ملخص المحتوى في الصفحة رقم 1
JENN-AIR SIDE-BY-SIDE REFRIGERATOR
TABLE OF CONTENTS
Important Safety Instructions ........................................ 1-2
Installation ............................................................................. 3-7
Temperature Controls ............................................................ 8
Fresh Food Features ....................................................... 9-11
Freezer Features ................................................................... 12
Ice and Water ..........
ملخص المحتوى في الصفحة رقم 2
This appliance is equipped with a three-prong grounding plug for your protection against possible electrical shock hazards. It must be plugged into a grounding receptacle. Where a standard two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to have it What You Need to Know About replaced with a properly grounded three-prong wall receptacle. Do not under any circumstances, cut or Safety Instructions remove the third (ground) prong from the po
ملخص المحتوى في الصفحة رقم 3
SAVE TH ESE I NSTRUCTIONS
ملخص المحتوى في الصفحة رقم 4
Location Door and Hinge Removal • Do not install refrigerator near oven, radiator or other Some installations require door removal to get heat source. If not possible, shield refrigerator with refrigerator to final location. cabinet material. • Do not install where temperature falls below 55° F (13° C) or rises above 110° F (43° C). Malfunction may occur at this temperature. • Refrigerator is designed for indoor household application only. Measuring the Opening When installing your refrigerator,
ملخص المحتوى في الصفحة رقم 5
. If tube end is damaged, cut off %" before Connecting the Water Supply reconnecting. (select models) If leaking occurs, reconnect the line. 3. Close door& 4. Remove top hinge covers by removing Phillips screws. 5. Unscrew 5 J_;,, hex head screws from top hinges. 6, For ice and water ..... dispensing models onmy: Detach main wire connector harness. Do not remove screw connecting green ground w ire, , To detach main wire harness, use a fiat blade tool or fingernail to press junction point between
ملخص المحتوى في الصفحة رقم 6
Materials Needed Handme installation If not installed, the handle is located in the interior or • Y4"outer diameter flexible copper tubing attached to the back of your refrigerator. Remove and • Shut-off valve (requires a '/#' hole to be drilled into discard handle packaging and tape. water supply line before valve attachment} • Adjustable wrench Handle design varies from refrigerator to refrigerator. • '/4" hex nut driver Please reference the appropriate instructions for your model. Note Front
ملخص المحتوى في الصفحة رقم 7
Align notches on back of handle 6. Align bottom of handle with lower with retaining clips on doors. door tab. Press upper handle end to door surface and firmly grasp lower Insert clips into notches and slide handle down until it end of handle. Gently slide handle contacts bottom trim. upward until bottom of handle settles on door surface, then reverse Replace top door trim and Phillips direction, sliding downward to almost screws. engaging tab with clip. Repeat instructions 1-3 to install 7. Gra
ملخص المحتوى في الصفحة رقم 8
. Turn both rear adjustment screws (B) clockwise to raise and counterclockwise to lower the rear of the refrigerator. . Using the carpenter's level, make sure front of refrigerator is '/4" (6 ram) or '/2bubble higher than back of refrigerator and that the refrigerator is level To enhance the appearance and maintain performance from side to side. the refrigerator should be level. . If required, correct rocking of refrigerator by Note turning rear adjustment screw clockwise to raise rocking corner
ملخص المحتوى في الصفحة رقم 9
Adjusting the Controls Touch Temperature Controls 24 hours after adding food, you may decide that one The controls are located at the top front of the or both compartments should be colder or warmer. If refrigerator compartment. so, adjust the control(s) as indicated in the Controm Temperature Control Guide table below. See page 19 for instructions on checking compartment temperature. • Except when starting the refrigerator, do not change either control more than one number at a time. • Allow 24
ملخص المحتوى في الصفحة رقم 10
To Slide Out Elevator TM Shelf: • Grasp the front of the shelf and pull forward. • Push the shelf in to return to original position. To Adjust the Elevator TM Shelf: • Pull out the knob on the crank handle. • Rotate the crank clockwise to raise the shelf, and counterclockwise to lower the height of the shelf. To Remove Elevator TM Shelf: • Completely unload the shelf and pull the shelf forward. • Pull until the shelf stops. • Press up on the tabs located underneath its outside Your refrigerator
ملخص المحتوى في الصفحة رقم 11
