Audiovox APS25CH دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Model APS-25CH
Installation Manual
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch
in order to begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps Default
1st Door L/UL 1 Sec. 3.5 Sec. 1 Sec L, Dbl. U/L 1 Sec.
2nd Accy Lock Auto Lock On Auto Lock Off Auto Lock Off
3rd Accy. UL Auto UL On Auto UL Off Auto UL Off
4th Passive Locks Passive Active Active
5th P

ملخص المحتوى في الصفحة رقم 2

CHANNEL 2 OUTPUT: This system provides an additional hardwire remote output to control an assortment of optional upgrades. This output is an independent channel from the transmitter and is controlled by button #2 or the combination of button 1 & 2 dependent on the programming of the transmitter as set up by your installation center. It is a delayed ground pulse (300 mA maximum) and can be used to control:  Optional trunk release relay AS-9256  Optional remote starter AS-9075 INSTALLATION OF MA

ملخص المحتوى في الصفحة رقم 3

VALET SWITCH: Select a desired mounting location for the switch, that is easily accessible to the driver of the vehicle. The switch does not have to be concealed, however, concealing the switch is always recommended, as this provides an even higher level of security to the vehicle. The switch may be mounted in or below the dash by drilling a 1/4" diameter hole in the location. Be sure to check behind the dash for adequate clearance for the body of the switch, and to confirm that the drill will

ملخص المحتوى في الصفحة رقم 4

DARK GREEN WIRE: (-) INSTANT TRIGGER This is an instant on ground trigger wire. It must be connected to the previously installed hood and trunk pin switches. BROWN WIRE: - DOOR TRIGGER If the vehicle’s door courtesy light switches have a - ground output when the door is opened ( GM and most Imports ) you must connect this wire to the negative output from one of the door switches. In most cases, the brown wire will only need to be connected to one door switch, no matter how many doors the vehicle

ملخص المحتوى في الصفحة رقم 5

3 Wire Positive Switched Door Locks In this application, the red wire provides a positive pulse during disarming (pulsed + 12 volt unlock) output. Connect the red wire to the wire that provides a low current positive signal from the factory door unlock switch to the factory door lock control relay. The green wire provides a positive pulse during arming (pulsed + 12 volt lock) output. Connect the green wire to the wire that provides a low current positive signal from the factory door lock switch

ملخص المحتوى في الصفحة رقم 6

THIS PAGE LEFT BLANK INTENTIONALLY 128-6453 6 of 8

ملخص المحتوى في الصفحة رقم 7

128-6453 7 of 8

ملخص المحتوى في الصفحة رقم 8

© 2003 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6453 128-6453 8 of 8