ملخص المحتوى في الصفحة رقم 1
Mini Carpet Extractor (4 Gallon)
MODELS: MPRO
10080390
MPROEU
10080400
MPROGB
10080410
MPROAU
10080420
Operating Instructions (ENG)
86037780-U
08/15/08
ملخص المحتوى في الصفحة رقم 2
MACHINE DATA LOG/OVERVIEW Model: Date of Purchase: Serial Number: Sales Representative: Address: Phone Number: Copyright 2006 Windsor Industries, Printed in USA OVERVIEW This carpet extractor is a mains powered, portable carpet extractor intended for commercial use. The appliance sprays a cleaning solution onto the carpet, agitates the wet carpet, and then extracts the soiled solution back into the unit’s recovery tank. The appliance
ملخص المحتوى في الصفحة رقم 3
TABLE OF CONTENTS Machine Data Log/Overview.........................2 PARTS LIST Table of Contents..........................................3 Brush Deck ....................................... 5-1 HOW TO USE THIS MANUAL Control Panel.................................... 5-3 Decal.................................................5-5 Frame & Wheels............................... 5-7 How to use this Manual.................................1-1 Handle ..............................
ملخص المحتوى في الصفحة رقم 4
HOW TO USE THIS MANUAL This manual contains the following sections: The SAFETY section contains important information regarding hazardous or unsafe practices of the - HOW TO USE THIS MANUAL machine. Levels of hazards are identified that could - SAFETY result in product damage, personal injury, or severe - OPERATIONS injury resulting in death. - MAINTENANCE - PARTS LIST The OPERATIONS section is to familiarize the operator with the operation and function of the The HOW TO USE THIS M
ملخص المحتوى في الصفحة رقم 5
SAFETY IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. This machine is for commercial use. To reduce the risk of fire, electric shock, or injury: Connect to a properly grounded outlet. See Grounding Instructions. Do not leave the machine unattended. Unplug machine from outlet when not in use and before maintenance or service. Use only indoors. Do no
ملخص المحتوى في الصفحة رقم 6
SAFETY The following symbols are used throughout this guide as indicated in their descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words -WARNING and CAUTION and FOR SAFETY. The level of hazard intensity is determined by the following definitions: WARNING - Hazards or unsafe practices which COULD result in severe personal injury or death. CAUTION - Hazards or unsafe practices which could result in minor personal injury or
ملخص المحتوى في الصفحة رقم 7
SAFETY 120 VOLT MODELS: THIS PRODUCT IS FOR COMMERCIAL USE ONLY. This appliance is for use on a nominal 120-volt circuit, and has a grounded plug that looks like the ELECTRICAL: plug in “Fig. A”. A temporary adaptor that looks like In the USA this machine operates on a standard 15 the adaptor in “Fig. C” may be used to connect this amp 120V, 60 hz, A.C. power circuit. The amp, plug to a 2-pole receptacle as shown in “Fig. B”, if a hertz, and voltage are listed on the data la
ملخص المحتوى في الصفحة رقم 8
SAFETY SAFETY LABEL LOCATION The following WARNING LABEL(S) are found on your cleaning unit. These labels point out important Warnings and Cautions which should be followed at all times. Failure to follow warnings and cautions could result in fatality, personal injury to yourself and/or others, or property damage. Follow these instructions carefully! DO NOT remove these labels. NOTE: If at any time the labels become illegible, promptly replace them. WARNING LABEL PA
ملخص المحتوى في الصفحة رقم 9
OPERATION CHEMICALS To avoid electric shock use indoors only. Use only the suitable chemicals listed below. Using To reduce risk of fire, do not use volatile substances. incompatible chemicals will damage the machine. Use only cleaners intended for carpet application. Damages of this type are not covered under warranty. Carefully read ingredients on INSPECTION manufacturer’s label before using any product in this Carefully unpack and inspect your extractor for machine. sh
ملخص المحتوى في الصفحة رقم 10
OPERATION 5 1 4 2 11 10 12 3 9 13 6 7 8 CONTROLS & COMPONENTS 7. Solution Tank Drain Hose 8. Accessory Tool Connection 1. Power and Operation Mode Switch Solution connection for accessory tools. Turns accessory tool on or machine on. 9. Accessory Hose Connection 2. Main Handle Hose connection for accessory tool. 3. Solution Button 10. Dome Clamp Sprays solution on floor when pressed. 11. Dome 4. Brush Motor Circuit Breaker
