ملخص المحتوى في الصفحة رقم 1
OPERATING INSTRUCTIONS FOR
MODEL 3000TA
Trace Oxygen Analyzer
P/N M66316
3/09/11
DANGER
Toxic gases and or flammable liquids may be present in this monitoring
system.
Personal protective equipment may be required when servicing this
instrument.
Hazardous voltages exist on certain components internally which may persist
for a time even after the power is turned off and disconnected.
Only authorized personnel should conduct maintenance and/or servicing.
Before conducting
ملخص المحتوى في الصفحة رقم 2
3000TA- EU Copyright © 2011 Teledyne Analytical Instruments All Rights Reserved. No part of this manual may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any other language or computer language in whole or in part, in any form or by any means, whether it be electronic, mechanical, magnetic, optical, manual, or otherwise, without the prior written consent of Teledyne Analytical Instruments, 16830 Chestnut Street, City of Industry, CA 91749-15
ملخص المحتوى في الصفحة رقم 3
Trace Oxygen Analyzer Specific Model Information The instrument for which this manual was supplied may incorporate one or more options not supplied in the standard instrument. Commonly available options are listed below, with check boxes. Any that are incorporated in the instrument for which this manual is supplied are indicated by a check mark in the box. Instrument Serial Number: _______________________ Options Included in the Instrument with the Above Serial Number: 3
ملخص المحتوى في الصفحة رقم 4
3000TA- EU Important Notice Model 3000TA-EU complies with all of the requirements of the Commonwealth of Europe (CE) for Radio Frequency Interference, Electromagnetic Interference (RFI/EMI), and Low Voltage Directive (LVD). The following International Symbols are used throughout the Instruction Manual. These symbols are visual indicators of important and immediate warnings and when you must exercise CAUTION while operating the instrument. See also the Safety Information on the next
ملخص المحتوى في الصفحة رقم 5
Trace Oxygen Analyzer Safety Messages Your safety and the safety of others is very important. We have provided many important safety messages in this manual. Please read these messages carefully. A safety message alerts you to potential hazards that could hurt you or others. Each safety message is associated with a safety alert symbol. These symbols are found in the manual and inside the instrument. The definition of these symbols is described below: GENERAL WARNING/CAUTION: Re
ملخص المحتوى في الصفحة رقم 6
3000TA- EU CAUTION: THE ANALYZER SHOULD ONLY BE USED FOR THE PURPOSE AND IN THE MANNER DESCRIBED IN THIS MANUAL. IF YOU USE THE ANALYZER IN A MANNER OTHER THAN THAT FOR WHICH IT WAS INTENDED, UNPREDICTABLE BEHAVIOR COULD RESULT POSSIBLY ACCOMPANIED WITH HAZARDOUS CONSEQUENCES. This manual provides information designed to guide you through the installation, calibration and operation of your new analyzer. Please read this manual and keep it available. Occasionally, some instruments
ملخص المحتوى في الصفحة رقم 7
Trace Oxygen Analyzer This is a general purpose instrument designed for use in a nonhazardous area. It is the customer's responsibility to ensure safety especially when combustible gases are being analyzed since the potential of gas leaks always exist. The customer should ensure that the principles of operation of this equipment are well understood by the user. Misuse of this product in any manner, tampering with its components, or unauthorized substitution of any component
ملخص المحتوى في الصفحة رقم 8
3000TA- EU Table of Contents Safety Messages ........................................................................... v Introduction ................................................................................... 1 1.1 Overview 1 1.2 Typical Applications 1 1.3 Main Features of the Analyzer 1 1.4 Model Designations 2 1.5 Front Panel (Operator Interface) 3 1.6 Recognizing Difference Between LCD & VFD 4 1.7 Rear Panel (Equipment Interface) 5 Operational Theory ...............
ملخص المحتوى في الصفحة رقم 9
Trace Oxygen Analyzer 3.4 Installing the Micro-Fuel Cell 29 3.5 Testing the System 29 Operation ..................................................................................... 31 4.1 Introduction 31 4.2 Using the Data Entry and Function Buttons 31 4.3 The System Function 33 4.3.1 Tracking Oxygen Readings During Calibration and Alarm Delay 34 4.3.2 Setting up an Auto-Cal 36 4.3.3 Password Protection 37 4.3.3.1 Entering the Password 37 4.3.3.2 Installing or Changing the Pa
ملخص المحتوى في الصفحة رقم 10
3000TA- EU 5.2.2 When to Replace a Cell 58 5.2.3 Removing the Micro-Fuel Cell 58 5.2.4 Installing a New Micro-Fuel Cell 59 5.2.5 Cell Warranty 61 5.3 Fuse Replacement 61 5.4 System Self Diagnostic Test 62 5.5 Major Internal Components 63 5.6 Cleaning 64 5.7 Troubleshooting 64 Appendix ...................................................................................... 67 A-1 Model 3000TA Specifications 67 A-2 Recommended 2-Year Spare Parts List 68 A-3 Drawing List 70 A-4 19-in
ملخص المحتوى في الصفحة رقم 11
Trace Oxygen Analyzer List of Figures Figure 1-1: Model 3000TA Front Panel ........................................... 3 Figure 1-2: Model 3000 TA Rear Panel ........................................... 5 Figure 2-1: Micro-Fuel Cell .............................................................. 8 Figure 2-2. Cross Section of a Micro-Fuel Cell (not to scale) .......... 8 Figure 2-3. Characteristic Input/Output Curve for a Micro-Fuel Cell ............................................
