ملخص المحتوى في الصفحة رقم 1
ملخص المحتوى في الصفحة رقم 2
Congratulations Congratulations on the purchase of your state-of-the-art remote start and security system. Reading this Owner’s Guide prior to using your system will help maximize the use of your system and its many fea- tures. Please visit: www.clifford.com – For general and additional guide information. For any additional questions please contact your authorized Directed dealer or contact Directed at 1-800-753-0600. What you get Welcome to the best generation of security with remote sta
ملخص المحتوى في الصفحة رقم 3
Important information Government Regulations and Safety information Read the Government Regulations and Warning! Safety First sections of this manual prior to operating this system. Warning! Failure to heed this information can result in death, personal injury or property damage and may also result in the illegal use of the system beyond its intended purpose. Your Warranty Your Responder LE system comes with a warranty. Please make sure you receive the warranty registration card and proo
ملخص المحتوى في الصفحة رقم 4
Contents Getting Started .................................................................................................... 4 Keys to using this manual ...................................................................... 4 Responder LE 2-Way ........................................................................................... 5 Using your System ............................................................................................... 7 Commands and Confirmations .................
ملخص المحتوى في الصفحة رقم 5
Alarm Features ................................................................................................. 24 Normal Arm Protection ....................................................................... 24 Sensor Silent Arm protection ............................................................... 24 Full Silent Arm Protection .................................................................... 25 Sensor Warn-away ..........................................................................
ملخص المحتوى في الصفحة رقم 6
Warning! Safety First ......................................................................................... 46 Installation ........................................................................................ 46 Remote Start Capable ........................................................................ 46 Manual Transmission Vehicles ............................................................. 46 Interference ............................................................................
ملخص المحتوى في الصفحة رقم 7
Getting Started Keys to using this manual Specific actions (in bold type) and style conventions are used consis- tently throughout this manual, they are as follows: Press: implies pushing in and releasing a button. Hold: is used after Press actions when a button needs to be held in position for an extended period of time, typically several sec- onds. Italicized words denote section/sub headings in this guide and can be located through the table of contents. An asterisk (*) when used after
ملخص المحتوى في الصفحة رقم 8
Responder LE 2-Way Internal Antenna Transmit LED Ghost Command LED’s Buttons AUX Function Button Feature Description Internal Antenna Used for transmitting and receiving* information Command buttons (4) Used to perform arming, disarming, auxiliary channel and remote start commands Function button Used to access function levels for commands, configura- tion menus for programming, Car Selection, and to request reports. Ghost LED’s ** Each button has an associated LED next to it that are active
ملخص المحتوى في الصفحة رقم 9
Control Center Control button Status LED The Control Center, typically located on the upper part of the front windshield sends and receives commands or messages to and from your system. It consists of: The In-vehicle system antenna, for 2 way communication. The Status LED, as a visual indicator of the system’s status. The Control button, for placing the system into Valet Mode* and to perform the Emergency Override** operation. * See Remote and System Operations section for details.
ملخص المحتوى في الصفحة رقم 10
Using your System Commands and Confirmations Commands, Basic or Advanced, are used to activate system features and are performed by pressing one of the Command buttons. Basic commands control the most often used security and remote start fea- tures while Advanced commands control more specialized features and request reports. Confirmations for Basic or Advanced commands are indicated first by siren chirps and parking light flashes, and then by illuminated Ghost LED’s and beeps or tones on the
ملخص المحتوى في الصفحة رقم 11
