Aprilaire 70 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

LivingSpaceControl
Model70LivingSpaceControl
InstallationManual
®
ForusewithAprilaire CentralDehumidifier
Models1700,1720,1710,1750,1770,1710A,1750A,1770A
WARNING
120voltsmaycauseseriousinjuryfromelectricalshock.Disconnectelectricalpowerto
thefurnace&airconditionerbeforestartinginstallation.ThisLivingSpaceControlisnot
a120volt(linevoltage)device.
Improperinstallationmaycauseseriousinjuryfromelectricalshock.Thisproductmust
beinstalledbyaqualifiedheating&airconditioningcontractorinaccordancewithNE

ملخص المحتوى في الصفحة رقم 2

SPECIFICATIONS Low Dew Point Control Level (“MORE DRY” or 7 bars on display) 40°F High Dew Point Control Level (“LESS DRY” or 1 bar on display) 65°F Temperature Sensor Range 40°F to 100°F Relative Humidity Sensor Range 30% to 100% Temperature Storage Conditions -30°F to 120°F Relative Humidity Storage Conditions 0 to 100% Supply Voltage (DC from Central Dehumidifier Control Board) 12 VDC LIVINGSPACECONTROLINSTALLATIONINSTRUCTIONS STEP1.CHOOSEALOCATIONTOMOUNTTHECONTROL The Model 70 Living Space C

ملخص المحتوى في الصفحة رقم 3

A B + – REMOTECONTROL REMAOTBEC+ON–TROL STEP3.MOUNTTHECONTROLONTHEWALL There are two mounting screws and two drywall anchors provided with the control. SeeFigure2. 1. Route wires through square hole in Figure2– MounttheControl backing plate. Level backing plate against wall and mark two of the mounting holes. 2. Drill two 3/16” diameter holes at the marked locations and install drywall ANCHOR anchors (included). Drywall anchors should be used unless installing on paneling or other hard surfaces.

ملخص المحتوى في الصفحة رقم 4

4. Slide excess cable back into the wire entry Figure4– IntegratedSensorControlBoard wall opening and fill the hole with insulation. Failure to seal the hole can cause drafts to enter the control and effect humidity (moisture SYSTEM SETUP level) sensing accuracy. OFF ON MODEL70 MODEL70 5a. IfconnectingtoaCentralDehumidifier withIntegratedSensorControlBoard (Figure4): Ensure that Switch 1 in the “SYSTEM SETUP” block on the Integrated Sensor Control Board has been set to “MODEL 70 ON”. 90-1489 5b.