Aprilaire 8334 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

>
4. After labeling wires, remove wires from terminals. 6. Mark placement of mounting holes. See Fig. 3.
14. Put the HP/NON HP switch to either the HP for Heat Pump or NON
Features
®
Set base aside.
HP for furnace applications in the proper position.
5. Remove existing thermostat base from wall.
• Single Stage heat pump compatible.
MOUNTING HOLES
6. Refer to the following section for instructions on how to
• Zone system compatible as a master thermostat.
HP/NON HP
install thermostat.
• Low bat

ملخص المحتوى في الصفحة رقم 2

> > > > > > > > > To Test Thermostat Operation Changing Fahrenheit (F) to Celsius (C) Wiring Diagrams Limited Warranty Setting or Changing the Setpoint Temperature The thermostat is preset to display the temperature in degrees The following is just a sample of the most common types of HVAC systems. ® Your Research Products Corporation Aprilaire Thermostat unit is expressly WARNING: DO NOT SHORT (JUMPER) ACROSS TERMINALS OF GAS Fahrenheit. You may change the display readout to Celsius if desired.