Honeywell HE300 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Wiring Configuration
INSTALLATION ADDENDUM
ADVANCED MODELS (HE150/HE250/HE300)
HE150 OR HE250 HE300
G OR W
G OR W
AIR PROVING AIR PROVING
OR 3 OR 3
2
2
DEVICE
DEVICE
C
C
H8908 H8908
1
30 40 30 40
20 50 POWER IN 20 50
10 60 10 60
OFF ON OFF ON
1
POWER IN
DIP SWITCH SETTING
RESET POWER AFTER
ANY DIP SWITCH CHANGES
1 HE150/HE250 USES A 15 VA TRANSFORMER WIRED INTO 24V IN. 1 HE300 USES A LINE CORD PLUG.
HE100/HE200 USES A 10 VA TRANSFORMER WIRED INTO 24V IN.
2 CONNECT G TO HUMIDIFY WHEN THERE IS

ملخص المحتوى في الصفحة رقم 2

WIRING CONFIGURATION HE150 OR HE250 HE300 POWER OUT POWER OUT G (THERMOSTAT) 24V FOR G (THERMOSTAT) 24V FOR 1 1 ELECTRONIC ELECTRONIC HUMIDISTAT HUMIDISTAT FROM FROM R R HUMIDITY HUMIDITY 2 CONTROL CONTROL G (FURNACE) G (FURNACE) POWER IN 2 POWER IN DIP SWITCH SETTING RESET POWER AFTER 1 ONLY NEEDED IF SYSTEM’S THERMOSTAT DOES NOT ISOLATE Y FROM G. 1 ONLY NEEDED IF SYSTEM’S THERMOSTAT DOES NOT ISOLATE Y FROM G. ANY DIP SWITCH CHANGES IF NEEDED, BREAK THE THERMOSTAT G TO SYSTEM G CONNECTI

ملخص المحتوى في الصفحة رقم 3

WIRING CONFIGURATION BASIC MODELS (HE100/HE200) HUMIDIFIER 1 PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED. 2 24 VAC WIRING. H8908 30 40 TRANSFORMER 20 50 10 60 L1 OFF ON POWER (HOT) 2 SUPPLY FAN CONTROL WATER L2 SOLENOID 1 LEAD WIRE FURNACE FAN M29945A MOTOR Fig. 5. Wiring H8908 with fan interlock. HUMIDIFIER 1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS H8908 REQUIRED. 2 24 VAC WIRING. 30 40 TRANSFORMER 20 50 L1 10 60 OFF ON (HOT) POWER 2 FAN CONTROL S

ملخص المحتوى في الصفحة رقم 4

WIRING CONFIGURATION H8908 HUMIDIFIER 30 40 20 50 2 10 60 OFF ON TRANSFORMER 1 L2 L1 (HOT) CURRENT WATER LO SENSING SOLENOID RELAY C HI LEAD WIRE 1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED. 2 24V WIRING. M29943A Fig. 7. Wiring H8908 with current-sensing relay. HUMIDIFIER H8908 AIR PROVING 30 40 DEVICE 20 50 10 60 OFF ON 2 TRANSFORMER WATER SOLENOID 1 LEAD WIRE L2 L1 (HOT) 1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED. 2 24