Marley Engineered Products D دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Electric/Hydronic
Baseboard Heaters
(Model D)
FILE #E37116
Installation & Maintenance Instructions
Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by a division of Marley
Engineered Products. You have made a wise investment selecting the highest quality product in the heat-
ing industry. Please carefully read and follow the installation and maintenance directions shown in this
manual. You should enjoy years of efficient heating comfort with this product fro

ملخص المحتوى في الصفحة رقم 2

IMPORTANT ! CAUTION CAUTION ! ! CERTAIN FABRICS DISCOLOR IN TIME FROM INDIRECT SUNLIGHT AND HEATER MAY BE INSTALLED ABOVE THE FLOOR SUCH AS ATOP A BASE- NORMAL ROOM TEMPERATURE - MOSTLY ORGANIC AND SYNTHETIC BOARD. HOWEVER, THE POWER SUPPLY MUST ENTER THE HEATER MATERIAL. THEY WILL DISCOLOR MORE RAPIDLY WHEN EXPOSED TO THROUGH THE KNOCKOUT IN THE BACK OF THE HEATER IF INSTALLED DIRECT SUNLIGHT AND WARM CURRENTS. HANG DRAPES TO PROVIDE ABOVE THE FLOOR. MINIMUM OF 2 INCHES (51mm) AIR SPACE BETWEE

ملخص المحتوى في الصفحة رقم 3

JUNCTION BOX JUNCTION BOX END CAP POWER SUPPLY CABLE SCREW Figure 5. Routing of Power Supply Cable HEATER The following methods of mounting the heaters to common types of wall sur- Figure 3. Removal of End Cap faces are suggested: a. Plaster Walls: Use toggle or molly screw anchors. SNAP TOP OF COVER OFF THE CENTER BRACKET/ INTERMEDIATE SUPPORTS b. Wall Studs: Use #12 round head screws penetrating at least 3/4" (19mm) into stud. c. Masonry Walls: Use #12 round head screws into lead, plastic,

ملخص المحتوى في الصفحة رقم 4

another heater, it is easier for the power supply connections to be made prior 3. Allow entire system to operate steadily for 1/2-hour. For a period of time after to the installation of the heater(s) to the wall. If this is not possible, connections the heaters are put into operation, the owner may notice a “new smell” coming may be made through the opening in the junction boxes when the front cover(s) from the heaters. This is expected on new installations. Bringing heaters to full is removed.