Graco ROTOFLEX 309793 A دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Repair Kit
RotoFlex™ Pump
309793 A
Part No. 234156
60 psi (4.1 bar) Maximum Working Pressure
Pressure Relief Procedure
To reduce the risk of serious bodily injury, includ-
ing electric shock and splashing fluid in eyes, fol-
low this procedure whenever you stop spraying:
ti3126a
1. Shut OFF air source.
2. Disconnect power source.
3. Turn gun air valve ON.
WARNINGS
Pressurized Equipment Hazard
Fluid from gun, leaks or ruptured components can splash in the eyes or on skin and cause serious
injury

ملخص المحتوى في الصفحة رقم 2

RotoFlex Pump Repair Kit RotoFlex Pump Repair Kit Disassembly 1. Relieve Pressure, page 1. 6. Loosen bolt (A) located between air 2. Unplug sprayer from outlet. and material hose outlets. Unscrew 3. Remove shroud 6 bolt to lower plate, 5 (6 bolts). leaving about 4-5 A threads on bolt. ti3083a DO NOT REMOVE 1 BOLT COMPLETELY. 4 2 ti3025a 3 7. Slide a wood block under 4. Remove hopper by motor for sup- loosening bottom port. fitting and then lift- ing hopper straight up, off unit. t

ملخص المحتوى في الصفحة رقم 3

RotoFlex Pump Repair Kit Reassembly Reinstall RotoFlex Pump hose on plate. 3. Align dots located on hose fitting, making sure they are facing each other at all times to ensure the hose 1. Kink hose as shown, does not twist during reinstallation. DOTS making sure dots located on hose fitting face each other. ti3084a 4. Reposition plate, aligning hex fittings with enclosure openings. ti3127a 5. Remove wood block support under motor. 2. Slide hose onto plate as shown below, mak- 6. Tighten

ملخص المحتوى في الصفحة رقم 4

RotoFlex Pump Repair Kit All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. Sales Offices: Minneapolis, Detroit International Offices: Belgium, Korea, Hong Kong, Japan PRINTED IN USA 309793 1/2003 4 309793 A