Fisher-Price M7948 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

M7948
Please keep this instruction sheet for future reference, as it contains
important information.
Requires four “C” (LR14) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
www.fisher-price.com

ملخص المحتوى في الصفحة رقم 2

Assembled Parts Grandstand Track Trophy Shifter Flags

ملخص المحتوى في الصفحة رقم 3

Battery Installation 1.5V x 4 “C” (LR14) • Locate the battery compartment on the bottom of the toy. • Loosen the screws in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door. • Insert four “C” (LR14) alkaline batteries. Hint: We recommend using alkaline batteries for longer battery life. • Replace the battery compartment door and tighten the screws with a Phillips screwdriver. • If the toy begins to operate erratically, you may need to reset the elec

ملخص المحتوى في الصفحة رقم 4

Assembly Grandstand Track 1 1 • “Snap” the grandstand onto the track. Shifter 1 2 • “Snap” the shifter into the slot as shown. Flags 1 3 • Insert the flags into the flag posts around the track. Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. M7948a-0920 ©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA

ملخص المحتوى في الصفحة رقم 5

Start Your Engines! Power Switch Shifter Ramp Key • Slide the power switch on the bottom of the track to the on position . • Drive the cars onto the track. • Turn the key to start your engines! Note: When you turn the key the track will stay on for 30 seconds. To restart the track, turn the key off and then back on again. • Use the shifter to drive faster. • Pull over to the pit stop for a tune-up. Lift the ramp to roll the car onto the track. Grandstand Off-Ramp Gate • After the race, open the

ملخص المحتوى في الصفحة رقم 6

Consumer Information Care • Wipe the toy with a clean cloth dampened with a mild soap and water solution. • Do not immerse the toy. FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, i