Friedrich RT6 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

To Install Thermostat
ELECTRICAL SHOCK HAZARD – Turn off power at the main service panel by removing the fuse
RT6
or switching the appropriate circuit breaker to the OFF position before removing the existing
Electronic Thermostat
thermostat.
IMPORTANT: Thermostat installation must conform to local and national building and electrical codes and
ordinances.
Note: Mount the thermostat about five feet above the floor. Do not mount the thermostat on an outside wall, in
direct sunlight, behind a

ملخص المحتوى في الصفحة رقم 2

Configuration Mode Settings Operating Modes The setup screens for Configuration Mode are as follows: There are three possible operating modes for the RT6. Of f, Heat, and Cool modes are accessed by pressing the SYS (left) button. 1. System – Set for heat pump, non-heat pump, reversing valve operation OFF Mode System Setting Reversing Valve Setting Friedrich Models • In this mode, the thermostat will not turn on the heating or cooling devices Heat Pump HP O - Energized in Cooling Note: The i