ملخص المحتوى في الصفحة رقم 1
DO NOT
DISCARD
R
3100 WOOD STOVE SERIES
Advanced Combustion Control (ACC)
Owner’s Manual
Installation and Operation
Models:
31M-ACC-MBK
31M-ACC-GT
Beaverton
Tested and
Listed by Oregon USA
31M-ACC-NT
C US
OMNI- Test Laboratories, Inc.
31ST-ACC
Step Top Uni-Body Model
Millennium Model
(Pedestal Model Shown)
CAUTION
DO NOT DISCARD THIS MANUAL
• Read, understand and • Leave this manual with
• Important operating
follow these instructions party responsible for
and maintenance
for safe installat
ملخص المحتوى في الصفحة رقم 2
R 3100 Wood Stove Series (ACC) and Welcome to the Quadra-Fire Family! Hearth & Home Technologies welcomes you to our tradi- meticulously fabricated and gold and nickel surfaces are tion of excellence! In choosing a Quadra-Fire appliance, hand-fi nished for lasting beauty and enjoyment. Our pledge you have our assurance of commitment to quality, durabil- to quality is completed as each model undergoes a quality ity, and performance. control inspection. From design, to fabrication, to ship
ملخص المحتوى في الصفحة رقم 3
R 3100 Wood Stove Series (ACC) TABLE OF CONTENTS Section 1: Listing and Code Approvals Section 8: Operating Instructions (Cont’d) A. Appliance Certifi cations ......................4 H. Blower Operating Instructions .............29 B. Mobile Home Approved ......................4 I. Opacity (Smoke) .................................29 C. Glass Specifi cations ............................4 J. Overfi ring ............................................29 D. BTU & Effi ciency Specifi cations .......
ملخص المحتوى في الصفحة رقم 4
R 3100 Wood Stove Series (ACC) Listing and Code Approvals 1 D. BTU & Effi ciency Specifi cations A. Appliance Certifi cation 3100 Millennium & Step Top (ACC) Model: EPA Certifi ed: 1.1 grams per hour Uni-Body 79.51% Effi ciency: Laboratory: OMNI Test Laboratories, Inc. 11,800 to 32,000 BTU Output: 061-S-66-6 Report No & Date: up to1,800 sq ft Heating Capacity: Wood Stove Type: Vent Size: 6 inches Standard: UL1482 and ULC S627 and (UM) 2 cubic feet Firebox Size: 84-HUD, Mobile Home Approved. 18 i
ملخص المحتوى في الصفحة رقم 5
R 3100 Wood Stove Series (ACC) Getting Started 2 B. Fire Safety A. Design, Installation & Location Considerations Consideration must be given to: To provide reasonable fi re safety, the following should be given serious consideration: • Safety • Convenience 1. Install at least one smoke detector on each fl oor of • Traffi c fl ow your home to ensure your safety. They should be • Chimney and chimney connector required located away from the heating appliance and close to the sleeping areas.
