InStep RS100 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Keep this manual for future reference. If you sell or give this convenience
stroller away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
CONVENIENCE STROLLER
Operating Instructions
Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you
have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F,
8:00 a.m. – 5:00 p.m. CST or visit our web site at www.instep.n

ملخص المحتوى في الصفحة رقم 2

IMPORTANT We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with your selection. Great care and effort has been taken, however occasionally problems may occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer questions, please contact us at either our Toll-Free Customer Service Number or Email us at our number list- ed below. Service will be quicker if you have your model number (found o

ملخص المحتوى في الصفحة رقم 3

Step 3. Rear Wheel Rear Axle E1 D Assembly Assembly Turn stroller onto its front as shown (Figure D). Slide the rear axle assembly onto frame Rear Axle as shown (Figure E1). Rear Axle Assembly Note: to remove rear axle Release Buttons assembly push up the Both Sides plastic baffles while pushing in the silver release button pull off the axle assembly E2 F1 (Figure E2). Place rear brake cog on the rear Rear Axle wheel – turn the cog so the grooves line up with the ribs on the wheel sprocket, then

ملخص المحتوى في الصفحة رقم 4

Step 4. Mount child G1 G2 napper bar Napper Bar Release Tab Position bar as shown with tabs on the bottom. (Figure G1) Push in until tabs lock in place. To remove napper bar, push up on bottom tabs and pull off napper bar (Figure G2). Step 5. Adjust Canopy Push or pull canopy too the desired position. Use Instructions WARNING: Always remove child from stroller before folding. H To fold stroller: Step 1. Retract canopy and fully recline seat before folding (Figure H). (See “To adjust 3-position

ملخص المحتوى في الصفحة رقم 5

To place child in stroller: Always engage rear brakes so stroller is steady. Lift canopy from both sides and rotate back. Place child in stroller with the T-shield between the child’s legs. Fasten the waist buckle. Adjust belt so that it fits snugly around the child’s waist (Figure L). (Note: To release, squeeze sides of buckle) WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt. To adjust 3-position recline seat: L To fully recline seat, pull up on the recline bar

ملخص المحتوى في الصفحة رقم 6

Care and Maintenance Check fasteners After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary. Periodically check the stroller to ensure that it is in good operating condition. To clean seat and canopy: If light cleaning is required, use a soft cloth with warm water and mild soap then air dry. Do not put into washing machine. Do not put in dryer. DO NOT BLEACH. To clean frame: Wipe using a soft cloth with warm water and mild soap. Air dry. DO NOT USE polish or