ملخص المحتوى في الصفحة رقم 1
Instruction
Manual
Avoid injury or death -
Read and understand this manual! ISPC054BA 06/03 US
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS Operations and Adjustments..........................18 Instruction manual is for: Harness Straps ComfortSport 5-Point Newborn/Toddler Child Restraint Harness Tie ComfortSport Overhead Shield Newborn/Toddler Buckle Child Restraint Recline / Upright Positions 5-Point Crotch Strap Adjustment Instructions for these models are the same unless Overhead Shield Adjustment otherwise noted. Changing Harness Strap Slots LATCH Belt Routing Before You Begin Removin
ملخص المحتوى في الصفحة رقم 3
IMPORTANT INFORMATION No child restraint can guarantee protection Safety First Check List ❃ from injury in every situation, but proper use helps reduce the risk of serious injury or death. ✔Read and understand instruction manual READ THIS MANUAL CAREFULLY. and child restraint labels. ✔Infants less than 20 lbs. (9 kg) must use Registration Information ❃ child restraint rear-facing. ✔Do not use child restraint rear-facing in Child restraints could be recalled for safety vehicle seat with air ba
ملخص المحتوى في الصفحة رقم 4
WARNINGS - Prevent serious injury or death: Failure to follow these instructions Vehicle seat belt system MUST hold and child restraint labels can result child restraint securely. Not all in child striking the vehicle’s interior vehicle seat belts can be used with during a sudden stop or crash. a child restraint. Secure child restraint with a vehicle seat belt or LATCH that is properly If vehicle seat belt does not hold routed as shown in this manual. child restraint securely, read “Vehicle
ملخص المحتوى في الصفحة رقم 5
WARNINGS - Prevent serious injury or death (continued): If child restraint is in a crash, it DO NOT remove LATCH system from must be replaced. DO NOT use it child restraint. If using vehicle seat again! A crash can cause unseen belt to secure child restraint, LATCH damage and using it again could connectors must be stored. (see result in serious injury or death. section “LATCH storage”) DO NOT use child restraint if it is Never attach two damaged or missing parts. LATCH connectors to one veh
ملخص المحتوى في الصفحة رقم 6
BASIC INFORMATION Dangerous Vehicle Seats ❃ WARNING Do not use child restraint on rear-facing or DO NOT place this side-facing vehicle seats. child restraint in a vehicle seating location that has a front air bag. If an Child Restraint Useful Life ❃ air bag inflates, it can hit the child and STOP using child restraint and throw it away child restraint with great force after the date molded into the back of and cause serious injury or death the child restraint. to your child. Check vehicle
ملخص المحتوى في الصفحة رقم 7
WHAT IS LATCH? United States Federal Motor Vehicle Safety Standards have defined a new system for Typical seat in a Vehicle installing child restraints in vehicles. The passenger vehicle. Top Tether Anchor system is called LATCH. LATCH stands for: Other vehicle types Points Lower Anchorage and Tether for CHildren. may have different LATCH locations. LATCH System for Vehicles: LATCH in the vehicle consists of a top tether anchor point and two lower anchor points. Vehicle Lower Anchor Some
ملخص المحتوى في الصفحة رقم 8
LATCH SYSTEM LATCH System: LATCH consists of a permanently attached lower anchorage belt and a top tether strap (Fig. a). Child Restraint Vehicle Top Tether ONLY use LATCH in a seating Top Tether position recommended Anchor by vehicle manufacturer. Point Thank you for contacting Graco. LATCH is defined as anchorages 280mm (11.02 inches) on center. Vehicle As a manufacturer, we do Lower not recommend using the Anchor Points LATCH system in the center position if it exceeds this length. If you
ملخص المحتوى في الصفحة رقم 9
HEIGHT & WEIGHT LIMITS Rear-facing: 5 to 30 lbs. (2.2-13.6 kg) The American Academy of Pediatrics Infants who weigh less than 20 lbs. recommends that children should be at least one * (9 kg) MUST be rear-facing. year of age before being positioned forward facing. Infants or toddlers 20 to 30 lbs. (9 to 13.6 kg) may be rear-facing. Preterm or Low Birth Weight ❃ IMPORTANT: This child restraint is Infants certified for use rear-facing with children up to 30 lbs. (13.6 kg). However, some A
