ملخص المحتوى في الصفحة رقم 1
Model 330V
O Ow wn ne er r’’s s G Gu uiid de e
ملخص المحتوى في الصفحة رقم 2
lliim miitte ed d lliiffe ettiim me e c co on ns su um me er r w wa ar rr ra an ntty y Directed Electronics, Inc. promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed Electronics, Inc. unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the
ملخص المحتوى في الصفحة رقم 3
AND/OR VANDALISM. THIS WARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REINSTALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED ELECTRONICS, INC. OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FED- ERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED ELECTRONICS, INC. SHALL BE STRICTLY LI
ملخص المحتوى في الصفحة رقم 4
contents ® limited lifetime consumer . . . . . nuisance prevention circuitry . . .7 warranty . . . . . . . . . . . . . . . . . . . .i diagnostics . . . . . . . . . . . . . . . . . .9 arming diagnostics . . . . . . . . . .9 trademarks and copyrights . . . . .1 disarming diagnostics . . . . . . .9 what is included . . . . . . . . . . . . .2 table of zones . . . . . . . . . . . .10 important information . . . . . . . . .2 rapid resume logic . . . . . . . . . . .10 using your system . . . . . . .
ملخص المحتوى في الصفحة رقم 5
what is included Control module and harness ® A Stinger dual stage shock sensor (on-board the control module) ® Pre-wired Valet switch and status LED ® Failsafe Starter Kill relay (if equipped) important information Congratulations on the purchase of your security system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an authorized dealer voids the warranty. All dealers are provided with a preprinted
ملخص المحتوى في الصفحة رقم 6
using your system manual (active) arming The factory default is active arming. In this mode you can activate, or arm, the system by locking the doors with your factory keyless entry transmitter. When the system arms, you will hear a short horn honk and see the parking lights flash once. While the system is armed, the status LED will flash about twice a second, showing that the system is active- ly protecting your vehicle. If you hear a second short horn honk after arming, and see the status LED
ملخص المحتوى في الصفحة رقم 7
n no otte e:: If any protected entry point (such as a door or a switch- protected trunk or hood) is open, the system will not passively arm. Additionally, each time a sensor is triggered during the arming countdown, the 30-second countdown starts over. armed protection When armed, your vehicle is protected as follows: Light impacts to your vehicle will trigger the warn away sig- nal. The system will pulse the horn and flash the parking lights for a few seconds. Heavy impacts will trigger the s
ملخص المحتوى في الصفحة رقم 8
disarming To disarm the system, unlock the doors using your factory keyless trans- mitter. The horn will sound twice, and the parking lights will flash twice. If the horn sounds either four or five times when disarming, refer to the Diagnostics section of this guide. This is called Tamper Alert. disarming without a transmitter This feature allows you to override the system without the transmitter should it be lost, damaged or disabled. To do this, you must have the ve- ® hicle's ignition key and
ملخص المحتوى في الصفحة رقم 9
® ® ® ® T To o e en nt te er r o or r e ex xiit t V Va alle et t M Mo od de e w wiit th h t th he e V Va alle et t s sw wiit tc ch h:: Turn ignition to “on” position, then turn to “off” position. Press ® and release the Valet switch within 10 seconds. The status DRW-35 LED will light steady if you ® ® have entered Valet Mode. To exit Valet Mode, repeat the steps above. ® The LED will turn off when exiting Valet Mode. ® remote valet ® Remote Valet is a convenient feature that makes bypassi
ملخص المحتوى في الصفحة رقم 10
transmitter does not have a panic button, this system can be pro- grammed to enable a panic feature (refer to the Programming Options). If enabled, just press the lock button on your factory keyless transmit- ter twice within three seconds to enter Panic Mode. The horn will sound and the parking lights will flash for 30 seconds. To stop Panic Mode at any time, press the unlock button on your factory transmitter. n no otte e:: The system can also be programmed so that pressing the lock button twi
ملخص المحتوى في الصفحة رقم 11
If the bypassed sensor tries to trigger the system while it is being bypassed, the 60-minute bypass period will start over. This ensures that a sensor that is continuously triggering will remain bypassed. Doors are covered differently: If the alarm is triggered by an open door for three full cycles (one-and-one-half minutes), the doors will be bypassed until the trigger ceases. n no otte e:: Arming and disarming the system does not reset this function! The only ways to reset a bypassed zone ar
ملخص المحتوى في الصفحة رقم 12
diagnostics The microprocessor at the heart of your system is constantly monitor- ing all of the switches and sensors connected to it. It detects any faulty switches and sensors and prevents them from disabling the entire sys- tem. The microprocessor will also record and report any triggers that occurred during your absence. arming diagnostics If the system is armed with an input active (door open, sensor trigger- ing, etc.) the unit will chirp once when arming and then one more time a few secon
ملخص المحتوى في الصفحة رقم 13
each time it is disarmed, until the next time the ignition key is turned on. table of zones The zone number is the number of LED flashes used by the system to identify that input. The standard input assignments are listed below. Z ZO ON NE E (Number LED Flashes) D DE ES SC CR RI IP PT TI IO ON N 1 1 Instant trigger - often used for hood/trunk pin switches 2 2 Instant trigger - a heavier impact detected by the shock sensor 3 3 Door switch trigger 4 4 Optional sensor 5 5 Ignition trigger The LED w
ملخص المحتوى في الصفحة رقم 14
programming options Programming options control your system's normal, operational set-up. Most options do not require additional parts, but some may require installation labor. programming settings The following is a list of the program settings: n no otte e:: Factory default setting is shown in b bo olld d. n no otte e:: Settings 6 and 11 are to be set by the installer. 1. A Ac ct tiiv ve e or passive arming (automatic arming 30-seconds after closing the last door). 2. Arming/disarming confir
ملخص المحتوى في الصفحة رقم 15
the parking lights will flash for a few seconds followed by a full trigger response when the door is opened. In the instant mode, the system will trigger the full trigger response. 8. Sensor shunt zones 2 2 and 4 4 or All zones. 9. Siren duration - 3 30 0 seconds or 60 seconds. n no otte e:: The siren is optional and requires additional installation. ® ® 10. Valet Pulse Count: The number of pulses of the Valet switch required to disarm the security system are programmable from one to five pulses
ملخص المحتوى في الصفحة رقم 16
glossary of terms Control Module: The “brain” of your system. Usually hidden under- neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all of the alarm’s functions. ® Failsafe Starter Kill (if equipped): An automatic switch controlled by the security system which prevents the vehicle’s starter from cranking whenever the system is armed. The vehicle is never prevented from ® cranking when the system is disarmed, in Valet Mode, or should the s
ملخص المحتوى في الصفحة رقم 17
© 2005 directed electronics, inc. 14
ملخص المحتوى في الصفحة رقم 18
notes © 2005 directed electronics, inc. 15
ملخص المحتوى في الصفحة رقم 19
© 2005 directed electronics, inc. 16
ملخص المحتوى في الصفحة رقم 20
✂ ✂ Q QU UI IC CK K R RE EF FE ER RE EN NC CE E G GU UI ID DE E:: T To o a ar rm m t th he e s sy ys st te em m ■ You can arm the system by locking the doors with your factory keyless entry transmitter. When the system arms, your will hear a short horn honk, and see the parking lights flash once. T To o d diis sa ar rm m t th he e s sy ys st te em m ■ To disarm the system, unlock the doors using your factory keyless trans- mitter. You will hear two horn honks, and the parking lights will
