ملخص المحتوى في الصفحة رقم 1
READ AND SAVE THESE INSTRUCTIONS
®
™
MIDWAY II
Model No.
54” Ceiling Fan
CF929BS 00
Owner's Manual
CF929WW 00
Net Weight: 23.8 Lbs.
LIMITED WARRANTY
What The Warranty Covers:
This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials.
You must be the original purchaser or user of the product to be covered.
What The Period Of Coverage Is:
As it applies to the motor, this warranty will last for thirty years
ملخص المحتوى في الصفحة رقم 2
! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3. Be careful of
ملخص المحتوى في الصفحة رقم 3
This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Tools Needed for Assembly Up to 50 ft. 14 One Phillips head screwdriver One stepladder 50-100 ft. 12 One 1/4” blade screwdriver One wire stripper Three wire connectors (supplied) One 3/16” hex wrench (supplied) ! WARNING Before assembly your ceiling fan, refer to section on MATERIALS proper method of wiring your fan (page 6). If you fee
ملخص المحتوى في الصفحة رقم 4
How to Put Your Ceiling Fan Together 1. Remove the hanger ball by loosening the setscrew 4. Make sure the grommet is properly installed in the in the hanger ball until the ball falls freely down the coupling cover then slide the coupler cover on the downrod (Figure 1). Remove the clevis pin from the downrod until it rests on the motor housing. Place downrod, then remove the hanger ball. Retain the the ceiling cover over the downrod. Be sure both pin and hanger ball for reinstallation in step 5.
ملخص المحتوى في الصفحة رقم 5
8. To ensure proper blade assembly, make sure the Electrical Requirements label on the blades are facing the bottom of the Your new ceiling fan will require a grounded electrical ceiling fan. Slide blade through center slot in fan supply line of 120 volts AC, 60 Hz, 15 amp circuit. housing. Mount blade to fan housing using three 3/16-24 x 1/2” slotted Phillips washer head blade The outlet box must be securely anchored and screws (Figure 5). capable of withstanding a load of at least 50 pounds.
ملخص المحتوى في الصفحة رقم 6
How to Wire Your Ceiling Fan ! WARNING To reduce the risk of fire, electric shock, or personal If you feel that you do not have enough electrical injury, mount fan to outlet box marked acceptable for wiring knowledge or experience, have your fan fan support, and use screws supplied with outlet installed by a licensed electrician. box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support 1. Your ceiling fan is supplied with an Emerson and may need to be
ملخص المحتوى في الصفحة رقم 7
Installing Glass Globe 1. Engage the connector of the ballast, in the lower BALLEST OF housing assembly, onto the fluorescent lamp plug LOWER HOUSING ASSEMBLY CONNECTOR (Figure 12). 2. Carefully push the fluorescent bulb (supplied) into FLUORESCENT LAMP PLUG the two spring clamps until the clamps secure the lamp. SPRING CLAMP 3. Place the glass bowl into the opening in the lower housing assembly, aligning the three flat areas on the top edge of the glass with the three raised dimples on the lo
ملخص المحتوى في الصفحة رقم 8
Setting Receiver Frequency Using Your Ceiling Fan 1. After electricity has been turned off at the main fuse 1.Restore electrical power to the outlet box by turning box, locate the receiver switch opening located on the electricity on at the main fuse box. top of the upper housing (Figure 13). 2. Remove the battery cover by pressing firmly on the 2. Set the position of all four levers, ON or OFF to the arrow and sliding the cover off the control same position as those on the transmitter. transmit
ملخص المحتوى في الصفحة رقم 9
! WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. 2. Loose power line connections to the fan, or loose 2. Check line wire connections to fan and switch wire switch wire connections in the switch housing. connections in the switch housing. ! WARNING: Make sure main
ملخص المحتوى في الصفحة رقم 10
Maintenance Accessories 1. Downrod Extension Kits (see store or catalog). IMPORTANT CARE INSTRUCTIONS for your Ceiling Fan Periodic cleaning of your new ceiling fan is the only ! WARNING maintenance that is needed. The use of any other control not specifically When cleaning, use only a soft brush or lint free cloth approved for this fan could result in fire, shock and to avoid scratching the finish. personal injury. Abrasive cleaning agents are not required and should be avoided to prevent damag
ملخص المحتوى في الصفحة رقم 11
Repair Parts 2 1 3 5 14 4 6 7 15 FAN/OFF HI 16 FOR/REV MED LIGHT LOW DIMMER 9 8 ® 19 13 11 10 17 18 12 11
ملخص المحتوى في الصفحة رقم 12
Repair Parts Listing Key Model No. No. Description CF929WW 00 CF929BS 00 — Hanger Ball Assembly, 761655 761655-17 Consisting of: 1 Hanger Bracket — — 2 Hanger Ball — — 3 Downrod — — — Parts Bag Containing: 762029 762029-2 4 Wire Connector (3) — — 5 Stud, Threaded, 1-1/4" (2) — — 6 Lockwashers (2) — — 7 Knob, Knurled (2) — — 8 Pin, Clevis — — 9 Clip, Hairpin — — 10 Screw, 3/16-24 x 1/2” (16) — — 11 Lower Housing Assembly 762377-1 762377 12 Glass Globe 762031 762031 13 Blade (set of 5) 762375-1 76
