Omega HPP-600 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

HPP-600
Pneumatic Hand Pump
M4673/0508
INSTRUCTIO N
SHEET
Shop online at: omega.com e-mail: info@omega.com
For latest product manuals: omegamanual.info
Volume Control
The HPP-600 pump is equipped with two knobs for fine adjustment of the system
pressure. The vent knob can be used to slowly reduce the system pressure. The
vent knob should be closed prior to pressurizing the system by turning the knob
away from the pump housing. The Vernier knob can be used to increase or
decrease the system at

ملخص المحتوى في الصفحة رقم 2

For High Pressure Operation Prior to pressurizing, back out the Vernier knob until the ring on the Vernier shaft is showing. Pump to pressurize. Turn the Vernier knob towards the pump housing and the pressure should easily be able to reach 600 psi. NOTE: The pump uses a Schrader valve instead of a needle valve. Thus, full open or closed is several turns from the end of the travel. Over-tightening does not increase the seal. Fittings The pump is equipped with 1/8" and 1/4" BSP ports. In order to