ملخص المحتوى في الصفحة رقم 12
3000TA- EU List of Tables Table 3-1: Analog Output Connections Pin Function .................... 23 Table 3-2: Alarm Relay Contact Pins ............................................ 24 Table 3-3: Remote Calibration Connections .................................. 25 Table 3-4: Range ID Relay Connections ....................................... 26 Table 3-5: Commands via RS-232 Input ....................................... 28 Table 5-1: Self Test Failure Codes ............................
ملخص المحتوى في الصفحة رقم 13
Trace Oxygen Analyzer Introduction Introduction 1.1 Overview The Teledyne Analytical Instruments Model 3000TA Trace Oxygen Analyzer is a versatile microprocessor-based instrument for detecting oxygen at the parts-per-million (ppm) level in a variety of gases. This manual covers the Model 3000TA General Purpose flush- panel and/or rack-mount units only. These units are for indoor use in a nonhazardous environment. 1.2 Typical Applications A few typical applications of the Model 3000TA ar
ملخص المحتوى في الصفحة رقم 14
Introduction 3000TA- EU Advanced Micro-Fuel Cell, designed for trace analysis, has a one year warranty and an expected lifetime of two years. Versatile analysis over a wide range of applications. Microprocessor based electronics: 8-bit CMOS microprocessor with 32 kB RAM and 128 kB ROM. Three user definable output ranges (from 0-10 ppm through 0- 250,000 ppm) allow best match to users process and equipment. Air-calibration range for convenient spanning at 20.9 %. Auto Ran
ملخص المحتوى في الصفحة رقم 15
Trace Oxygen Analyzer Introduction 1.5 Front Panel (Operator Interface) The standard 3000TA is housed in a rugged metal case with all controls and displays accessible from the front panel. See Figure 1-1. The front panel has thirteen buttons for operating the analyzer, a digital meter, an alphanumeric display, and a window for viewing the sample flowmeter. Figure 1-1: Model 3000TA Front Panel Function Keys: Six touch-sensitive membrane switches are used to change the specific function
ملخص المحتوى في الصفحة رقم 16
Introduction 3000TA- EU Left & Right Arrows Select between functions currently displayed on the VFD screen. Up & Down Arrows Increment or decrement values of functions currently displayed. Enter Moves VFD display on to the next screen in a series. If none remains, returns to the Analyze screen. Escape Moves VFD display back to the previous screen in a series. If none remains, returns to the Analyze screen. Digital Meter Display: The meter display is a LED device that produce
ملخص المحتوى في الصفحة رقم 17
Trace Oxygen Analyzer Introduction 1.7 Rear Panel (Equipment Interface) The rear panel, shown in Figure 1-2, contains the gas and electrical connectors for external inlets and outlets. Those that are optional are shown shaded in the figure. The connectors are described briefly here and in detail in the Installation chapter of this manual. Figure 1-2: Model 3000 TA Rear Panel Power Connection Universal AC power source. Gas Inlet and Outlet One inlet (must be externally valved)
ملخص المحتوى في الصفحة رقم 18
Introduction 3000TA- EU Remote Span/Zero Digital inputs allow external control of analyzer calibration. Calibration Contact To notify external equipment that instrument is being calibrated and readings are not monitoring sample. Range ID Contacts Four separate, dedicated, range relay contacts. Low, Medium, High, Cal. Network I/O Serial digital communications for local network access. For future expansion. Not implemented at this printing. Optional: Calibration Gas Ports
ملخص المحتوى في الصفحة رقم 19
Trace Oxygen Analyzer Operational Theory Operational Theory 2.1 Introduction The analyzer is composed of three subsystems: 1. Micro-Fuel Cell Sensor 2. Sample System 3. Electronic Signal Processing, Display and Control The sample system is designed to accept the sample gas and transport it through the analyzer without contaminating or altering the sample prior to analysis. The Micro-Fuel Cell is an electrochemical galvanic device that translates the amount of oxygen present in the s
ملخص المحتوى في الصفحة رقم 20
Operational Theory 3000TA- EU 2.2.2 Anatomy of a Micro-Fuel Cell The Micro-Fuel Cell is a cylinder only 11/4 inches in diameter and 11/4 inches thick. It is made of an extremely inert plastic, which can be placed confidently in practically any environment or sample stream. It is effectively sealed, although one end is permeable to oxygen in the sample gas. The other end of the cell is a contact plate consisting of two concentric foil rings. The rings mate with spring-loaded contacts in
