ملخص المحتوى في الصفحة رقم 1
Model APS-920
Owner’s Manual
ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors,
hood lid and trunk lid.
2. Press and release Lock/Arm button on the keychain trans-
mitter.
The dash mounted LED begins to flash slowly. Parking Lights
flash one time.
Siren sounds one chirp.
If the siren/horn sounds 3 chirps, then you have left a door,
trunk, or hood lid ajar. Simply close the opened entry point
to provide full protection. If the siren "chirped" three times,
ملخص المحتوى في الصفحة رقم 2
will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children playing near your vehicle that may accidently trigger your security system. In this case you can cancel the siren sounding without disarming your alarm. INTRUSION WARNING SIGNALS This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an intrusion attempt has occurred, the siren will chirp 4 times and the par
ملخص المحتوى في الصفحة رقم 3
flash pattern reports the previously stored code, the new code was not entered correctly. Please repeat steps 1 through 7 above considering the following. NOTE: Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero), or no digit entered in any place, units or tenths. NOTE: If 15 seconds of inactivity expire or if the ignition switch is turned off for more then 5 sec- onds during any of the above steps, the unit will revert back to the last successfully stored
ملخص المحتوى في الصفحة رقم 4
hold either the lock or unlock button of your transmitter for three seconds. The parking lights will begin to flash, the siren will sound, and if connected, the vehicle horn will beep making your vehicle audible as well as more visible. The lights, siren and or horn will stop automatically after 30 seconds. If you wish to turn off this mode prior to the expiration of the 30 second timer, press and hold for three seconds either the lock or unlock buttons a second time, or press and release th
ملخص المحتوى في الصفحة رقم 5
To do this: 1. Turn the ignition key on then off. 2. Within 10 seconds, press and release valet switch three times. 3. If the chirps were on before you started, then you will hear two chirps indicating they have been turned off. If the chirps were off before you started, then you will hear one chirp indicating they have been turned on. NOTE: Whenever the chirps are bypassed, the 4-chirp intrusion indicator and 3 chirp de- fective zone indicator will always operate. Since these are important war
ملخص المحتوى في الصفحة رقم 6
TURBO TIMER MODE This system provides a means to cool down the vehicles turbo charger, if so equipped, by allowing the vehicle to continue to run for a prescribed period of time every time the vehicle's engine is turned off. This feature requires the system to be set up for turbo timer during installation. Consult with your installation center to be certain this feature was activated and how long the vehicle will continue to run, 3, 5, or 10 minutes after the ignition switch is turned off. To
ملخص المحتوى في الصفحة رقم 7
1) Enter the transmitter program mode of channel 1 as indicated above. 2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a chirp, then release and immediately press the same button a second time until you hear a long chirp followed by a short chirp. This action erases the transmitter. If the transmitter you wish to erase has been lost or stolen then following the information below will successfully remove the transmitter. NOTE: For this procedur
ملخص المحتوى في الصفحة رقم 8
Vehicle as Been Started By Remote Control. Vehicle Is Running Under Control of The Remote Start Unit. Alternate Vehicle Mode Is Activated. Toggle feature on and off by pressing Trunk/Key + * buttons for 5 seconds until beep is heard, then press the Lock Button Once. Battery Save Mode Is On. Battery Level Indicator, Shown At Full Level. Hood Or Trunk Input Was Activated. Door Input Was Activated. Vibration Sensor Was Activated. Pre Detect Stage Of Sensor Was Activated. WARNING!! CARBON MONOXIDE
ملخص المحتوى في الصفحة رقم 9
ORDER FORM FOR APS620TX & APS920TX2 Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the information legibly and mail this form and your payment ac- cording to the instructions below. Note: Transmitter model number found on back of case. APS620TX APS920TX2 Order APS620TXP-300 If Lock & Unlock Buttons Are Blue & APS620TXP-304 If 1) Transmitter Model Number_____________________ Lock Unlock Buttons Are Red 2) Name: _______________________
ملخص المحتوى في الصفحة رقم 10
Page 10 128-7852 10 of 12 36 MONTH LIMITED WARRANTY Applies to control modules, relays, transmitters, sensors and sirens. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 36 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) wi
ملخص المحتوى في الصفحة رقم 11
THIS PAGE LEFT BLANK INTENTIONALLY Page 11 128-7852 11 of 12
ملخص المحتوى في الصفحة رقم 12
FCC NOTICE This device complies with part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance voids the users authority to operate this device. © 2006 Audiovox Electronics Corporation 150 Marcus Blv
