNING WARNING Running engine gives off carbon monoxide, an Fuel and its vapors are extremely flammable and odorless, colorless, poison gas. explosive. Breathing carbon monoxide can cause nausea, Fire or explosion can cause severe burns or fainting or death. death. Some chemicals or detergents may be harmful if WHEN ADDING FUEL inhaled or ingested, causing severe nausea, � Turn pressure washer OFF and let it cool at least 2 minutes fainting or poisoning. before removing
ملخص المحتوى في الصفحة رقم 4
Section 1: Safety Rules WARNING WARNING Rapid retraction of starter cord (kickback) will The high pressure stream of water that this pull hand and arm toward engine faster than equipment produces can pierce skin and its you can let go. underlying tissues, leading to serious injury and possible amputation. Broken bones, fractures, bruises or sprains could result. Spray gun traps high water pressure, even when engine is stopped and water is disconnected, � ALWAYS point gun in safe direction and sq
ملخص المحتوى في الصفحة رقم 5
Section 1: Safety Rules CAUTION CAUTION Improper treatment of pressure washer can damage it Excessively high or low operating speeds increase risk and shorten its life. of injury and damage to pressure washer. � If you have questions about intended use, ask dealer or � DO NOT tamper with governed speed. contact Briggs & Stratton Power Products. � DO NOT operate pressure washer above rated pressure. � NEVER operate units with broken or missing parts, or without protective housing or covers. CAUTI
ملخص المحتوى في الصفحة رقم 6
Section Features and Controls 2 KNOW YOUR PRESSURE WASHER Read this Operator’s Manual and safety rules before operating your pressure washer. Compare the illustrations with your pressure washer to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. Spray Gun Accessory Tray Quick Connect Nozzle Extension Recoil Starter Spray Tips with Quick Connect High Pressure Hose Air Filter Primer Bulb Oil Fill/Dipstick Throttle Lever Detergent S
ملخص المحتوى في الصفحة رقم 7
Section Assembly 3 ASSEMBLY PREPARING PRESSURE IMPORTANT: Read entire operator's manual before you WASHER FOR USE attempt to assemble or operate your new pressure washer. If you have any problems with the assembly of your Unpack the Pressure Washer pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-743-4115. If calling for 1. Remove everything from carton except pressure assistance, please have the model, revision, and serial washer. number from the da
ملخص المحتوى في الصفحة رقم 8
Section 3: Assembly 2. Insert carriage bolts through holes from outside of unit 4. Insert “L” hook through hole just above billboard on and attach a plastic knob from inside of unit (Figure 2). left side of handle (viewing from front of unit). Hold Tighten by hand. hook in place and attach a plastic knob from inside of unit (Figure 4).Tighten by hand. Figure 2 — Secure Handle Figure 4 — Attach “L” Hook to Handle Spray Gun Hook 5. Insert multi–colored quick connect spray tips and other supplied a
ملخص المحتوى في الصفحة رقم 9
Section 3: Assembly 4. Run water through your garden hose for 30 seconds Connect Hose and Water Supply to to clean out any debris. Pump IMPORTANT: DO NOT siphon standing water for the IMPORTANT: To avoid pump damage, you must assemble water supply. Use ONLY cold water (less than 100°F). the nozzle extension to the spray gun and attach all hoses 5. Connect the garden hose (not to exceed 50 feet in before you start the engine. length) to the water inlet.Tighten by hand (Figure 7). NOTE: Remove and
ملخص المحتوى في الصفحة رقم 10
Section Operation 4 How to Start Your Pressure Washer HOW TO USE YOUR To start your pressure washer for the first time, follow PRESSURE WASHER these instructions step-by-step.This starting information also applies if you have let the pressure washer sit idle for If you have any problems operating your pressure washer, at least a day. please call the pressure washer helpline at 1-800-743-4115. 1. Place pressure washer near an outside water source capable of supplying water at a flow rate greater
ملخص المحتوى في الصفحة رقم 11
Section 4: Operation 9. When starting engine, position yourself as recommended WARNING in Figure 12 and start engine according to instructions Running engines produce heat.Temperature of given in engine operator’s manual.Also see operating muffler and nearby areas can reach or exceed instructions tag located on the pressure washer. 150°F (65°C). Figure 12 - Recommended Starting Position Severe burns can occur on contact. Exhaust heat/gases can ignite combustibles, structures or damage fuel tank
