ملخص المحتوى في الصفحة رقم 1
CD PLAYER
DPF-1010
DPF-2010
DPF-3010
INSTRUCTION MANUAL
KENWOOD CORPORATION
COMPACT
DIGITAL AUDIO
B60-3730-08 00 KO ( T, M, X ) OC
99/12 11 10 9 8 7 6 5 4 3 2 1 98/12 11 10 9 8 7 6 5 4 3
ملخص المحتوى في الصفحة رقم 2
Introduction DPF-3010/2010/1010 (En) Caution : Read this section carefully to ensure safe operation. Before applying power 2 Units are designed for operation as follows. Australia ..................................................................................AC 240 V only *Other countries ............................ AC 110-120 / 220-240 V switchable Europe and U.K. .....................................................................AC 230 V only *AC voltage selection AC voltage selector swi
ملخص المحتوى في الصفحة رقم 3
DPF-3010/2010/1010 (En) Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee (the person or company receiving the unit) can file a claim against the carrier for 3 shipping damage. We recommend that you r
ملخص المحتوى في الصفحة رقم 4
Caution : Read this page carefully to ensure IMPORTANT SAFEGUARDS safe operation. DPF-3010/2010/1010 (En) Please read all of the safety and operating instructions 6. Temperature – The appliance may not function before operating this appliance. Adhere to all warnings on properly if used at extremely low, or freezing 4 the appliance and in the instruction manual. Follow all the temperatures. The ideal ambient temperature is safety and operating instructions. These safety and above +5°C (41°F). op
ملخص المحتوى في الصفحة رقم 5
Caution : Read this page carefully to ensure safe operation. DPF-3010/2010/1010 (En) 13.Lightning – For added protection for this appliance during 18.Power lines – An outside antenna system should not be a lightning storm, or when it is left unattended and unused located in the vicinity of overhead power lines or other 5 for long periods of time, unplug it from the wall outlet and electric light or power circuits, or where it can fall into such disconnect the antenna or cable system. This will p
ملخص المحتوى في الصفحة رقم 6
System connections DPF-3010/2010/1010 (En) Malfunction of microcomputer Caution: If operation is not possible or erroneous display appears even Do not plug in the power lead until all connections are com- though all connections have been made properly, reset the 6 pleted. microcomputer referring to “In case of difficulty”. ª Make connections as shown below. When connecting the related system components, refer also to the instruction manuals of the related components. Caution regarding placement
ملخص المحتوى في الصفحة رقم 7
DPF-3010/2010/1010 (En) 7 Connection to a general-use amplifier Use the provided audio cords to connect the OUTPUT jacks of this unit to the CD input jacks (or AUX jacks) of the amplifier. Connection to digital amplifier or MD (only for DPF-3010/2010) Connect the DIGITAL OUTPUT (OPTICAL) jack to the digital input jack of the amplifier, DAT recorder, MD recorder, etc., using an optical fiber cable which are commercially available in audio stores. ÖWhen using an optical fiber cable to connect this
ملخص المحتوى في الصفحة رقم 8
DPF-3010/2010/1010 (En) 8 SYSTEM CONTROL SYSTEM CONTROL CONNECTIONS Connecting system control cords after connecting a KENWOOD audio component system lets you take advantage of convenient system control operations. SYSTEM There are two KENWOOD system control modes. Make connec- CONTROL tions according to the groups of terminal symbols shown below. [XS8] Mode : lets you combine F, f, and Ä terminals [SL16] Mode : for terminals only SYSTEM CONTROL This unit is compatible with both [XS8] and [S
ملخص المحتوى في الصفحة رقم 9
Maintenance DPF-3010/2010/1010 (En) Disc handling precautions 9 Cleaning Handling If fingerprints or foreign matter become Hold compact discs so that you do not attached to the disc, lightly wipe the touch the playing surface. disc with a soft cotton cloth (or similar) from the center of the disc outwards, in a radial manner. Label side ÖDo not attach paper or tape to either Playing the playing side or the label side of side Sticker compact discs. Ö The paste left on the label surface after Stor
ملخص المحتوى في الصفحة رقم 10
Controls and indicators DPF-3010/2010/1010 (En) 10 REPEAT indicator CCRS indicator Program SINGLE TIME indicator check indicator EDIT indicator TOTAL TIME indicator REPEAT CCRS TRACK 1 2 3 4 5 TRACK EDIT SINGLE TIME TRACK mode indicator NO. TOTAL TIME P.C. 6 7 8 9 10 PGM Program mode indicator 11 12 13 14 15 _ 16 17 18 19 20 88 88 :88 TIME indicator, Pause indicator program No. Play track No. indicator Play indicator Music calender Output level indicator The figure shows an example DISPLAY
ملخص المحتوى في الصفحة رقم 11
