ملخص المحتوى في الصفحة رقم 1
INSTALLATION INSTRUCTIONS
AND OWNER'S MANUAL
The White Mountain Log Collection
LOG SET FOR UNVENTED
GAS LOG HEATER
OR
VENTED DECORATIVE APPLIANCE
MODELS
LS-18P-1
LS-24P-1
LS-30P-1
EFFECTIVE DATE
JANUARY 2007
WARNING: If the information in these in-
structions are not followed exactly, a fire or
explosion may result causing property dam-
Installer: Leave this manual with the appli-
age, personal injury or loss of life.
ance.
Consumer: Retain this manual for future refer-
— Do not store or use
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS Section Page Important Installation Guidelines ......................................................................... 3 General Information ............................................................................................. 3 Log Placement ...................................................................................................4-6 LS-18P-1 Photos .................................................................................................. 7 LS-24P-1
ملخص المحتوى في الصفحة رقم 3
IMPORTANT INSTALLATION GUIDELINES Proper Log Placement WARNING: Do not allow fans to blow directly into the fireplace. Log placement is critical to proper burner performance. Logs Avoid any drafts that alter burner flame patterns. must be correctly positioned onto the burner. The photos in this WARNING: Do not use a blower insert, heat exchanger insert or manual show the proper pinned position for logs on this set. other accessory not approved for use with this heater. Owners need to be shown
ملخص المحتوى في الصفحة رقم 4
LOG PLACEMENT Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs, wash your hands gently with soap and water. All Logs The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Refer to Figure 1 for the following warning. Warning: Failure to position the parts in accordance with
ملخص المحتوى في الصفحة رقم 5
LOG PLACEMENT 8. Insert boss on upper middle right (H) log into recess on middle right (G) log and on front grate bar 9. Place recess in middle center (I) log onto boss on rear center (E) log and resting on front left (A) log. 10. Place square recess in upper middle left (J) log onto round boss on middle left (F) log and round recess in upper middle left (J) log onto boss on rear center (E) log I J H G E C F D B A Figure 3 11. Place round recess in top center (K) log onto round boss on upper mi
ملخص المحتوى في الصفحة رقم 6
LOG PLACEMENT Apply loose material (glowing embers) per appropriate Installation Instructions and Owner's Manual. Replacement of loose material (glowing embers) must be purchased from Empire Comfort Systems, Inc. Application of excess loose material (glowing embers) may adversely affect performance of the heater. WARNING: All previously applied loose material must be removed prior to reapplication. Replacement Loose Material (glowing embers) Part Number LS-18P 15999 LS-24P 15970 LS-30P 159
ملخص المحتوى في الصفحة رقم 7
EMBER PLACEMENT LS-18P-1 PHOTOS 20176-3-0107 Page 7 Photo 2 Photo 1 Some logs have been removed for clarity Do not cover any large rear ports with loose material (glowing embers). Do not cover any large front ports with loose material (glowing embers). Photo 4 Photo 3 Some logs have been removed for clarit y Some logs have been removed for clarity
ملخص المحتوى في الصفحة رقم 8
EMBER PLACEMENT LS-24P-1 PHOTOS Page 8 20176-3-0107 Photo 2 Photo 1 Some logs have been removed for clarity Do not cover any large rear ports with loose material (glowing embers) Do not cover any large front ports with loose material (glowing embers) Photo 3 Some logs have been removed for clarity Photo 4 Some logs have been removed for clarity
ملخص المحتوى في الصفحة رقم 9
EMBER PLACEMENT LS-30P-1 PHOTOS 20176-3-0107 Page 9 Photo 2 Photo 1 Some logs have been removed for clarity Do not cover any large rear ports with loose material (glowing embers) Do not cover any large rear ports with loose material (glowing embers) Photo 3 Photo 4 Some logs have been removed for clarity Some logs have been removed for clarity
ملخص المحتوى في الصفحة رقم 10
PARTS LIST & PARTS VIEW Attention: When ordering parts, it is very important that part number and description of part coincide. L K H J I M G E D C F B A Index No. Part Number Part Number Part Number LS-18P-1 LS-24P-1 LS-30P-1 Description R-8353 A R-8361 R-8368 Front Left Log B R-8775 R-8412 R-8777 Rear Left Log C R-8699 R-8699 R-8699 Rear Right Log D R-8354 R-8362 R-8369 Front Right Log E R-8355 R-8363 R-8370 Rear Center Log F R-8413 R-9020 R-8778 Middle Left Log G R-8700 R-8700 R-8700 Middle R
ملخص المحتوى في الصفحة رقم 11
HOW TO ORDER REPAIR PARTS Parts can be ordered only through your service person or dealer. For best results, the service person or dealer should order parts through the distribu- tor. Parts can be shipped directly to the service person/dealer. All parts listed in the Parts List have a Part Number. When ordering parts, first obtain the Model Number from the name plate on your equipment. Then determine the Part Number (not the Index Number) and the Description of each part from the following appro
ملخص المحتوى في الصفحة رقم 12
Empire Comfort Systems, Inc. 918 Freeburg Ave. Belleville, IL 62220 PH: 618-233-7420 or 800-851-3153 FAX: 618-233-7097 or 800-443-8648 info@empirecomfort.com www.empirecomfort.com Page 12 20176-3-0107
