Life Fitness Exercise Bike Lifecycle 8500 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

LIFE FITNESS EXERCISE BIKE
INSTALLATION INSTRUCTIONS

ملخص المحتوى في الصفحة رقم 2

IMPORTANT SAFETY INSTRUCTIONS! ⇒ DO NOT locate the Lifecycle 8500 exercise bike outdoors, near swimming pools, or in areas of high humidity. ⇒ DO NOT operate your Lifecycle 8500 bike if it has been dropped, damaged, or even partially immersed in water. Contact Life Fitness Customer Support Services at the number on the back page of this Installation Instruction Guide. ⇒ DO NOT locate the Lifecycle 8500 bike any closer than 30 inches ( 76 cm ) to a television set. ⇒ DO NOT locate addition

ملخص المحتوى في الصفحة رقم 3

TOOLS REQUIRED FOR ASSEMBLY... Phillips screwdriver, 1/2” wrench PARTS DESCRIPTION STABILIZER/HANDLEBAR BOLT Qty: 5 CONSOLE SCREW Qty: 4 1 2 0017-00101-1043 0017-00101-0932 SEAT ASSEMBLY Qty: 1 COLLAR Qty: 1 3 4 AK18-00127-0002 0K18-01156-0001 HANDLEBAR ASSEMBLY Qty: 1 DISPLAY CONSOLE ASSEMBLY Qty: 1 5 6 AK18-00168-0000 AK17-00206-0001 STABILIZER BAR Qty: 1 9V ALKALINE BATTERY Qty: 1 7 8 AK18-0070-0000 0017-00003-0757

ملخص المحتوى في الصفحة رقم 4

ملخص المحتوى في الصفحة رقم 5

Step 1 Before proceeding, familiarize yourself with the parts of the Lifecycle 8500 exercise bike and make sure that you have received all the items described in the Parts List. Step 2 Remove the STABILIZER BAR (#7) from the carton base. Use the empty CONSOLE CARTON (A) to raise the rear of the Lifecycle bike as shown. Remove the two BOLTS (#1) from the bottom of the SHIPPING STABILIZER (B), save the BOLTS and store the SHIPPING STABILIZER with the other shipping containers. Step 3 Use the same

ملخص المحتوى في الصفحة رقم 6

Step 7 Slide the COLLAR (#4) down until it completely covers the HANDLEBAR ASSEMBLY HARDWARE and the HANDLEBAR POST (D). Secure the COLLAR by squeezing the sides and pushing firmly downward. Step 8 There is a large hole in the rear of the DISPLAY CONSOLE (#6) through which you can see a 16-PIN CONNECTOR (16P) and a 3-PIN CONNECTOR (3P). These correspond to the respective CONNECTORS on the WIRE HARNESS protruding from the top of the HANDLEBAR. Properly align the locking tabs of the 16-PIN CONNECT

ملخص المحتوى في الصفحة رقم 7

Step 11 After placing the Lifecycle bike in the intended location for use, check the stability of the bike. If the bike is not stable, rotate the FOOT (G) in the STABILIZER BAR (#7) that appears to be higher until the Lifecycle bike is stable. Secure the position of the FOOT by tightening the LOCKNUT with an open- end wrench. PRE-OPERATION CHECKLIST 4 Insure that the STABILIZER BAR and HANDLEBAR BOLTS are tight. 4 Make sure the exercise bike is properly leveled and stable. Before attempting t