Manitowoc Ice Q-SERIES Q-0600 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Q-0600 Compressor Replacement
Installation Instructions


NOTE: THIS REPLACEMENT IS ONLY FOR THE Q-SERIES MACHINES. NO CHANGES WITH
START/RUN COMPONENTS ARE NEEDED.

1. Disconnect power to the ice machine at the electrical 8. Remove extra section of suction service valve
disconnect (moving the toggle switch to the off process tube from the ice machine at swedge joint.
position will not disconnect line voltage). Repeat thi

ملخص المحتوى في الصفحة رقم 2

10. Fit tubing provided into the proper place, as shown. 11. Place armaflex insulation provided in kit on suction Make sure that the discharge line ends up on the line, as shown in picture below. Slide insulation up inside of the suction line. Cut ice machine suction tubing and secure while brazing. line to fit new tubing. Deburr suction line before 12. Braze all tubing into place. Purge system with fitting new tubing in. nitrogen during all brazing operations on the ice machine. 13. U

ملخص المحتوى في الصفحة رقم 3

21. Reinstall all other panels. 22. Reconnect power and test run ice machine. 8006173 Sheet 3 of 3 06/25/01