ملخص المحتوى في الصفحة رقم 1
Owner’s Manual Quantum Energy Technologies
OWNER'S MANUAL
Including Installation Instructions And Warranty Information
TO SUIT HEAT PUMP STORAGE WATER HEATER
MODELS
Compact: 150-08ACW-134
270-11AC3-134
340-11AC3-134
340-17ACW-134
Titan Split: 340TIH-134
FOR ADVICE, REPAIRS AND SERVICE
1800 644 705
Document Number: QDC0030PD-11
Date Of Revision: 01 Mar. 2008
ملخص المحتوى في الصفحة رقم 2
Owner’s Manual Quantum Energy Technologies Contents Section 1: APPLIANCE DETAILS ................................................................................................. 5 1a: Owner’s Details ...................................................................................................................... 5 1b: Installer’s Details ...........................................................
ملخص المحتوى في الصفحة رقم 3
Owner’s Manual Quantum Energy Technologies 4c: Caution When Left Operating But Unused........................................................................... 14 Section 5: SAFETY INFORMATION .......................................................................................... 14 5a: Safety Devices ...................................................................................................................... 14 5b: Important Note Regarding P
ملخص المحتوى في الصفحة رقم 4
Owner’s Manual Quantum Energy Technologies 10b.2: Second Level: Press SET+DOWN for 6 seconds.......................................................... 26 10b.3: Third Level: Press UP+DOWN for 6 seconds........................................... 26 10c: Error Codes ......................................................................................................................... 26 10d: De-Icing........................................................
ملخص المحتوى في الصفحة رقم 5
Owner’s Manual Quantum Energy Technologies Section 1: APPLIANCE DETAILS For future convenience, please fill in the following details and retain with your original invoice. 1a: Owner’s Details Surname: …………………………………… Given Name(s): ….……………………….... Address: ……………………………………………………………………………...………… Town/Suburb: ……………………………………………………………………..…………… State/Territory:……………………………… Postcode: …………………………………… Date of Purchase: .….……….……………… Purchased From: ………………………
ملخص المحتوى في الصفحة رقم 6
Owner’s Manual Quantum Energy Technologies Section 2: INTRODUCTION Quantum Energy Technologies 2a:One Of The Worlds Most Energy Efficient Methods Of Water Heating Production We thank you for your decision to purchase a Quantum Energy Technologies Heat Pump Water Heater, which will reward you with many years of low energy hot water production. QUANTUM ENERGY TECHNOLOGIES Pty Ltd designs and manufactures energy efficient Heat Pump water heaters. The simple wa
ملخص المحتوى في الصفحة رقم 7
Owner’s Manual Quantum Energy Technologies 2c: Features Of Your Quantum Water Heater 1. Fully welded steel tank with class X vitreous enamel lining for superior corrosion resistance and longer life. 2. Indirect heat transfer eliminates tank hot spots. 3. One of the most energy efficient Heat Pump systems in the world. 4. Able to save more money, especially in cold weather, than any other solar system on the market. Warranty Return Card
ملخص المحتوى في الصفحة رقم 8
Owner’s Manual Quantum Energy Technologies 3a.2: Corrosion Protection Fittings and the Shell Surface in contact with the water are to be galvanically compatible. Sealants and / or Teflon plumbing tape should be used on potentially galvanically incompatible fittings. This is to protect against possible electrolytic corrosion between the metals (where moisture penetration could occur due to incorrectly or poorly sealed fittings). 3b: Air Flow The Compact and Spl
ملخص المحتوى في الصفحة رقم 9
Owner’s Manual Quantum Energy Technologies 3f: Cold Water Connection An approved isolating valve, approved non-return valve, line strainer (optional but recommended), and union must be fitted between the supply main and the RP ¾ / 20mm socket in the water heater. All fittings must be approved by the relevant Authority (refer to Figures 1 & 2). 3g: Pressure Reducing Valve This water heater is designed for direct connection to a maximum water supply pressure of 5
ملخص المحتوى في الصفحة رقم 10
Owner’s Manual Quantum Energy Technologies 3m: Electrical Connection Quantum water heaters are designed for single-phase 220/240V A.C supply only. A certified electrician must carry out all electrical work according to the local supply authority regulations and AS3000. A 15-amp circuit breaker must be installed at the power supply for the hot water unit. A separate circuit breaker is recommended for each unit in the case of multiple installations. The power co