(DPF-3010/DPF-2010 only) Operation of remote control unit DPF-3010/2010/1010 (En) The keys with the same name as those on the main unit operate the same way as the main unit. The keys marked * are provided only on the remote control unit. 11 1 Program-related and other keys *2 OUTPUT (DOWN, UP) key 7 DISC SELECTOR DISC SELECTOR RANDOM 1 2 3 RANDOM key ) 3 Numeric keys ( 1 1 1 ~ ) ) ) , 0 0 0 ) # REPEAT key ^ 1 1 ) ) 0 0 REPEAT 4 5 DISC SKIP DISC SKIP P.MODE key $ 1 P.MODE 12 3 TIME DISPLAY key
ملخص المحتوى في الصفحة رقم 12
76 4 ¢ 1Á Normal play (TRACK mode) DPF-3010/2010/1010 (En) Use the following procedure to play a CD in the original order of tracks from track No. 1. The figure shows an example for the DPF-3010 12 76 4 ¢
1Á
: Keys and control used in the operations described on this page. Playing tracks in order from track No. 1 Press the ON/STANDBY switch to ON. 1 ON/STANDBY Ö Playback starts when a disc has been loaded. Load a disc. 2 1Open the tray. 0 2Place a disc. Ö Do not touch the played side of disc
ملخص المحتوى في الصفحة رقم 13
DPF-3010/2010/1010 (En) Playback from desired track Press the numeric keys as shown below.... 13 1 2 3 To enter track No. 23 : 003 4 5 6 To enter track No. 40 : 0000) 7 8 9 ÖPlayback starts from the selected track and continues on the subse- 0 +10 quent tracks. Skipping tracks To skip To skip 4¢
backward forward Ö The track in the direction of the pressed key is skipped, and the selected track will be played from the beginning. ÖWhen the 4 key is pressed once during playback, the track being p
ملخص المحتوى في الصفحة رقم 14
Programmed play (PGM mode) DPF-3010/2010/1010 (En) Use the following procedure to program desired tracks in a desired order. (up to 20 tracks) The figure shows an example for the DPF-3010 14 Preparation Ö Load a disc in the CD player. @ 76 4 ¢
1Á
: Keys and control used in the operations described on this page. Press so that the “PGM” indicator lights. 1 Lights up. Do this operation in the stop mode. P.MODE TRACK NO. PGM 01 Program desired tracks. 2 1 Select the desired track No. Press the nu
ملخص المحتوى في الصفحة رقم 15
DPF-3010/2010/1010 (En) Auto space function During programming of tracks, a non-recorded space of a few seconds will be automatically created between tracks. By recording 15 tracks with these spaces on tape, the search and repeat play operations of tape using the DPSS function (which works by searching the non-recorded spaces) can be performed reliably. Ö Even when the performances of two tracks are continuous (which occurs with classical or live recording music), the spaces will be created i
ملخص المحتوى في الصفحة رقم 16
Repeated playback DPF-3010/2010/1010 (En) Preparation Ö Load a disc in the CD player. @ The figure shows an example for the DPF-3010 16 ª 76 4 ¢
1Á
: Keys and control used in the operations described on this page. To repeat only the programmed tracks Press so that the "PGM" indicator lights. 1 Lights up. P.MODE TRACK NO. PGM 01 Do this operation in the stop mode. 2 Select the desired track No. Press the numeric keys as shown below... ÖAll of the programmed tracks will be repeated. 005 Ö In c
ملخص المحتوى في الصفحة رقم 17
DPF-3010/2010/1010 (En) The figure shows an example for the DPF-3010 17 76 4 ¢
1Á
: Keys and control used in the operations described on this page. To repeat the entire disc 1 Press so that the “TRACK” indicator Lights up. lights. TRACK TRACK NO. P.MODE 01 Switch REPEAT ON. 2 Lights up. REPEAT TRACK TRACK REPEAT NO. 01 3 Start playback. PLAY/PAUSE 6 To cancel repeated playback Goes off. Press the REPEAT key again. REPEAT TRACK TRACK REPEAT NO. 01
ملخص المحتوى في الصفحة رقم 18
Editing DPF-3010/2010/1010 (En) The following procedure allows to record a CD within the specified tape length so that no music is interrupted in the middle at the ends of sides A and B. The figure shows an example for the DPF-3010 18 Preparation Ö Load a disc in the CD player. @ 76 4 ¢
1Á
: Keys and control used in the operations described on this page. Light the “EDIT” indicator. 1 Do this operation in the stop mode. Lights up. Lights up. EDIT EDIT PGM Go to step 2 within 5 seconds. C_ __ I
ملخص المحتوى في الصفحة رقم 19
DPF-3010/2010/1010 (En) The figure shows an example for the DPF-3010 19 76 4 ¢
1Á
: Keys and control used in the operations described on this page. To check the edited contents Lights up. A 5 EDIT CHECK P.C. FI LE Ö When the CHECK key is pressed, track numbers and remaining time in the file A are displayed first, then those in the file B. Ö The "P.C." indicator goes off in a few seconds. To clear the edited contents Press any one of these keys. CLEAR P.MODE 0 ÖThe edited data is cleared entir
ملخص المحتوى في الصفحة رقم 20
Playback in a random order (Random playback) DPF-3010/2010/1010 (En) As tracks are selected at random, you can enjoy listening to for a long time. The figure shows an example for the DPF-3010 20 Preparation Ö Load a disc in the CD player. @ ª 76 4 ¢
1Á
: Keys and control used in the operations described on this page. Press the P.MODE key so that the "TRACK" 1 indicator lights. If the "PGM" indicator is lit, press the Lights up. P.MODE key. TRACK 1 2 3 4 5 TRACK SINGLE TIME NO. 6 7 8 9 10 P
