Manitowoc Ice J-0600 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

J/B/G-0600 COMPRESSOR REPLACEMENT
Installation Instructions

NOTE: THIS REPLACEMENT IS ONLY FOR THE J, B, AND G-SERIES ICE MACHINES. START AND RUN
COMPONENT CHANGES VARY WITH THE TYPE OF MACHINE. FOR J-SERIES MACHINES ONLY, THE
RUN CAPACITOR NEEDS TO BE REPLACED WITH THE ONE INCLUDED IN THE KIT. B AND G-SERIES
MACHINES NEED ALL OF THE START AND RUN COMPONENTS REPLACED WITH THE ONES
INCLUDED IN THE KIT.

1. Dis

ملخص المحتوى في الصفحة رقم 2

9. Fit tubing provided into the proper place, as shown. Cut ice machine suction line to fit new tubing. Deburr suction line before fitting new tubing in. 11. Braze all tubing into place. Purge system with nitrogen during all brazing operations on the ice machine. NOTE: IF REPLACING COMPRESSOR INTO A 12. Use electrical tape to seal suction line insulation. REMOTE ICE MACHINE, MAKE SURE TO FIRST FOLLOW INSTRUCTIONS A, B, AND C BELOW, BEFORE PROCEEDING TO INSTRUCTION

ملخص المحتوى في الصفحة رقم 3

17. Make sure that all the tubing is not rubbing against anything else in the machine. 18. Reinstall the corner post that was removed earlier and place electrical cover on compressor. 19. Reinstall back panels of ice machine. 20. Make sure to replace start and run components according to the machine you are replacing the compressor in. See note in the beginning of instructions for designation. 21. Reinstall all other panels. 2