ملخص المحتوى في الصفحة رقم 11
Owner’s Manual Quantum Energy Technologies 3n.1: Refrigeration Tube Sizes Quantum Model Copper Tube Size - Inlet Copper Tube Size - Outlet 3 5 340 TIH-134 / Inch (9.5mm) / Inch (15.9mm) 8 8 * When the evaporator is below the tank level on the Titan model use 12.7mm(1/2”) outlet tube. 3o: Caution Regarding Drilling Metal Jacket This is extremely important and MUST be adhered to without exception! DO NOT DRILL ANY HOLES IN OUTER METAL JACKET DAMAGE TO REF
ملخص المحتوى في الصفحة رقم 12
Owner’s Manual Quantum Energy Technologies Figure 1: Installation Diagram (Compact Systems) Wall 100 mm Min Condensation Drain Orientation 500 mm if multiple Min Power Cord Compact units are being installed. 15°
ملخص المحتوى في الصفحة رقم 13
Owner’s Manual Quantum Energy Technologies Figure 2: Installation Diagram (Split Systems) Wall 100 mm Min Power Connection 200 mm i M n 35° Water Connections 32°
ملخص المحتوى في الصفحة رقم 14
Owner’s Manual Quantum Energy Technologies Section 4: OPERATING INSTRUCTIONS 4a: Filling The Water Heater Open all hot water taps. Open isolating valve at the cold-water inlet and allow the water heater to fill until water flows through the system. Close each hot water tap after the air is expelled from its line. 4b: Water Quality Your Quantum water heater has been manufactured to suit the water conditions of most Australian metropolitan supplies. Please not
ملخص المحتوى في الصفحة رقم 15
Owner’s Manual Quantum Energy Technologies 5b: Important Note Regarding PTR Valve The Pressure & Temperature relief valve should be checked for adequate performance or replaced at intervals not exceeding 5 years, or less in areas where there is a high incidence of water deposits. Providing there is some discharge from the relief valve during each heating cycle there is no requirement to manually activate the release mechanism on the relief valve. There is a pos
ملخص المحتوى في الصفحة رقم 16
Owner’s Manual Quantum Energy Technologies 6d: Service Caution – Before Any Work Is Carried Out Before any electrical components are inspected the System MUST be turned off at the power switch / hot water circuit breaker. Do not touch wiring or any electrical components without supervision or training to Australian (or equivalent) standards. 6e: Thermal Overload (Incorporated in Digital Controller) All models are fitted with a digital controller for heat pump
ملخص المحتوى في الصفحة رقم 17
Owner’s Manual Quantum Energy Technologies 6f.2: Five Year Service (By Authorized Personnel Only) The five-year service should be carried out by a licensed tradesperson every five years. It is recommended that your local Quantum distributor carry out this service. The service should include the following: - 1. Replace the Pressure & Temperature Relief valve. 2. Replace the anode. 3. Flush the water heater. 4. Checking of the refrigeration system. 5
ملخص المحتوى في الصفحة رقم 18
Owner’s Manual Quantum Energy Technologies 6f.4: Flushing Of Water Tank As with other hot water heater tanks, dissolved solids in the water or scale may accumulate in the bottom of the water tank forming sludge. This is generally less of a problem with Quantum units as no internal elements or burners are used. If such sludge build-up does occur the following procedure can be followed to clean out the tank. 1. Turn Off power to the unit. 2. Turn Off water s
ملخص المحتوى في الصفحة رقم 19
Owner’s Manual Quantum Energy Technologies Section 7: RECOGNITION OF ABNORMAL OPERATION 7a: Pressure & Temperature Relief Valve Running It is not unusual for the Pressure & Temperature Relief valve to allow a small quantity of water to escape during the heating cycle. The amount of discharge will depend on hot water usage. As a guide, if it discharges more than 20 litres of water in 24 hours then there may be a problem. 7a.1: Continuous Trickle Likely build up
ملخص المحتوى في الصفحة رقم 20
Owner’s Manual Quantum Energy Technologies 4. Replace faulty tap washers and have your plumber rectify any leaking pipe work. 5. Have any new appliances been installed that might be using the extra power? 6. If there are no water leakages around the building and no excessive usage of hot water, yet electricity bills are higher than normal (without any other appliance being responsible) then it may indicate a problem with the water heater. Contact your nearest