ملخص المحتوى في الصفحة رقم 6
R 3100 Wood Stove Series (ACC) C. Negative Pressure To minimize the affects of negative air pressure the following Draft is the pressure difference needed to vent appliances must be considered: successfully. Considerations for successful draft include: • Install the outside air kit. Install the intake on the • Preventing negative pressure side of the house towards prevailing winds during the • Location of appliance and chimney heating season. • Ensure adequate outdoor air is supplied
ملخص المحتوى في الصفحة رقم 7
R 3100 Wood Stove Series (ACC) F. Tools And Supplies Needed D. Flue Draft Considerations Location of the appliance and chimney will affect perfor- Before beginning the installation be sure that the following mance. As shown in Figure 6.1 on page 6 the chimney tools and building supplies are available. should: • Be installed through the warm space enclosed by the Reciprocating saw Framing Material building envelope. This helps to produce more draft, Pliers Hi-Temp Caulking Material espec
ملخص المحتوى في الصفحة رقم 8
R 3100 Wood Stove Series (ACC) Spark Arrestor Cap H. Typical Stove Systems Fireclay Flue Liner Concrete Cap With Air Space Stove system with masonry chimney consists of: Rafter • Stove Flashing • Chimney Connector (stove pipe) 1" (25mm) Clearance With Firestop • Thimble Ceiling Joist Eave • Masonry Chimney • Hearth Pad Floor Protection Combustible Wall Thimble, 12" (305mm) Of Brick Sheathing Outside Air Rear Vent Outside Air Floor Termination Cap Protector Airtight
ملخص المحتوى في الصفحة رقم 9
R 3100 Wood Stove Series (ACC) Dimensions and Clearances 3 25 in. (635mm) A. Appliance Dimensions C L 9-15/16 in. 12-1/2 in. (237mm) (318mm) NOTE: Flue Collar size is 6 inch (152mm) diameter (ID) 10-15/16 in. (271mm) 15-1/16 in. 14-15/16 in. (383mm) (373mm) 18-15/16 in. Millennium Model 30 in. (475mm) (762mm) Figure 9.1 Front View 26-11/16 in. (668mm) 24-5/16 in. (618mm) 6-11/16 in. (170mm) C L 11-1/2 in. 16 in. (406mm) (292mm) 20-3/4 in. (527mm) Figure 9.2 Side View Page 9 March 2, 2007
ملخص المحتوى في الصفحة رقم 10
R 3100 Wood Stove Series (ACC) Appliance Dimensions (Cont’d) 3100 Step Top Pedestal Model 3100 Step Top Leg Model 25 in. (635mm) C 12-1/2 in. L 9-5/16 in. (318mm) (237mm) 14-15/16 in. 19-1/16 in. (379mm) (484mm) 33-1/8 in. 10-15/16 in. 15-1/16 in. (841mm) (278mm) (383mm) 34-1/4 in. (870mm) 18 in. (457mm) 23-7/8 in. (606mm) Figure 10.1 Figure 10.3 26-11/16 in.(678mm) 6-11/16 in. (170mm) 24-5/16 in. (618mm) 3-1/2 in. 15-3/8 in. (391mm) (89mm) C 3-11/16 in. (94mm) L Back of Stove to Glass 23-3/8 i
ملخص المحتوى في الصفحة رقم 11
R 3100 Wood Stove Series (ACC) B. Clearances to Combustibles (UL and ULC) BACKWALL / SIDEWALL ALCOVE SIDE VIEW NOTE: Clearances may only be reduced by means approved by the regulatory authority having jurisdiction A B G A C D B H 90° OFF TOP * UP & OUT CEILING G G CLEARANCE CORNER INSTALLATION STOVE TO CEILING CLEARANCE E ALCOVE TOP VIEW F C E D F MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS In Inches & (Millimeters) NOTE: All "A" , "C" and "F" Dimensions are to the inside diameter
ملخص المحتوى في الصفحة رقم 12
R 3100 Wood Stove Series (ACC) Installation 4 In Canada, similar fl oor protection must be provided 18 A. Hearth Protection Requirements inches (457mm) in front and 8 inches (203mm) from the FLOOR PROTECTION: Floor protector must be non-com- sides and rear of the stove. *See exception. bustible material, extending beneath heater and to the front, *EXCEPTION: Non-combustible fl oor protections must sides and rear as indicated. The fl oor must be non-com- extend beneath the fl ue pipe when in
ملخص المحتوى في الصفحة رقم 13