ملخص المحتوى في الصفحة رقم 10
REAR-FACING INSTALLATION WITH LATCH LATCH belt must be routed through Pull front to back and left to right to check for 1 6 opening in child restraint for rear-facing mode. secure installation (fig. d). (see page 23, fig. k). Check that the lower anchorage belt stays Belt must lay flat and not be twisted. tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service (see back cover). Adjust child restraint to reclin
ملخص المحتوى في الصفحة رقم 11
REAR-FACING INSTALLATION WITH LATCH (continued): Tether Openings Towels LATCH (fig. e) (fig. a) (fig. b) (fig. c) (fig. d) 9 LAPC0110A
ملخص المحتوى في الصفحة رقم 12
FORWARD-FACING INSTALLATION WITH LATCH LATCH belt must be routed through Pull front to back and left to right to check for 1 6 opening in child restraint for forward-facing secure installation (fig. d). (see page 23, fig. l). Check that the lower anchorage belt stays tight and does not slip from the tightened Belt must lay flat and not be twisted. position. If it does not stay tight, try another seating position or contact Customer Service (see back cover). Adjust child restraint to uprig
ملخص المحتوى في الصفحة رقم 13
FORWARD-FACING INSTALLATION WITH LATCH (continued): Tether Openings Pull to tighten (A) LATCH (B) (fig. a) (fig. e) (fig. b) (fig. c) (fig. d) 11
ملخص المحتوى في الصفحة رقم 14
REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS Pull front to back and left to right to check for 5 WARNING secure installation (fig. b). Vehicle lap belt MUST stay tight. LATCH belt MUST be stored when using vehicle seat belt to install child If not secure, see “Vehicle Seat Belts” page 26. restraint. Store LATCH see page 25, fig. q. 1 6 Check level indicator on child restraint. Vehicle must be on level ground and child in 2 Adjust child restraint to recline position child restraint when
ملخص المحتوى في الصفحة رقم 15
REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS (continued): Tether Openings LATCH (stored) Installation with Lap belt only Towels (fig. c) Installation with Lap/shoulder belt (fig. a) (fig. b) 13 LAPC0110A
ملخص المحتوى في الصفحة رقم 16
FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS Pull front to back and left to right to check for 5 secure installation (fig. c). Vehicle lap belt WARNING MUST stay tight. LATCH belt MUST be stored when using vehicle seat belt to install If not secure, see “Vehicle Seat Belts” page 26. child restraint. Attach tether strap hook (A) to anchor 6 Store LATCH see page 25, fig. r. 1 hardware (B) and tighten adjustment belt to remove any slack (fig. d). If vehicle does not have anchor points
ملخص المحتوى في الصفحة رقم 17
FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS (continued): Tether Installation with Lap belt only Openings Pull to tighten (A) LATCH (stored) Stand (B) Installation with (fig. d) Lap/shoulder belt (fig. a) (fig. b) (fig. c) 15
ملخص المحتوى في الصفحة رقم 18
PLACING CHILD IN CHILD RESTRAINT 5-Point Models Only: WARNING Crotch strap must be in opening closest to but not under child. To prevent serious injury or death: Keep harness straps snug and Overhead Shield Models Only: positioned on shoulders with harness Harness tongue must be in opening tie at arm pit level. closest to but not under child. Do not use strap covers, blankets, cushions, or padding under harness straps or child unless provided by Graco. Place child in child restraint
ملخص المحتوى في الصفحة رقم 19
PLACING CHILD IN CHILD RESTRAINT (continued) 3 3 2 2 4 4 (fig. a) (fig. b) 17 5-Point Models Overhead Shield Models
ملخص المحتوى في الصفحة رقم 20
OPERATIONS and ADJUSTMENTS Harness Straps (fig. a): Recline / Upright Positions (fig. b): 1 4 Rear-facing - MUST use Recline position. To tighten: Pull lower belt tab. Forward-facing - MUST use Upright position To loosen: Pull and hold upper belt tab while pulling shoulder harness straps. Upright Position: Rotate stand out and push into child restraint (fig. b). 2 Harness Tie: Recline Position: Pull stand out and rotate into child restraint. To open: Press tabs and pull apart. Harness