ملخص المحتوى في الصفحة رقم 11
OPERATION OPERATING INSTRUCTIONS FILLING THE SOLUTION TANK SPECIAL NOTES: 1. Release dome clamp. This appliance is not intended for use by persons (including children) with reduced physical, sensory 2. Lift upper recovery tank from machine and or mental capabilities, or lack of experience and set aside. knowledge, unless they have been given supervision or instruction concerning use of the appliance by a 3. Use a clean bucket, recovery tank or hose to person respons
ملخص المحتوى في الصفحة رقم 12
OPERATION OPERATING THE MACHINE OPERATING MACHINE WITH 1. Vacuum the carpet and make sure it is cleared ACCESSORY TOOLS of surface debris before cleaning. This extractor is easily adapted for use with Windsor 2. Plug power cord into a grounded wall outlet. accessory tools: Contact Customer Service for details. 1. Disconnect vacuum hose at dome, insert hose cuff NOTE: Defeating the grounding pin on the power cord can result in a severe electrical shock. into the dome,
ملخص المحتوى في الصفحة رقم 13
MAINTENANCE PROTECT FROM FREEZING PERIODIC MAINTENANCE If it becomes necessary to store in temperatures that 1. After every 25 hours of operation, flush a white could drop below 40°F, the pumping system, hoses vinegar solution (ONE quart vinegar to two and valves must be protected from freezing with a gallons of water) or anti-browning solution (mixed methyl hydrate window washer antifreeze solution. as directed) through the extractor. This will prevent build-up of alkaline re
ملخص المحتوى في الصفحة رقم 14
MAINTENANCE MAINTENANCE INSTRUCTIONS SPRAY JET Remove machine power Note: To prevent a clogged jet due to alkali build-up, cord from electrical source the spray system should be flushed with 1 to 2 before making any adjustments or repairs to the gallons of clean hot water at the end of each day. machine. 1. Turn off switch and unplug machine. Only qualified maintenance personnel are to perform 2. Position the machine to have access to the
ملخص المحتوى في الصفحة رقم 15
MAINTENANCE PUMP REMOVAL BRUSH MOTOR REMOVAL 1. Turn off switch and unplug machine. 1. Turn off switch and unplug machine. 2. Set the machine in its upright position. Remove 2. Set the machine in its upright position. Remove the screws (2) in the back metal cover. Rotate the screws (2) in the back metal cover. Rotate the cover down and slide back releasing the tab the cover down and slide back releasing the tab under the machine from the main frame. under the machine
ملخص المحتوى في الصفحة رقم 16
MAINTENANCE VACUUM MOTOR REMOVAL Vacuum Motor Carbon Brushes Replacement End Cap 1. Turn off switch and unplug machine. 2. Set the machine in its upright position. Remove WARNING: The green Carbon the screws (2) in the back metal cover. Rotate ground wire must be Brushes attached for safe operation. the cover down and slide back releasing the tab See wiring diagram. under the machine from the main frame. 3. Remove the pump box cover. Remove screws (
ملخص المحتوى في الصفحة رقم 17
MAINTENANCE TROUBLESHOOTING CHART PROBLEM CAUSE SOLUTION Is the cord plugged in. Plug in cord. No power, nothing runs Circuit breaker tripped in building. Reset breaker Faulty switch. Call for service. Faulty power cord or pigtail. Call for service. Vacuum circuit breaker tripped. Reset breaker Vacuum motor will not Faulty main switch. Call for service. run Loose wiring. Call for service. Faulty vac motor. Call for service. Debris lodged in vac shoe. Remove debris from vac sh
ملخص المحتوى في الصفحة رقم 18
MAINTENANCE TROUBLESHOOTING CHART Squealing or grinding sound in brush Worn brush bearings Replace bearings. housing. Make several passes at right angles to Carpet not getting clean Severe soil conditions each other. Use a pre-spray. Replace spray jet which is producing a Worn spray jet Carpet too wet fine mist. Clean solution filter screen located Solution filter screen clogged. inside lower tank. Clean or replace jet. Do not use a wire Spray jet clogged. to clean jet. Da
ملخص المحتوى في الصفحة رقم 19
Mini Carpet Extractor Parts List 86037780 EXTRACTOR 12/09/06
ملخص المحتوى في الصفحة رقم 20
BRUSH DECK 2 1 3 15 16 8 9 10 11 4 13 5 1 7 6 12 1 7 14 86037780 EXTRACTOR 03/27/07 5-1