R 3100 Wood Stove Series (ACC) Step-Top Uni-Body Model For the Step Top Pedestal Model In US installations, it is For the Step Top Leg Model In US installations, it is nec- necessary to install a fl oor protector of a minimum of 3/8 inch essary to install a fl oor protector of a minimum thickness of (9.5mm) thick metal clad millboard or equivalent a minimum of 1-1/4 inch (32mm) or 1/2 inch of “k” value of 0.84 thick metal 16 inches (406mm) in front of glass and 8 inches (203mm) clad millboard o
ملخص المحتوى في الصفحة رقم 14
R 3100 Wood Stove Series (ACC) B. Outside Air Kit Installation WARNING A source of air (oxygen) is necessary in order for combus- Fire Risk. tion to take place. Whatever combustion air is consumed Asphyxiation Risk. by the fi re must be replaced. Air is replaced via air leak- Do not draw outside combustion air from: age around windows and under doors. In homes that have • Wall, fl oor or ceiling cavity tightly sealed doors and windows, an outside air source is needed. An optional Outside Air
ملخص المحتوى في الصفحة رقم 15
Do not remove. R 3100 Wood Stove Series (ACC) C. Blower (Optional) CAUTION 1. Remove the 3 bolts (1/4”-20 Phillips head) on the outer skin at the bottom rear of appliance. Shock Risk. 2. Align holes in mounting fl ange of blower with bolt holes in • Do NOT remove grounding prong from plug. appliance. Blower should be positioned at bottom of rear • Plug directly into properly grounded 3 prong outer skin as shown in Figure 15.1. receptacle. • Route cord away from appliance. 3. Re-insert and
ملخص المحتوى في الصفحة رقم 16
R 3100 Wood Stove Series (ACC) Chimney Requirements 5 A. Venting Components B. Chimney Systems Chimney Connector: Prefabricated Metal Chimney It is also known as fl ue pipe or stove pipe. The chimney • Must be a 6 inch (152mm) diameter (ID) high temperature connector joins the stove to the chimney. It must be a 6 inch o chimney listed to UL 103 HT (2100 F) or ULC S629M. (152mm) minimum diameter 24 gauge mild steel black or • Must use components required by the manufacturer for 26 gauge b
ملخص المحتوى في الصفحة رقم 17
R 3100 Wood Stove Series (ACC) Thimble C L Site constructed for masonry chimney installation: ceiling Components 13.5” below ceiling to top of opening • A minimum length of 12 inches [305mm] (longer for Wall or top of opening is a min.of thicker walls) of solid insulated factory-built chimney 4.5” below min.clearance Minimum18.0” specified by connector mfg. length constructed to UL 103 Type HT 8 inch (203mm) NFPA 211 1.5 2x2 framing stud inside diameter. Chimney needs to extend a min
ملخص المحتوى في الصفحة رقم 18
R 3100 Wood Stove Series (ACC) Solid Pack Chimney with Metal Supports as a C. Installing Chimney Components Thimble (Cont’d) Chimney Connector Single wall connector or stove pipe. Min. Chimney Clearance to This must be at least 24 gauge mild steel or 26 gauge blue Wall Spacer and Min. Clearance Combustibles - 2 inch (51mm) steel. The sections must be attached to the appliance and to 2 inch (51mm) each other with the crimped (male) end pointing toward the 1 inch (25mm) Air stove. All join
ملخص المحتوى في الصفحة رقم 19
R 3100 Wood Stove Series (ACC) D. Chimney Termination Requirements NOTE: Follow manufacturers instructions for clearance, securing, • Chimney performance may vary. fl ashing and terminating the chimney. • Trees, buildings, roof lines and wind conditions affect performance. • Must have an approved and listed cap • Chimney height may need adjustment if smoking or • Must not be located where it will become plugged by overdraft occurs. snow or other material • Must terminate at least 3 feet (
ملخص المحتوى في الصفحة رقم 20
R 3100 Wood Stove Series (ACC) Mobile Home Installation 6 You must use a Quadra-Fire Outside Air Kit Part OAK-ACC and (depending on fl oor installation, SparkArestor Cap Part SRV7033-041) for installation in a mobile home. 1. An outside air inlet must be provided for combustion See Storm Collar page 14 for installation information. 2. Appliance must be secured to the mobile home structure Roof Flashing by bolting the pedestal through hearth pad and into fl oor. 3. Appliance must be groun
