ملخص المحتوى في الصفحة رقم 1
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS Operations and Adjustments........................24-31 Before You Begin Important Information........................................3 Warnings.................................................4-5 Basic Information...........................................6-7 LATCH Belt Routing What is LATCH?...................................................8 LATCH from Vehicle Anchor Points LATCH Storage LATCH System....................................................9 Features.....
ملخص المحتوى في الصفحة رقم 3
IMPORTANT INFORMATION No child restraint can guarantee protection Safety First Check List from injury in every situation, but proper use helps reduce the risk of serious injury or death. Read and understand instruction manual and child restraint labels. READ THIS MANUAL CAREFULLY. must use Registration Information child restraint rear-facing. Do not use child restraint rear-facing in Child restraints could be recalled for safety reasons. You must register this restraint to be reached
ملخص المحتوى في الصفحة رقم 4
WARNINGS - Prevent serious injury or death: Failure to follow these instructions Vehicle seat belt system MUST hold and child restraint labels can result child restraint securely. Not all in child striking the vehicle’s vehicle seat belts can be used with interior during a sudden stop or a child restraint. crash. Secure child restraint with If vehicle seat belt does not hold a vehicle seat belt or LATCH that is child restraint securely, read properly routed as shown in this “Vehicle Seat B
ملخص المحتوى في الصفحة رقم 5
WARNINGS - Prevent serious injury or death (continued): If child restraint is in a crash, it DO NOT remove LATCH system from must be replaced. DO NOT use it child restraint. If using vehicle seat again! A crash can cause unseen belt to secure child restraint, LATCH damage and using it again could connectors must be stored. (see result in serious injury or death. section “LATCH storage”) DO NOT use child restraint if it is Never attach two damaged or missing parts. LATCH connectors to one vehicle
ملخص المحتوى في الصفحة رقم 6
BASIC INFORMATION Certification WARNING Vehicle Safety Standard 213 for use in motor DO NOT place this child restraint in a vehicle seating location that has a Unoccupied Child Restraint front air bag. If an Always secure child restraint with LATCH or a air bag inflates, it can hit the child and In a crash, an unsecured child restraint can child restraint with great force injure passengers. and cause serious injury or death to your child. Check vehicle owner’s Dangerous Vehicle Seats manu
ملخص المحتوى في الصفحة رقم 7
BASIC INFORMATION (continued): Child Restraint Useful Life STOP using child restraint and throw it away after the date MOLDED child restraint. in the location shown. Vehicle Seat Protection restraint. Warm Weather or warm weather. To avoid burns, always check before putting child in child restraint. 7
ملخص المحتوى في الصفحة رقم 8
WHAT IS LATCH? Vehicle system is called LATCH. LATCH stands for: Top Tether Anchor LATCH locations. Lower Anchorage and Tethers for CHildren. Points LATCH System for Vehicles: LATCH Vehicle anchor point and two lower anchor points. Lower Anchor Points ISOFIX to identify the new child restraint LATCH ISOFIX. LATCH anchor points. Vehicle Seat Crease LATCH with a symbol (Fig. a) or a colored dot. See your vehicle owner’s manual for exact locations, anchor identification, and re
ملخص المحتوى في الصفحة رقم 9
LATCH SYSTEM LATCH consists of a permanently attached lower anchorage belt and a top tether strap (Fig. a). ONLY use LATCH in a seating position recommended Vehicle Child Restraint Top Tether Top Tether Anchor LATCH Point inches from the center of one LATCH anchor to the center of another LATCH anchor. If allowed by your Vehicle center seating position may be used if the anchor spacing is 11” or greater. Vehicle Lower Anchor Points LATCH for installations with children weighing N
ملخص المحتوى في الصفحة رقم 10