Remote Control Command table Direct Access Level x 1 x 2 x 3 x 4 Button LEVEL 1 LEVEL 2 LEVEL 3 LEVEL 4 Arm/Lock Silent Arm Sensor Sensor Silent Full Silent (Panic) Bypass Arm Arm Disarm/Unlock Silent Disarm Remote Valet Car Finder Remote Start Runtime Timer Start Smart Start Defogger Reset Aux/Trunk AUX 1 AUX 2 AUX 3 AUX 4 AUX Advance Level, Temperature Arm Status* Runtime Change Car Check* Remaining* (3 sec), Enter programming (8 sec) *Not available for 1-way companion remote control Fau
ملخص المحتوى في الصفحة رقم 12
** Remote Start feature not available when the Remote Start status is incorrect upon receiving the command. (Example: Runtime reset command received when remote start is off). Refer to the notes included in the command descriptions that ad- dress these faults or go to Remote Start Faults under the Remote Start Features section for more details. © 2011 Directed Electronics. All rights reserved. 9
ملخص المحتوى في الصفحة رقم 13
Basic Commands (Direct Access) No Ghost LED’s on Arm Press and release The alarm arms, doors lock (if connected), and the siren chirps and parking lights flash once. The Arm LED and beeps play to confirm. If Valet mode* is On, the doors lock and the Arm LED, LED and a fault tone plays. Exit Valet mode to arm the alarm normally. If a trigger zone fault is detected the siren chirps once again and the remote will emit a Trigger Zone Fault Report**, the Arm LED, LED and a fault tone plays. To A
ملخص المحتوى في الصفحة رقم 14
triggered; the siren will chirp 4 or 5 times, and the Disarm LED, LED and 4 or 5 fault tones play to alert of the report. Remote Start Press and release Activates (or if On, deactivates) the remote starter. The engine and parking lights turn On and the Remote start LED and On tones play, or the engine and parking lights turn Off and the Remote start LED and Off tones play to confirm. If a Remote start configuration issue prevents the engine from starting, the LED and a fault tone will play
ملخص المحتوى في الصفحة رقم 15
Advanced Commands: (Level 1) Press and release the button 1 time. The LED illuminates indicat- ing Level 1 Silent Arm Press and release The alarm arms, doors lock (if connected), and the parking lights flash once. The Arm LED turns on to confirm. Valet mode* or Trigger Zone Fault Report** messages may be received. Silent Disarm Press and release The alarm disarms, doors unlock (if connected), and the parking lights flash twice. The Disarm LED turns on to confirm. The Silent Disarm output may b
ملخص المحتوى في الصفحة رقم 16
AUX 1 Press and release AUX Activates (or if On, deactivates) the Aux 1 output. The Aux LED and On tones or Off tones play to confirm. Temperature Request Press and hold the button Requests the vehicle’s interior temperature and displays it by illuminat- ing the green ghost LED’s; cold is 1 LED, cool (2), warm (3), warmer (4) . * See Remote and System Operations section for details. ** See Alarm Features for details. © 2011 Directed Electronics. All rights reserved. 13
ملخص المحتوى في الصفحة رقم 17
Advanced Commands: (Level 2) Press and release the button 2 times. The and Aux LED’s illumi- nate indicating Level 2 Sensor Bypass Press and release Performing the Sensor Bypass command will incrementally bypass sen- sor operations and be confirmed as follows: Warn-away bypass: The Parking lights flash 2 times. The Arm LED, 1 beep and 1 fault tone play to confirm. Sensors will be activated for Full Trigger levels of impact only. Warn-away & Full trigger bypass: The Parking lights flash 3 tim
ملخص المحتوى في الصفحة رقم 18
Timer Start* Press and release Activates (or if On, deactivates) Timer Start. The parking lights flash quickly four times for On and slowly four times for Off. The Remote Start LED and beeps play (1 for on, 2 for off) to confirm.. Note System needs to be armed or Timer Start will not start the engine. AUX 2 Press and release AUX Activates (or if On, deactivates) the Aux 2 output. The Aux LED and On tones or Off tones play to confirm. Arm Status Press and hold the button The remote will genera
ملخص المحتوى في الصفحة رقم 19
Advanced Commands: (Level 3) Press and release the button 3 times. The , Aux and Remote Start LED’s illuminate indicating Level 3 Sensor Silent Arm* Press and release The alarm arms, doors lock, and the siren chirps and parking lights flash 3 times. The Arm LED, 1 beep and 3 fault tones play to con- firm. Car finder Press and release The siren emits one long chirp and the parking lights flash for 10 sec- onds. The Disarm LED and 1 beep play to confirm. The parking light flashes stop if armed or
ملخص المحتوى في الصفحة رقم 20
AUX 3 Press and release AUX Activates (or if On, deactivates) the Aux 3 output. The Aux LED and On tones or Off tones play to confirm. Runtime Remaining Press and hold the button Requests the remaining Remote start runtime and temporarily displays it in 4 increments using the green Ghost LED’s. Example for 12 minute runtime: 3 LED’s: 6 to 9 minutes remaining (50 - 75% of time selected). 1 LED: less than 3 minutes remaining (<25% of time selected). Note Remote Start must be On to use this f
