Sears 74781 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

m
VARIABLE
SIGNAL CONTROL
I
i
OPERATING STATUS
KEYS
I UNT SCREEN
!
r_ SAFETY DOOR
SWITCH
_ MODEL NO. PLATE
_]_ ERFORMANCE
GUIDE LABEL
[! J
If you need SERVICE or PARTS for your Kenmore dryer:
ELECTRIC
Be ready to give your Sears Service Department the model number, serial number and date of
MODEL 64781
purchase. Write in below. The plate Im with model and serial numbers is located behind the
dryerdoor.
GAS
MODEL 74781
IM I
MODEL NO. SERIAL NO. DATE OF PURCHASE
I

ملخص المحتوى في الصفحة رقم 2

How to dry a load of laundry b_ Clean lint scre_ bef'rre each load. ) Set Hea! Temp Control lgl Push the Start Control [] to start your dryer. Set End_of-Cycle Signal Control il. _Put laundry into dryer and shut the door. (_ Remove load when dry. Set Cycle Selector Control II I| I ! I mouw m WUP if.A1', lll_ R Iff_ IlUl INi, m m imiim I m-li_ ImlI lII)I Ill Cycle Selector Control I1 End-of-Cycle Signal Control Use this control to select the proper drying method for the type of Use this control t

ملخص المحتوى في الصفحة رقم 3

Ill CYCLE SELECTOR CONTROL TOUCH-UP Cycle AUTO DRY I Cycle Use this cycle for most loads, it gives the best drying in the shortest time. Use this cycle to "smooth" synthetic and permanent press clothes that are clean but wrinkled from being crowded in a closet or suitcase. This setting Drying time varies according to type of fabric, size of load and dryness provides about 15 minutes of heated tumbling followed by a 10-minute setting. (approx.) cooldown. Dryness is determined by thermostats that

ملخص المحتوى في الصفحة رقم 4

FEATURES Ik_ Model No. Plate E1 Lint Screen Shows model and serial numbers. Have these ready if you ever call for Keep the lint screen clean. A lint-clogged screen will slow down the flow service. of air. This makes drying time longer and wastes energy. Clean the lint screen before each load as follows: 1. With dryer off, remove the screen by pulling straightup. l_ Performance Guide Label 2. Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is hard to remove. Located insi