FEATURES Instruction Harness slots bar strap** Harness strap Harness tie Harness strap Harness Harness slots Adjustment belt Crotch strap Harness release LATCH Recline stand belt*** LATCH Belt Harness adjustment strap Splitter plate LATCH connector anchor points behind some seats. A tether anchors the top of the child restraint to the body of the LATCH. LATCH may ONLY be used IN PLACE of vehicle belt if vehicle is equipped with belt or LATCH, a tether helps reduce
ملخص المحتوى في الصفحة رقم 11
1” (2.5cm) HEIGHT & WEIGHT LIMITS Rear Facing: 4 to 40 lbs. (1.8 - 18kg) * facing until age 2 or until they reach the maximum rear facing height and weight rating for their seat. MUST be rear-facing. Preterm or Low Birth Weight rear-facing. Infant IMPORTANT: rear-facing with children up to A preterm infant or low birth weight infant may rear-facing According to the American Academy of Pediatrics, Child should use car seat forward-facing only if improperly reclined
ملخص المحتوى في الصفحة رقم 12
REAR-FACING INSTALLATION WITH LATCH LATCH belt must be routed through opening in 6 1 child restraint for rear-facing mode. (fig. e) (see page 29, fig. d Belt must lay flat and not be twisted. tight and does not slip from the tightened Adjust child restraint to recline position position. If it does not stay tight, try another 2 (see fig. a and page 25, fig. g rear-facing LATCH anchors. 7 For ease of installation, extend LATCH belt to its Vehicle must 3 maximum length. Ball MUST be entir
ملخص المحتوى في الصفحة رقم 13
REAR-FACING INSTALLATION WITH LATCH (continued) Recline Position Tether Openings (fig. a) Towels Recline Position (fig. b) LATCH (fig. f) (fig. c) (fig. d) (fig. e) 13 LAPC0110A LAP LAPC01 C0110A 10A LAPC0110A
ملخص المحتوى في الصفحة رقم 14
FORWARD-FACING INSTALLATION WITH LATCH LATCH belt must be routed through 6 1 opening in child restraint for forward-facing (see page 29, fig. e LATCH belt by pulling adjustment belt. Belt must lay flat and not be twisted. child restraint (fig. d). Adjust car seat to upright position (see fig. a 7 2 and page 25, fig. g (fig. e) Place forward-facing with LATCH anchors. tight and does not slip from the tightened For ease of installation, extend LATCH belt position. If it does not stay ti
ملخص المحتوى في الصفحة رقم 15
FORWARD-FACING INSTALLATION WITH LATCH (continued) Tether Pull to tighten (A) (B) Lock (fig. f) Openings Position Upright LATCH Upright Position Position (fig. a) (fig. e) (fig. b) (fig. c) (fig. d) 15
ملخص المحتوى في الصفحة رقم 16
REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS 5 (fig. d) WARNING LATCH belt MUST be stored when belt MUST stay tight. using vehicle seat belt to install child restraint. If not secure, see “Vehicle Seat Belts” page 32. Store LATCH belt by attaching to connectors 1 through forward-facing openings 6 (see page 31, fig. k Vehicle must side (fig. a). Ball MUST be entirely in green zone (fig. e). LATCH If necessary, place rolled towels under child by pulling adjustment
ملخص المحتوى في الصفحة رقم 17
REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS (continued) Tether Installation with Openings Lap belt only LATCH Towels Recline Position (fig. d) (fig. e) Installation with Lap/shoulder belt Recline Position (fig. a) (fig. b) (fig. c) 17 LAPC0110A LAPC0110A LAPC0110A LAPC0110A LAPC0110A
ملخص المحتوى في الصفحة رقم 18
FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS 4 WARNING LATCH belt MUST be stored when using vehicle seat belt to install child restraint (fig. d). child restraint. 5 Store LATCH belt by attaching to connectors 1 (fig. e) through rear-facing openings (see page 31, fig. j belt MUST stay tight. side (fig. a). If not secure, see “Vehicle Seat Belts” page 32. LATCH by pulling adjustment belt. (A) to anchor 6 hardware (B) and tighten adjustment belt to (fig. f)
ملخص المحتوى في الصفحة رقم 19
FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS (continued) Tether LATCH (stored) Installation with Openings Lap belt only Pull to tighten (A) (B) Upright Position (fig. a) (fig. f) Lock Installation with Lap/shoulder belt Position Upright Position (fig. b) (fig. c) (fig. d) (fig. e) 19
ملخص المحتوى في الصفحة رقم 20
1” (2.5cm) PLACING CHILD IN CHILD RESTRAINT Check harness system: REAR-FACING Rear-facing - 4-40 lbs (1.8-18 kg) Harness straps must be through bottom or middle slots at or below shoulders. at or below child’s shoulders. Body support MUST be used if shoulders are below lowest slots. 1” below the top of the child restraint. 20
