Central Pneumatic Air Compressor 93289 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
ENGINE CLEANING SPRAY GUN
Model 93289
ASSEMBLY and OPERATING
INSTRUCTIONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
TO PREVENT SERIOUS INJURY,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.
© ®
Copyright 2005 by Harbor Freight Tools . All rights reserved. No portion of
this manual or any artwork contained herein may be re

ملخص المحتوى في الصفحة رقم 2

Specifications Air Inlet 1/4”-18 NPS Working Air Pressure 40 PSI, Do not exceed 60 PSI Air Consumption 7 CFM @ 40 PSI Dimensions (with cup) 6-1/2” H x 15-1/2” L x 4-1/4” W Cup Capacity 24 Ounces Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a safe a

ملخص المحتوى في الصفحة رقم 3

9. Maintain tools with care. Keep tools clean for better and safer performance. Follow instructions for lubricating and changing accessories. Inspect tool cords and air hoses periodically and, if damaged, have them repaired by an authorized technician. The handle must be kept clean, dry, and free from oil and grease at all times. 10. Disconnect air supply. Disconnect air hose when not in use. 11. Avoid unintentional starting. Be sure the Trigger (12) is in the Off position when not in use and

ملخص المحتوى في الصفحة رقم 4

Note: Performance of the compressor (if powered by line voltage) may vary depending on variations in local line voltage. Extension cord usage may also affect tool perfor- mance. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Unpack

ملخص المحتوى في الصفحة رقم 5

Operation FIGURE 1 Lock Ring (2) Fluid Nozzle (1) Cup (16) Trigger (12) Air Inlet (14) Note: Only use noncorrosive, nonflammable cleaning products that are compatible with the materials of this tool, and viscous enough to flow easily through the Nozzle. 1. Remove (un-thread) the Cup (16) from the unit and fill it with cleaning fluid (not in- cluded). 2. Replace the Cup (16) making sure it is securely tightened to the unit. 3. Connect the air source hose to the Air Inlet (14) as described in Air

ملخص المحتوى في الصفحة رقم 6

Maintenance 1. After each use, empty the Cup (16) of any remaining cleaner. Store the fluid in its original container, or dispose of it in accordance with local hazardous waste proce- dures. Fill the Cup (16) with warm water, set the air compressor to 20 PSI, and connect to the air source hose to the Spray Gun. Point the Spray Gun into a waste bucket and run the entire Cup of warm water through the gun. If the discharged water still smells strongly of the cleaner you used, repeat the process.

ملخص المحتوى في الصفحة رقم 7

Assembly Drawing SKU 93289 For technical questions, please call 1-800-444-3353. Page 7