Dairy Center Door Storage The Dairy Center provides convenient ChillKeeper TM door storage for spreadaNe items such (select models) as butter and margarine. On select models, this compartment can be The ChillKeeper TM keeps beverages moved to several different locations to and other items colder than the rest accommodate storage needs. of the fresh food compartment. An air inlet directs air from the freezer into To Remove: the chiller. • Slide dairy center up and pull out. Controls To UnstaH: Th
ملخص المحتوى في الصفحة رقم 12
Temperat_ re-Controlled Drawer Storage Drawers This drawer can be used for storage of Humidity-Controlled Crisper Drawers meats, deli or other miscellaneous items. The Crisper Drawers provide a higher humidity environment for fresh fruit and vegetable storage. The drawer features a control that Controls adjusts the amount of cold air allowed into the drawer. Set the control to Cheese to provide a normal The crisper controls regulate the amount of humidity in refrigerator temperature. Set the con
ملخص المحتوى في الصفحة رقم 13
FREEZER FEATURES To UnstaH: Shelves and gaskets Slide bin into railing below ice maker until bin locks Fixed Freezer Shelf into place. Drop ice maker arm to activate ice maker. UMPORTANT: Ice bin must be locked in place for proper ice dispensing. Turn auger driver behind bin counterclockwise (as shown) to properly align ice bin with auger driver. mounting holes. To Install Clip-mounted Shelves: Place left side of shelf in mounting holes and press down into wall mounting clips. Shelves Door Stora
ملخص المحتوى في الصفحة رقم 14
C Certain sounds may accompany the various cycles of Automatic ice Maker the ice maker. The motor may have a slight hum, the (select modds) cubes will rattle as they fall into an empty storage pan and the water valve may click or "buzz" occasionally. Energy rating guides that are posted on the If the ice is not used frequently, the ice cubes will refrigerator at the time of purchase do not include become cloudy, shrink, stick together and taste stale. optional ice maker energy usage. Empty the i
ملخص المحتوى في الصفحة رقم 15
I CE AN D WATE R Dispenser Features Water Dispenser Operation (select models) DISPENSER Note • During initial use of water dispenser, there will be Dispenser Light (select models) a one- to two-minute delay while water tank fills before water dispenses. Discard first 10-14 glasses A light activates within the dispenser area at full power of water after initially connecting refrigerator to when dispensing ice or water with the main dispenser household water supply and after extended pad. periods
ملخص المحتوى في الصفحة رقم 16
Auto Light (select models] Dispenser Contro_ (sdect modds) (contro_ features vary by model) The Auto Light function activates the dispenser light at half-power when the Light Sensor ice Dispenser Operation detects that the light levels in room are low. To Dispense Ice and Water: To Activate Auto Light: . Select Water, Crush or Cube mode by pushing , Press Auto Light button. A green indicator light above button ilhminates when the sensor is active. button on dispenser control panel. A green light
ملخص المحتوى في الصفحة رقم 17
i Water FimterRe ova and Replacing Water Filter installation (select mode s) IMPORTANT: Air trapped in system may cause water and cartridge to eject. Use caution when removing. 1. Turn filter counterclockwise until it releases from filter head. 2. Drain water from filter into sink, and dispose in normal household trash. 3. Wipe up excess water in filter cover and continue with Initial Installation, steps 2 through 4. The filter should be changed at least every 12 months. IMPORTANT: Condition of
ملخص المحتوى في الصفحة رقم 18
System Specification and Performance Data Sheet Refrigerator Water FHter Cartridge Mode U KF8001A×× Specifications Service Flow Rate (Maximum] ............................................. 0.78 GPM (2.9 L/mini Rated Service Life UKF8001AXX-750 (Maximum] ......750 gallons!2838 liters Maximum Operating Temperature ..................................... 100° F/38 ° C 1000 Apollo Road Minimum Pressure Requirement ........................................ 35 psi!241 kPA Eagan, Minnesota 55121-2240 Mini
ملخص المحتوى في الصفحة رقم 19
State of California Department of Health Services Water Treatment Device Certificate Number 03- 1583 Date Issued: September 16, 2003 Date Revised: April 22. 2004 Trademark/Model Designation Replacement Elements UKF8001AXX750 UKF8001AXX 46 9006 469006-750 67003523-750 67003523 Manufacturer: PentaPure Inc. The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section 116830 of the Health and Safety Code _ for the following health related contaminant
ملخص المحتوى في الصفحة رقم 20
Fresh Food Storage Frozen Food Storage , The fresh food compartment of a refrigerator should , The freezer compartment of a refrigerator should be be kept between 3/4°-40 ° F (1°-4 ° C] with an kept at approximately 0° F (-18 ° C]. To check the optimum temperature of 37° F (3° C]. To check the temperature, place an appliance thermometer temperature, place an appliance thermometer in a between the frozen packages and check after 24 glass of water and place in the center of the hours. If the tempe