ملخص المحتوى في الصفحة رقم 12
Section 4: Operation How to Use Accessory Tray How to Use Quick Connect Spray Tips The unit is equipped with an accessory tray with places to store your spray gun, nozzle extension and quick connect The quick–connect on the nozzle extension allows you to spray tips.There is also a hook at the front of the switch between four different quick connect spray tips.The accessory tray to hold your high pressure hose. spray tips vary the spray pattern as shown (Figure 14). NOTE: The extra hole in the tr
ملخص المحتوى في الصفحة رقم 13
Section 4: Operation 2. Pull back collar on quick–connect and pull current To apply detergent follow these steps: spray tip off. Store spray tips in holder provided on the 1. Review spray tip use. accessory tray. 2. Prepare detergent solution as required by 3. Select desired spray tip: manufacturer. � For delicate rinse (lower pressure and higher 3. Place small filter end of detergent siphoning tube into flow), for gentle cleaning of cars/trucks, boats, RV’s, detergent container. patio furniture
ملخص المحتوى في الصفحة رقم 14
Section 4: Operation Pressure Washer Rinsing Cleaning Detergent Siphoning Tube If you used the detergent siphoning tube, you must flush it For Rinsing: with clean water before stopping the engine. 1. Engage trigger lock on spray gun. 1. Place detergent siphoning tube/filter in a bucket full of 2. Remove black detergent spray tip from nozzle clean water. extension. 2. Engage trigger lock on spray gun. 3. Select and install desired high pressure spray tip 3. Attach black detergent spray tip. follo
ملخص المحتوى في الصفحة رقم 15
Section Maintenance 5 SPECIFICATIONS PRESSURE WASHER Max Outlet Pressure . . . . . . . . . . . . . . . . . . . . . 2200 psi MAINTENANCE Max Flow Rate . . . . . . . . . . 2.2 gallons per minute (gpm) Detergent Use detergent approved for pressure washers Check and Clean Inlet Screen Water Supply . . . . . . . . . . . . . . . . Not to Exceed 100°F Examine the screen on the pump’s water inlet. Clean it if Temperature the screen is clogged or replace it if screen is damaged. Automatic Cool . . . .
ملخص المحتوى في الصفحة رقم 16
Section 5: Maintenance 1. Detach spray gun and nozzle extension from high 6. Reinstall spray tip and in-line filter into nozzle pressure hose. Detach nozzle extension from spray extension. gun and remove o-ring and screen from nozzle 7. Reconnect nozzle extension to spray gun. extension. Flush screen, spray gun, and adjustable 8. Reconnect water supply, turn on water, and start engine. nozzle extension with clean water to clear debris. 9. Test pressure washer by operating with each quick 2. Plac
ملخص المحتوى في الصفحة رقم 17
Section Storage 6 To use PumpSaver, make sure the pressure washer is PREPARING THE UNIT turned off and disconnected from supply water. Read and follow all instructions and warnings given on the FOR STORAGE PumpSaver container. Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on pump parts and CAUTION “freeze” pump action. If you do not plan to use the You must protect your unit from freezing temperatures. pressure washer for more than 30 days, follo
ملخص المحتوى في الصفحة رقم 18
Section Troubleshooting 7 TROUBLESHOOTING Problem Cause Correction 1. Low pressure spray tip installed. 1. Replace spray tip with high pressure spray tip. 2. Water inlet is blocked. 2. Clear inlet. 3. Inadequate water supply. 3. Provide adequate water flow. 4. Inlet hose is kinked or leaking. 4. Straighten inlet hose, patch leak. Pump has following problems: 5. Clogged inlet hose strainer. 5. Check and clean inlet hose failure to produce pressure, erratic strainer. pressure, chattering, loss of
ملخص المحتوى في الصفحة رقم 19
BRIGGS & STRATTON POWER PRODUCTS GROUP, LLC PRESSURE WASHER OWNER WARRANTY POLICY Effective December 1, 2005 replaces all undated Warranties and all Warranties dated before December 1, 2005 LIMITED WARRANTY Briggs & Stratton Power Products Group, LLC will repair or replace, free of charge, any part(s) of the pressure washer that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. Th
ملخص المحتوى في الصفحة رقم 20
Sección Reglas de Seguridad 1 CONSERVE ESTAS INSTRUCCIONES TABLA DE CONTENIDOS REGLAS DE SEGURIDAD Sección 1 - Reglas De Seguridad . . . . . . . . . . . . . . . . . . . . . . 20-23 Éste es el símbolo de alerta de seguridad. Sirve Sección 2 - Características y Controles . . . . . . . . . . . . . . . . . . . 24 para advertir al usuario de un posible riesgo para Sección 3 - Montaje . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25-27 su integridad física. Siga todos los mensajes de
