ملخص المحتوى في الصفحة رقم 12
Using the Stroller as an Infant Car Seat Carrier The Big Caboose will accommodate a car seat carrier in EACH of the front seating locations. Follow the same instructions for each seat if two car seats are to be installed. • To use the stroller to carry an infant car seat carrier, you must replace the Child Tray with the Car Seat Carrier Support. Figure • Remove the Child Tray by pressing in on the lock tabs and pulling the tray off the brackets. Store the tray in a convenient pla
ملخص المحتوى في الصفحة رقم 13
WARNING ALWAYS install the infant carrier so that the child is facing toward the rear (handle) of the stroller with the restraining straps secured. ALWAYS position the infant carrier so that it is securely placed down inside the Car Seat Carrier Support frame. ALWAYS position the infant carrier so that it is resting ON the seatback, but NOT on the top of the seatback. NEVER position the carrier restraining straps on or near the child’s neck as this may result in strangulation. Right Way Pag
ملخص المحتوى في الصفحة رقم 14
IMPORTANT NOTE When using your stroller as an infant car seat carrier, the following are the compatible infant car seat models that the Caboose Stand-On Tandem will accommodate: • Graco® Snug Rider™ Series • Combi® Centre Series • Graco® SafeSeat™ • Combi® Connection • Peg Perego® Primo Viaggio • Safety 1st® Designer 22™ • Peg Perego® Primo Viaggio SIP • Eddie Bauer® Infant Car Seat (models 22-625 and 22-626) • Evenfl o® Embrace™ • Baby Trend® Latch-Loc and Flex-Loc • Chicco® Key Fit Car Se
ملخص المحتوى في الصفحة رقم 15
CAUTION: While folding the stroller, be careful to keep your fi ngers from being pinched by moving parts. • Secure the stroller in the folded position by engaging the locking latch on the right side of the stroller over the extended rivet. See Figure 28. Figure 8 Maintenance All of the fi ttings, snaps, locks, rivets, and other hardware and plastic parts on the stroller should be inspected periodically to insure that they are secured properly and not damaged or malfunctioning. The sea
ملخص المحتوى في الصفحة رقم 16
Joovy • 2919 Canton Street • Dallas, TX 75226 • (877) 456-5049 • Fax: (214) 761-1774 E-mail: customerservice@joovy.com • Website: www.joovy.com ©Joovy 2006 • Document Version 1.0 Page 16 The Big Caboose Stand-On Triple Instruction Manual
ملخص المحتوى في الصفحة رقم 1
The Big Caboose Stand-On Triple
Instruction Manual
These instructions are for the
following Joovy Style #’s:
430, 431, 437
Patent No. ,6,7
Please read this instruction manual completely before using
this stroller. Keep these instructions for future reference.
Joovy • 2919 Canton Street • Dallas, TX 75226 • (877) 456-5049 • Fax: (214) 761-1774
E-mail: customerservice@joovy.com • Website: www.joovy.com
Page 1
The Big Caboose Stand-On Triple Instruction Manual
ملخص المحتوى في الصفحة رقم 2
WARNINGS ! • Failure to follow these instructions could result in serious injury or death. • Never leave child unattended. • Avoid serious injury from falling or sliding out. • Always use safety belts and insure that all children are positioned according to these instructions. 3 Be certain that the stroller is fully opened, BOTH safety latches are in position, and the wheel brakes are on before allowing children near the stroller. 3 The maximum weight of the child that can be seated in each f
ملخص المحتوى في الصفحة رقم 3
Assembling and Using your Stroller To insure safe operation of your stroller, please follow these instructions carefully Unpacking the Product • Carefully remove stroller and all parts from the box and plastic bag. • Identify the parts (stroller, front wheels (2), canopy (2), tray (2), car seat carrier support (2) and documents) with the pictures in Figure 1. • Discard all packaging materials properly. • Remove the plastic coverings from all foam handles and any other areas of the product and
ملخص المحتوى في الصفحة رقم 4
Unfolding the stroller • Keep children away from stroller while unfolding. • Position the stroller with the handle bar closest to you. • Release the locking latch located on the right side by lifting the lever off of the extended rivet. See Figure 2. • Lift up slightly on the handle of the stroller. Then place one foot onto the rear platform and pull up and back on the handle until both side frame bars snap into their locking positions in the frame. CAUTION: While unfolding the stroller, be
ملخص المحتوى في الصفحة رقم 5
Figure Figure Front Wheel Locks The front wheels can be either in swivel mode or locked mode. • To put the front wheels in their locked mode, first rotate each wheel set so that the wheels are pointed straight ahead. • Pull up on the lever to engage the small tab on the lever with the slot in the plastic frame sleeve. The lever can be either facing forward or rearward to lock the wheels. See Figure 5. • To unlock the wheels and put them into swivel mode, push down on the lever to disenga
ملخص المحتوى في الصفحة رقم 6
Figure 8 Figure 9 • The canopy will ratchet forward or backward to block the sun. Pull forward on the front of the canopy frame tube to rotate it forward. Pull backward on the rear frame tube to rotate it backward. See Figure 8. • To remove the canopy, press the tab on the side of each of the male fittings while pulling upward on the canopy frame. See Figure 9. WARNING Possible pinching hazard - Be careful when closing and opening the side hinges so as not to pinch your fingers. Attaching/D
ملخص المحتوى في الصفحة رقم 7
Rear Wheel Brakes • Before placing any child into the stroller or removing them from the stroller, be certain that the rear wheel brakes are engaged. • To engage the rear wheel brakes, push down on the brake lever located on each rear wheel. See Figure 12. The stroller may require slight forward or rearward movement in order to line up the teeth on the brake with each wheel brake cluster. • Check that the brakes are properly applied by attempting to push the stroller backwards and forward
ملخص المحتوى في الصفحة رقم 8
WARNING Never allow a child to step onto the footrest in either position in order to get into or out of the stroller. This may cause the stroller to tip over and injure the child. Securing a Child into the Front Seats • Insure that the two snaps on both armrest pads that hold the seat onto the frame are securely snapped together. • Insure that both shoulder straps are attached to the waist strap buckles. See Figure 15. • Unlatch the waist/shoulder buckle by squeezing the latch releases on bo
ملخص المحتوى في الصفحة رقم 9
Figure 1 Figure 16 Figure 17 Figure 18 Seatback Positioning Each front seat has two positions. The fully upright position should only be used for a child that is at least 6 months old. • To place the seat in the upright position, push the bar on the rear of the seat toward the front of the stroller and rotate the seatback towards the front of the stroller until this bar is locked in its LOWEST position. See Figure 19. • To recline the seat, pull the bar on the rear of the seat toward the rea
ملخص المحتوى في الصفحة رقم 10
Securing a Rear Standing Child • Push the bench seat to its most forward position. • Position the canopy to its most forward position. • Position the child on the platform on the back of the stroller. Be sure that the child is facing forward and BOTH of their hands are holding the Figure 1 handles on the frame. • Position the safety strap behind the child and engage the buckle. See Figure 21. Adjust the strap so that it is snug against the child’s back. • Be sure that BOTH of the chil
ملخص المحتوى في الصفحة رقم 11
Using the Rear Bench Seat • Push the bench seat to its most rearward position. • Position the canopy to its most forward position. • Have the child sit on the bench seat facing backward with their feet on the platform. • You may need to adjust the position Figure of the seatback to allow for more room for the child to sit. • Unlatch the seat belt buckle by squeezing both prongs of each male buckle of the waist strap. • Place the crotch strap between the child’s legs. • Bring both en
